产漆酶血红密孔菌对城市污泥堆肥过程中有机氯农药的降解效应

为降低城市污泥堆肥中有机氯农药对环境的影响,实验室通过外加热源提供堆肥环境温度条件,并在不同堆料中接种不同剂量的产漆酶血红密孔菌,研究不同处理下产漆酶血红密孔菌对污泥中HCH、DDT和HCB的降解性能的影响。结果表明,供试血红密孔菌对3种有机氯农药的降解有明显的促进作用。未接种菌剂情况下,高温堆肥本身对HCH、DDT和HCB的降解率分别为51.1%、43.6%和63.4%;接种1%菌剂时,HCH、DDT和HCB比未接种堆料降解率分别提高了16.2%、34.6%和21.7%;接种3%菌剂时,HCH、DDT和HCB比未接种堆料降解率分别提高了41.1%、34.6%和20.1%。供试菌剂对DDT的降解效果最好,且DDT和HCH的降解能力与接种量大小呈正相关。此外,供试菌剂剂量大小对HCH不同异构体和DDT不同衍生物降解效果也不尽相同。     

反胶束漆酶/纤维素酶体系中油酸酯化的优化

漆酶和纤维素酶在反胶束水核中心具有较强的催化活性。为了对反胶束酶体系中油酸酯化反应深入研究,采用生物表面活性剂鼠李糖脂构建反胶束体系作为漆酶与纤维素酶酯化油酸的催化反应场所。通过实验研究了反胶束体系的不同条件对酯化产物含量的影响。对于反胶束漆酶体系,最佳酯化条件为：含水量W0 40%,鼠李糖脂临界胶束浓度20 mmol·L-1,pH值4,温度40 ℃;对于反胶束纤维素酶体系,最佳酯化条件为：含水量20%,鼠李糖脂临界胶束浓度80 mmol·L-1,pH值4,温度30 ℃。综合考虑几个因素,漆酶比纤维素酶更适合应用于反胶束中油酸的酯化。研究同时采用荧光光谱法对漆酶和纤维素酶在反胶束体系中结构性能的变化进行研究,结果表明,当反胶束体系处于最佳酯化反应条件时,荧光强度最高。     

中低温厌氧处理城市污水污泥颗粒化的研究

用高径比为3：1的UASB反应器分别在35℃和室温条件下处理模拟城市污水,研究了污泥的颗粒化过程.比较了在不同温度、浓度下形成的颗粒污泥的特征.水温为9～25℃,进水浓度为100～200 mg COD/L,水力上流速度（Vup）在0.013～0.11 m/h的4^#UASB反应器在60 d内在形成了成熟的颗粒污泥.研究表明,进水中低的有机物浓度,低的Ca^2＋、Mg^2＋浓度和低的Vup没有抑制颗粒化进程.     

分子生物技术在环境工程微生物领域中的应用

目前分子生物技术发展日新月异,已渗透到各相关学科。本文综述了分子生物技术的基本原理与方法,及其在环境工程微生物领域的应用。讨论了分子生物技术在环境工程微生物的检测应用及在污泥、生物膜、底泥和土壤等微生物种群的多样性分析方面,以及环境工程菌的挑选和培养等方面的研究成果及其巨大研究前景,对该技术在环境工程领域的应用与发展提出了一些见解。     

生态滤池处理城市污水小试研究

生态滤池(MEEF)是利用由微生物和蚯蚓为代表的微型动物共同组成的人工生态系统,对城镇污水中的污染物进行降解处理的新型污水处理技术。采用单层滤池和复合床滤池进行实验,在相同的实验条件下,对生态滤池和无蚯蚓滤池的运行效果进行了比较。运行初期,生态滤池的出水水质稍优于无蚯蚓滤池,特别是悬浮物浓度低;运行半月后,无蚯蚓滤池表面积泥,出现厌氧情况,出水水质变差,而生态滤池至少正常运行1个月。复合床生态滤池连续进水运行,水力负荷达到2.0m3/m2·d,COD去除率达80%以上,出水SS浓度<5mg/L。结果表明,蚯蚓在维持滤池的正常运行起着重要作用。最后介绍了生态滤池中各种生物的作用及生态滤池的工作原理。     

气-水联合反冲洗膜污染防治技术研究

采用气水联合反冲洗技术,考察了气水比(Qg/Ql)、反冲洗周期及其对膜污染的防治效果。结果表明,气水联合反冲洗较单独气或水反冲洗效果好;在过滤周期20min,反冲洗时间1min,气水比1.5时,气水联合反冲洗能够恢复膜通量到膜清水通量的80%以上。此法可大幅度清除沉积在膜表面的泥饼层,恢复膜通量,维持膜过滤性能的稳定,是一种较为有效的膜污染防治技术。     

