我国电子废弃物的管理及发展道路研究

我国电子废弃物的处理处置正向产业化方向稳步推进。本文概括了电子废弃物的特点,以及我国目前处理电子废弃物的现状。遵照循环经济理念,并基于我国国情,提出了我国在电子废弃物处理处置过程中应遵循的主要原则和今后的发展方向。     

Decommissioning of offshore oil and gas facilities: a comparative assessment of different scenarios

A material and energy flow analysis, with corresponding financial flows, was carried out for different decommissioning scenarios for the different elements of an offshore oil and gas structure. A comparative assessment was made of the non-financial (especially environmental) outcomes of the different scenarios, with the reference scenario being to leave all structures in situ, while other scenarios envisaged leaving them on the seabed or removing them to shore for recycling and disposal. The costs of each scenario, when compared with the reference scenario, give an implicit valuation of the non-financial outcomes (e.g. environmental improvements), should that scenario be adopted by society. The paper concludes that it is not clear that the removal of the topsides and jackets of large steel structures to shore, as currently required by regulations, is environmentally justified; that concrete structures should certainly be left in place; and that leaving footings, cuttings and pipelines in place, with subsequent monitoring, would also be justified unless very large values were placed by society on a clear seabed and trawling access.     

Determination of Frequency for Remeasuring Ground and Vegetation Cover Factor Needed for Soil Erosion Modeling

Determining a remeasurement frequency of variables over time is required in monitoring environmental systems. This article demonstrates methods based on regression modeling and spatio-temporal variability to determine the time interval to remeasure the ground and vegetation cover factor on permanent plots for monitoring a soil erosion system. The spatio-temporal variability methods include use of historical data to predict semivariograms, modeling average temporal variability, and temporal interpolation by two-step kriging. The results show that for the cover factor, the relative errors of the prediction increase with an increased length of time interval between remeasurements when using the regression and semivariogram models. Given precision or accuracy requirements, appropriate time intervals can be determined. However, the remeasurement frequency also varies depending on the prediction interval time. As an alternative method, the range parameter of a semivariogram model can be used to quantify average temporal variability that approximates the maximum time interval between remeasurements. This method is simpler than regression and semivariogram modeling, but it requires a long-term dataset based on permanent plots. In addition, the temporal interpolation by two-step kriging is also used to determine the time interval. This method is applicable when remeasurements in time are not sufficient. If spatial and temporal remeasurements are sufficient, it can be expanded and applied to design spatial and temporal sampling simultaneously.     

半导体企业的EHSMS评价体系研究

为了给员工提供安全、环保、健康的工作环境,半导体制造企业必须建立环境管理和职业健康安全管理体系(EHSMS).为此,评价EHSMS运行的有效性、完整性以及合法性就显得十分重要.本文在分析半导体企业污染物影响环境和健康基础上,建立了EHSMS评估体系.为了实施EHSM评估系统,方便半导体企业用户使用,提出了一套EHSM评价系统的计算机软件解决方案.     

高职院校试行"综合导师制"的教育教学实践研究

结合学院迎接人才培养工作水平评估和学院“迎评促建”工作的要求,凸现高职教育“以就业为导向”的办学要求,在环境工程系推行了“综合导师制”。意在充分发挥专业老师在教书育人、专业辅导、大学生人生规划和就业素质提高上的优势,积极构建环境工程系全员育人、全程育人、全方位育人的工作格局,建立一种师生互动的新型教育教学关系。     

ASBR反应器处理豆制品废水的试验

采用厌氧序批式活性污泥法处理食品加工废水。试验研究了反应器的最佳进水、反应时间比,从而得出最低进水pH值和最少加碱量,同时还研究了反应器在常温和低温下的处理能力,以及pH冲击、搅拌频率、消毒液对反应器的影响。结果表明:最佳进水、反应时间比为2.5h4.5h,此时进水pH值降低到5.0,加碱量大大减少;CODCr去除率随温度的降低而降低,25℃时,CODCr去除率为83.45%,20℃时,CODCr去除率降至73%左右,15℃时,CODCr去除率只有57%左右;本工艺条件下最佳搅拌频率为每小时搅拌10min,反应器对pH冲击具有一定耐受能力,但消毒液对处理效果影响较大且恢复困难。     

生物浮选法处理含油污泥

利用从石油污染物中分离的一组微生物菌株对胜利油田含油污泥进行了生物浮选处理,探讨了处理过程中温度、稀释率、投加菌量及加糖量等因子对油去除率的影响及组合菌株与单一菌株处理效果的差异。通过实验获得生物浮选最佳运行参数为:温度40℃,稀释率98%,加菌量3.75%,加糖量0.25%,在该参数运行条件下,原油去除率可达95%以上。使用混合菌株进行生物浮选有利于回收原油中含油量的提高。     

多管文丘里烟气除尘脱硫装置

根据引射扩散原理,对文丘里洗涤器进行了理论分析和设计计算,在此基础上研究开发了新型多管文丘里烟气脱硫除尘装置,并用于燃煤锅炉烟气的净化。实际运行表明,该装置的脱硫效率达到90%以上。     

催化超临界水氧化处理1,5-萘二磺酸

采用Mn2O3/γ-AL2O3和V2O5/γ-Al2O/为催化剂,在一连续流固定床反应器中进行了超临界水氧化1,5-萘二磺酸实验.实验结果表明,在380～440℃,24 MPa条件下,Mn2O3/γ-Al2O3和V2O5/y-Al2O3催化剂对1,5-萘二磺酸的氧化降解具有显著的促进作用,TOC去除率达到90%以上;催化剂的催化效果随反应温度的升高而增强,随pH值的降低而增强,随停留时间的延长先增强后趋于平缓.     

改良倒置A2/O工艺设计

在目前广泛采用的AO、A2O、倒置A2O等工艺的基础上,为提高脱氮除磷效率,提出改良倒置A2O工艺。并对其工艺的特点、设计和脱氮除磷效率进行了详细的研究和分析。