重庆天然气净化总厂污染减排管理及措施建议

文章就重庆天然气净化总厂近年来围绕可持续发展战略,针对净化总厂主要污染物废水、废气、固体废物,在工程技术改造、提高管理等方面所采取的污染减排措施和取得的成效进行归纳总结;并对净化总厂进一步的污染减排工作进行分析,提出切实可行的污染减排对策建议。     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

红壤坡地水土保持植物措施下柑橘林地水文生态效应

根据江西水土保持生态科技园2001～2008年不同处理措施柑橘林地径流小区的降雨产流产沙的定位观测资料及2010年土壤含水量测试数据,分析了坡面尺度水土保持植物措施下柑橘林地的产流产沙及土壤水分的特征,研究了狗牙根带状覆盖、狗牙根全园覆盖、果园清耕3种措施下的蓄水保土效应。结果表明：有草被覆盖的柑橘林小区的产流产沙量明显小于柑橘清耕小区,狗牙根带状覆盖小区减流减沙效果最好,减流率为98.21%,减沙率为99.84%。在大部分土层深度,草被带状覆盖下的土壤水分含量最高,均大于清耕措施,而全园覆盖由于植物蒸腾耗水量大水分含量反而低于带状覆盖。条带植草是防治柑橘林地水土流失的有效措施,具有明显的减流减沙效应和蓄积水分作用     

水性膨胀型防火涂料的现状和应用

钢结构是现代建筑工程中较普遍的结构形式之一,具备重量轻、机械性能好、可承受较大的荷载及制作和安装机械化程度高的特点。随着城市规模的发展,钢结构在我国建筑业具有非常广阔的应用前景。但由于其自身抗火能力差,在火灾高温作用下,其力学性能如屈服强度、弹性模量等会随温度升高而降低,一般在15min左右即丧失承重能力而垮塌,需采取保护措施使其温度不超过临界点才能在火灾中保持稳定性。涂敷钢结构防火涂料,施工简单、重量轻、耐火时间长且不受钢结构几何形状的制约,具有良好的经济性和实用性。随着环保意识的增强,国内外越来越多的建筑提倡绿色环保理念,参与三星或LEED认证体系的评级认证。水性膨胀型防火涂料凭借其优异的环保、施工安全和防火性能,开始逐渐受到众多业主和设计师的青睐。本文从防火原理、技术特点、防火领域的国内外认证、施工和质量管理的角度,浅谈水性膨胀型防火涂料的性能和发展现状,同时也讨论了目前防火涂料存在的一些问题。     

火灾下约束钢柱临界温度的简化计算方法

在火灾条件下,约束钢柱轴力由于升温而增加,会导致在较低的温度下发生屈曲;但屈曲后,钢柱的轴向温度膨胀得到释放,轴力下降,因此屈曲后钢柱仍能继续承栽。本文通过计算长度系数将转动约束钢柱转换为铰支钢柱,给出了一种轴向约束钢柱在火灾升温条件下的临界温度的简化计算方法——轴力放大系数设计方法。此法通过轴力放大系数将轴向约束钢柱转化为无约束钢柱,再按无约束钢柱计算得到钢柱的临界温度。用验证过的有限元模型对简化计算方法进行了验证,计算结果表明简化方法吻合较好。     

约束高强度Q460钢柱抗火性能分析

为了研究高强度约束钢柱在火灾下的反应,根据高强度结构钢Q460在高温下的力学性能参数,建立了约束高强度钢柱受火分析模型,得到了高强度约束钢柱在火灾下的轴向位移、跨中挠度、最大应力以及临界温度。采用有限元分析对理论结果进行了验证,两者吻合很好。利用验证过的该文计算方法计算了2种荷栽比、长细比和约束刚度比条件下的高强钢柱的抗火性能;采用CECS200:2006的力学性能参数计算了约束普通钢柱的抗火性能。通过对高强钢和普通钢的抗火性能分析发现,轴向约束明显降低钢柱的临界温度,长细比、荷载比越大,临界温度越低;高强钢的抗火性能要优于普通钢。     

吉林省“十二五”环保政策措施研究

十二五期间,吉林省将处在经济高速发展时期,完善环境保护政策措施,是有效实施十二五环保规划的关键。通过全省环境保护政策措施的回顾,科学预测新时期环境保护工作形势,研究全省十二五时期环境保护法规体系、协调机制、经济政策、环保投入、科技创新等方面的对策措施。     

Molecular characterization of conjugative plasmids in pesticide tolerant and multi-resistant bacterial isolates from contaminated alluvial soil

A total of 35 bacteria from contaminated soil (cultivated fields) near pesticide industry from Chinhat, Lucknow, (India) were isolated and tested for their tolerance/resistance to pesticides, heavy metals and antibiotics. Bacterial isolates were identified by 16S rDNA sequencing. Gas Chromatography analysis of the soil samples revealed the presence of lindane at a concentration of 547 ng g⁻¹ and α-endosulfan and β-endosulfan of 422 ng g⁻¹ and 421 ng g⁻¹ respectively. Atomic Absorption Spectrophotometry analysis of the test sample was done and Cr, Zn, Ni, Fe, Cu and Cd were detected at concentrations of 36.2, 42.5, 43.2, 241, 13.3 and 11.20 mg kg⁻¹ respectively. Minimum inhibitory concentrations of all the isolates were determined for pesticides and heavy metals. All the multi-resistant/tolerant bacterial isolates were also tested for the presence of incompatibility (Inc) group IncP, IncN, IncW, IncQ plasmids and for rolling circle plasmids of the pMV158-family by PCR. Total community DNA was extracted from pesticide contaminated soil. PCR amplification of the bacterial isolates and soil DNA revealed the presence of IncP-specific sequences (trfA2 and oriT) which was confirmed by dot blot hybridization with RP4-derived DIG-labelled probes. Plasmids belonging to IncN, IncW and IncQ group were neither detected in the bacterial isolates nor in total soil DNA. The presence of conjugative or mobilizable IncP plasmids in the isolates indicate that these bacteria have gene transfer capacity with implications for dissemination of heavy metal and antibiotic resistance genes. We propose that IncP plasmids are mainly responsible for the spread of multi-resistant bacteria in the contaminated soils.     

Integrated analysis of the effects of agricultural management on nitrogen fluxes at landscape scale

The integrated modelling system INITIATOR was applied to a landscape in the northern part of the Netherlands to assess current nitrogen fluxes to air and water and the impact of various agricultural measures on these fluxes, using spatially explicit input data on animal numbers, land use, agricultural management, meteorology and soil. Average model results on NH₃ deposition and N concentrations in surface water appear to be comparable to observations, but the deviation can be large at local scale, despite the use of high resolution data. Evaluated measures include: air scrubbers reducing NH₃ emissions from poultry and pig housing systems, low protein feeding, reduced fertilizer amounts and low-emission stables for cattle. Low protein feeding and restrictive fertilizer application had the largest effect on both N inputs and N losses, resulting in N deposition reductions on Natura 2000 sites of 10% and 12%, respectively.     

影响分析空白值的因素及控制措施

化学实验中,经常会出现空白值异常的情况。文中从可能对空白值产生影响的各个因素逐一进行分析,并在此基础上提出了控制空白值的手段和措施。