岩溶地下河系统中有机氯的分布特征与来源分析

选取重庆老龙洞、青木关岩溶地下河为研究对象,采用气相色谱仪-微池电子捕获检测器(GC-μECD)分析两条地下河水体中21种有机氯农药(OCPs)的浓度.结果表明,南山地下河中六六六(HCHs)和艾氏剂类化合物(ALDs)是主要检出物,青木关地下河中HCHs和甲氧滴滴涕是主要检出物.南山、青木关地下河中均未检出o,p'-DDE、p,p'-DDE、o,p'-DDD,同时,青木关地下河还未检出o,p'-DDT、狄氏剂,其余OCPs在两条地下河中检出率高达100%.青木关地下河中OCPs浓度范围为145~278 ng·L-1之间,平均值为213 ng·L-1;南山老龙洞地下河中OCPs浓度介于17.7~40.8 ng·L-1之间,平均值为32.7ng·L-1.两条地下河中各OCPs组分表现为地下河出口大于入口.通过对OCPs污染来源分析,发现两地下河流域滴滴涕(DDTs)主要来自于历史上工业DDTs输入,氯丹主要来自于大气沉降.六六六(HCHs)主要来源是林丹的输入,南山地下河属于历史污染,青木关地下河上游的甘家槽有新的HCHs输入.与国内外其他各水体相比,南山地下河水体中HCHs、DDTs浓度处于低水平;青木关下河处于中等偏高水平.结合中外用水卫生标准,发现南山地下河和青木关地下河未超过饮水安全标准.青木关应禁止农田施用有机氯农药,保护地下河生态环境.     

2014年APEC期间北京市PM10和PM2.5氧化性损伤能力研究

为评估APEC会议期间联防联控措施对北京市大气可吸入颗粒物毒性的影响,采集2014年APEC会议前后3个月北京市大气PM₁₀和PM_2.5样品,应用质粒DNA损伤评价法来研究其氧化性损伤能力. 结果表明,APEC会议期间PM₁₀对DNA的损伤率高于PM_2.5,颗粒物对 DNA损伤率随剂量的增加而增加. 本研究用TD30值来指示颗粒物氧化性损伤能力,TD30为引起30%的DNA损伤率所需要的颗粒物剂量（单位为 μg·mL^-1）,TD30值越低,颗粒物氧化性损伤能力越强,APEC会议前后样品的TD30值表现为 APEC期间（11月）>APEC前（10月）>APEC后（12月）,说明氧化能力APEC后 >APEC前 >APEC期间. 用PM₁₀质量浓度乘上其在250 μg·mL^-1 剂量下的DNA损伤率得到颗粒物暴露毒性指数TI（toxic index）,与往年具有代表性月份样品的数据对比,TI大小顺序为2004年 >2014年 >2008年,说明大气中颗粒物暴露毒性随着政策控制力度的加大而降低.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

探讨适用于河流沉积物重金属污染程度的评价方法

本文使用地累积指数法和潜在生态危害指数法两种方法对同一区域五条河流的沉积物中重金属的测定结果进行了评价和比较,提出了将河流沉积物中重金属的监测纳入我国地表水常规监测的意见和建议.     

港口规划环评评价内容及技术方法探讨

随着经济的快速发展,港口已成为社会发展的重要支柱。但随之带来的是港口建设与环境保护之间的矛盾日益突出,因此必须实施港口规划环境影响评价。本文基于《规划环境影响评价技术导则》(试行),结合港口规划环评的特点,对港口规划环评的技术路线和评价内容进行了总结。评价重点内容从规划协调性分析、环境承载力、公众参与和风险评价四个方面进行了研究和总结,为其它港口总体规划环境影响评价工作提供参考和借鉴。     

农村沼气在北方农业源减排中的应用浅析

农村沼气作为一种特殊的清洁能源,在沈阳市农村节能减排、应对气候变化和发展低碳经济、促进新农村建设方面发挥了巨大的作用。本文通过对沼气工程在北方地区应用的阐述,力图推动北方农村沼气在农业源减排工作中的应用。     

Improvement of welding heat source models for TIG-MIG hybrid welding process

Tungsten inert gas-metal inert gas (TIG-MIG) hybrid welding process is an effective way to improve welding productivity and quality due to advantages of the two processes. Mathematical analysis is crucial to fundamentally understand this synergetic welding process. In this study, based on experimental visualization of arc behaviors, some assumptions are proposed to deduce adaptive plane and volumetric heat source models separately for each involved welding method first. The influence of torch angles on distribution of temperature and geometry of weld bead are calculated and compared with experimental results. It shows that this developed algorithm of heat source can be employed to accurately predict welding process whether the electrode gun is slanted backward or forward to the direction of welding. Then TIG-MIG hybrid welding process is simulated and analyzed without considering the attractive or repulsive force of two arcs. The characteristic of TIG-MIG welding process is discussed compared to single MIG. It lays the foundation for the further research on the interaction of the two arcs during TIG-MIG hybrid welding.     

企业环境风险评估概述

绘制了企业环境风险评估程序图,根据程序图,企业环境风险评估包括分析计算化学物质数量与其临界量的比值(Q)、评估工艺过程与环境风险控制水平(M)以及环境风险受体敏感性(E)和风险等级划分4个步骤。     

HAZOP与LOPA结合的运用实践

通过将HAZOP与LOPA结合分析的具体事例,阐述了单一的HAZOP分析可能存在的缺陷,同时介绍了将HAZOP与LOPA结合进行HAZOPLOPA分析的优点。