城市污水污泥固结体重金属浸出毒性及路用性能研究

城市污水污泥的重金属离子Pb、Zn超过国家固体废弃物排放最高允许值,属于危险废物。污水污泥的最佳出路是无害化处理,资源化利用,产业化发展。研究了以上海市污水污泥为原料,加入一定比例的固化剂和矿物掺合料使之固结,经养护满足路用强度性能,测试其固结体重金属离子浸出质量浓度亦满足国家固体废弃物排放标准,即污泥中的重金属离子得到有效的束缚和稳定固化,既解决了环境问题,又为污泥产业化发展开辟了新的途径。     

Surface Consolidation of Pentelic Marble: Criteria for the selection of methods and materials - The Acropolis case (6 pp)

Goal and Scope In order to realize surface consolidation of Pentelic marble on the Acropolis monuments, we have collected the criteria that have to be fulfilled by the methods and materials without side effects on the marbles (and other stones). When the existing methods and materials did not satisfy the requirements (criteria), we invented new ones.Methods The criteria were collected from the literature, by thermodynamic and kinetic viewpoints, by laboratory experiments and in situ observations on monuments, both in Greece and in several countries in which the various methods and materials were applied. Concerning our method of ‘Inversion of sulfation’, performed by spraying a K2CO3 solution, its concentration and its temperature were controlled in order to have a total inversion (certified by liquid crystals) of gypsum back to CaCO3. For the new material of ours, ‘Reinforced Lime’, in order to eliminate the disadvantages of plain lime (low carbonation rate, low mechanical properties of CaCO3 formed, lack of carbonation in the bulk of lime), measurements of the rate of carbonation were performed in plain lime and in lime with a different CaCO3 concentration beforehand as well as in a different CO2 environments, using DTG and XRD to measure the rate of carbonation. The detachment (kg/cm2) of marble specimens stuck by lime in each case was also measured. A microscope was also used to measure the dimensions of the grain in each case as well as ammonium citrate and thymolphthalein to certify the depth of carbonation in each case. Part of the work was communicated in an international congress.Results A table with the criteria of the selection of the methods and materials for the consolidation of Pentelic marble surfaces (and other stones) was established. None of the employed methods and materials fulfilled the criteria. Only the ‘Inversion of gypsum ‘ and the ‘Reinforced Lime’ were adopted and applied to the Acropolis monuments and to other monuments in Greece and in several other countries.Recommendation and Outlook All criteria must be used for the selection of methods and materials for the consolidation of the monument surfaces. This is why we have already studied with the same procedures, methods and materials for restoration, surface cleaning and protection.     

焦炉装煤烟尘治理方案的探讨

焦炉装煤烟尘含有害物质，污染环境，危害人体健康。袋式除尘器的使用，消除了烟尘的污染，但因投资大、运行费用高、操作复杂，难以得到快速、广泛的推广。根据实验结果和已有应用情况，本文推荐了三相流化床除尘装置和颗粒层除尘器，它们可用于焦炉装煤烟尘治理，其投资和运行费用会大大降低。     

Oxidative treatment of simulated dyehouse effluent by uv and near-UV light assisted Fenton's reagent

UV/Fenton, near-UV-visible/Fenton, dark Fenton, and H₂O₂/UV reactions have been used to treat simulated dyehouse effluents representing wastewater from the textile dyeing and rinsing process. Experiments were carried out in a lab - scale photochemical reactor using concentrations of 0.5–25 mM H₂O₂, 0.04-0.5 mM Fe²⁺-ion and different dilutions of textile wastewater. To assess the extent of mineralization, decolourization kinetics and the effect of different fight sources on treatment efficiency, DOC, optical density at 254 nm and 600 nm wavelength and residual H₂O₂ concentrations were measured during the course of the advanced oxidation reactions. Comparative evaluation of the obtained results revealed that the decolourization rate increased with applied H₂O₂ and Fe²⁺-ion dose as well as the strength of the synthetic textile wastewater. The best results were obtained by the near - UV/visible/Fenton process with a decolourization rate constant of 1.57 min⁻¹, a UV_254nm reduction of 97% and a DOC removal of 41% at relatively low doses of the H₂O₂ oxidant and Fe²⁺-ion catalyst within 60 min treatment time.