镍渣的重金属浸出特性

在分析镍渣的矿物相组成和重金属元素含量的基础上,鉴定了镍渣样品的浸出毒性,并考察了pH、液固比和浸出时间等条件对镍渣样中铬、铅、铜和锌等重金属浸出特性的影响。结果表明,镍渣中的重金属总量约为渣样的0.9%,且铬、铜和锌的含量较高,需进行安全管理。实验所用镍渣样品为第Ⅰ类一般工业固体废物。在强酸条件下镍渣中重金属浸出浓度较大,pH3后浸出浓度显著降低;液固比40 L/kg时,镍渣中重金属不断溶出,液固比40 L/kg后,浸出达到饱和,浸出浓度趋于平衡;随着浸出时间的增加,重金属离子的浸出浓度先增加后减少,但由于各重金属性质不同,各重金属达到最大浸出浓度的时间不同。     

污水处理厂剩余污泥对凤仙花和万寿菊生长的影响

采用盆栽方式,通过对花卉植物生长状况和各项生理指标的考察,研究了不同污泥施用比对凤仙花(Impatiens balsamina)和万寿菊(Tagetes erecta L.)生长的影响。结果表明,污泥施用比不高于5%(质量分数)时对两种花卉植物发芽有促进作用。在前期,对照组凤仙花和万寿菊生长较好,其株高、叶绿素和可溶性糖含量高于污泥施用组,丙二醛(MDA)含量低于污泥施用组。而在后期,污泥的施用对两种花卉生长促进作用明显,污泥施用组的两种花卉植物株高和各项生理指标优于对照组,尤其是开花状况显著好于对照组。凤仙花和万寿菊较优的污泥施用比分别为3%~5%和1%~5%。     

5种植物材料的水解释碳性能及反硝化效率

碳源在硝酸盐去除过程中起电子供体的作用,是生物反硝化反应的关键物质之一。为解决污水处理脱氮时碳源不足抑制反硝化反应造成脱氮效率低的问题,本研究选取风车草、甘蔗渣、芦竹、美人蕉和稻草秆5种植物材料作为反硝化碳源,探讨不同植物材料的水解释碳能力和释放规律;并进一步以其水解液作为外加碳源,探讨其对反硝化脱氮效率的影响。研究结果表明,植物材料水解释碳过程符合二级动力学反应规律,不同植物材料的释碳能力具有显著性差异,以甘蔗渣在固液比1∶80时COD释放当量最大,为45.45 mg/L;添加植物水解液可显著提高反硝化脱氮效率,以芦竹水解液脱氮效果最好,达到71.9%。此外,碳氮比是影响脱氮效率的重要因素之一,以碳氮比为9时反硝化脱氮效果最佳。     

钱塘江引水降氮示范工程的构建和运行研究

针对杭州西湖钱塘江引水低碳高氮的特点,提出以改性水草塘—复合垂直流人工湿地(IVCW)相耦合的生物—生态工艺进行引水处理,对该引水降氮示范工程的构建和运行效果进行了跟踪研究。结果表明,整个稳定运行期间(2012年7月19日至11月19日),耦合工艺对COD、TN、硝酸盐氮、TP的平均去除率分别为52.27%、52.49%、53.69%、52.79%,系统出水满足《地表水环境质量标准》(GB 3838—2002)Ⅳ标准;改性水草塘和IVCW单元作为耦合工艺的两个重要组成部分,在脱氮、除磷方面优势互补,从而共同保证出水水质的稳定;在改性水草塘单元,温度与COD的去除效果呈负相关关系,进水C/N与TN去除效果呈正相关关系;而在IVCW单元,温度与COD、TN的去除效果均呈线性正相关关系,进水C/N与两者的去除效果也呈正相关关系,且对COD的影响要大于对TN的影响。     

锰铜铈氧化物催化剂氧化NO性能及动力学研究

实验以TiO2为载体采用浸渍法制备CuOx/TiO2、CeOx/TiO2、CuCeOx/TiO2和MnCuCeOx/TiO2催化剂,考察这些催化剂氧化NO活性,探究Cu、Ce摩尔比和添加Mn元素对CuCeOx/TiO2催化剂氧化NO活性的影响,使用扫描电镜观察催化剂表面结构.研究发现,Cu、Ce元素配合后的CuCeOx/TiO2催化剂氧化活性明显好于单独含Cu、Ce的催化剂,当Cu、Ce摩尔比为Cu:Ce=1:2时,CuCeOx/TiO2催化剂氧化活性最好,在NO浓度500×10-6,O2 10%,空速为24 000 h-1,350℃时,NO氧化度为0.62;添加Mn元素可以提高CuCeOx/TiO2催化剂低温氧化活性, 250℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度为0.53和0.69,300℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度均为0.76;此外,实验还研究了NO在MnCuCe/Ti-3催化剂上反应的动力学方程.     

Forensic Evaluation of Metals (Cr,Cu, Pb,Zn), Isotopes (δ13C and δ15N), and C:N Ratios in Freshwater Sediment

A forensic approach was used to evaluate sediments from Portão Stream, including analysis of metals, carbon (C) and nitrogen (N) stable isotopes, and C:N ratios. Samples collected at various points located along the stream were tested in order to investigate a possible illegal leachate input. The studied stream is heavily impacted by sewage and industrial discharges from two cities along its course. Among the metals analyzed, chromium (Cr) was noticeably the main pollutant, showing the highest levels, above regulatory limits, downstream from some potential sources of effluents enriched with this metal. Isotope analyses revealed a general trend of depletion in the heavier isotope along the stream for C and N. The exception was one point near a hazardous waste landfill, where relatively more enriched δ¹³C and δ¹⁵N values were found. The isotope and metal analysis results indicated that this site was affected by a particular source, demonstrating the combination of these parameters could be used for the discrimination of sources in a heavily polluted stream. Nevertheless, further investigations are necessary to provide a comprehensive evaluation of the biogeochemical processes involved in the incorporation of leachate in sediments to use this analysis as evidence for the illegal leachate discharge.     

模拟降雨条件下沉积物对磷的富集机理

通过模拟降雨径流实验，在７２ｍｍ／ｈ的大暴雨备件下，研究侵蚀性颗粒从土壤中的径流流失过程及其对磷的富集作用和机理。结果表明，深积物中不同粒长团聚体的组成和原来土壤中的组成有很大差异。径流流失的沉积物主要以０．２５ｍｍ以下的团聚体为主，径流中８０％以上的磷以颗粒态形式流失，而颗粒态磷的６０％－９０％随０．１ｍｍ以下的团聚体流失。不同粒径团聚体对磷的富集作用和富集系数不同。模拟实验建立了沉积物富集系数     

成矿作用中金银的共生与分离及Au/Ag比值的校正

在内生作用中金与银既有共生的一面 ,又有分离的一面。其共生与分离受地球演化历史制约 ,受控于元素化学性质和地球化学亲和性 ,与岩浆起源、演化有关 ,受控于不同的基底建造和构造单元。成矿作用中金与银的共生与分离可用Au/Ag比值大小来衡量 ,本文提出了根据Au、Ag的地壳克拉克值和工业品位对传统的Au/Ag比值进行校正的方法 ,校正后的Au/Ag比值可有助于矿床研究、找矿预测和资源评价等工作     

Assessment of <Emphasis Type="Italic">Gmelina arborea</Emphasis> sawdust–cement-bonded rainwater storage tank

The performance of a mixture of a forest bye product and cement for the production of storage structure for harvested rainwater was assessed. Three mix ratios of Cement: Gmelina arborea sawdust 3.0:1.0 (specimen A), 2.5:1.0 (specimen B) and 2.0:1.0 (specimen C) were considered. Engineering properties and dimensional stability of the different mix-ratios were monitored from prototypes cylindrical pots and test billet specimens. Possible change in quality of stored rainwater, with time was monitored in all the three cases. Water quality parameters monitored include pH, hardness, total suspended solids, alkalinity, acidity and total dissolved CO₂. The tensile stress obtained were 110, 104, and 95 N/mm², while the compressive strength were 5,000, 3,000, and 2,000 kN for specimens A, B and C respectively. Accelerated aging test showed that sample A were more resistant to deformation, while specimen C were more susceptible to change in structure over time. Similarly, the values of tensile and compressive strength after accelerated aging test increased in the order of specimen A > B > C. Except in specimen C where significant differences in alkalinity and acidity were observed, there were no significant differences in quality of the water stored in the pots after 2 months of storage. The results indicate the suitability of the Gmelina arborea waste as an alternative in constructing water storage structures in rural communities.     

The structure of the fire fighting foam surfactant Forafac®1157 and its biological and photolytic transformation products

For several decades, perfluorooctane sulfonate (PFOS) has widely been used as a fluorinated surfactant in aqueous film forming foams used as hydrocarbon fuel fire extinguishers. Due to concerns regarding its environmental persistence and toxicological effects, PFOS has recently been replaced by novel fluorinated surfactants such as Forafac®1157, developed by the DuPont company. The major component of Forafac®1157 is a 6:2 fluorotelomer sulfonamide alkylbetaine (6:2 FTAB), and a link between the trade name and the exact chemical structure is presented here to the scientific community for the first time. In the present work, the structure of the 6:2 FTAB was elucidated by ¹H, ¹³C and ¹⁹F nuclear magnetic resonance spectroscopy and high-resolution mass spectrometry. Moreover, its major metabolites from blue mussel (Mytilus edulis) and turbot (Scophthalmus maximus) and its photolytic transformation products were identified. Contrary to what has earlier been observed for PFOS, the 6:2 FTAB was extensively metabolized by blue mussel and turbot exposed to Forafac®1157. The major metabolite was a deacetylated betaine species, from which mono- and di-demethylated metabolites also were formed. Another abundant metabolite was the 6:2 fluorotelomer sulfonamide. In another experiment, Forafac®1157 was subjected to UV-light induced photolysis. The experimental conditions aimed to simulate Arctic conditions and the deacetylated species was again the primary transformation product of 6:2 FTAB. A 6:2 fluorotelomer sulfonamide was also formed along with a non-identified transformation product. The environmental presence of most of the metabolites and transformation products was qualitatively demonstrated by analysis of soil samples taken in close proximity to an airport fire training facility.