珠江三角洲经济区污水系统设计原则

分析了珠江三角洲经济区水环境现状；阐述了城市污水分散处理与集中处理的利弊；指出污水深度处理与回用是形成良性水循环的有效途径，更是经济可持续发展的必然要求；通过对已建排水系统存在问题的分析，探讨了珠江三角洲经济开发区污水系统的设计原则，认为污水系统规划要改变传统设计方法，应方便再生水回用，由经济、技术、地理等综合因素确定排水分区、污水厂厂址与数量，选择适合各排水区域水质水量的工艺流程，预留污水厂与再生水回用管线分期发展的空间，应优先选用国产污水处理设备，尽可能维持城市河涌自然生态。     

长庆油田水处理新技术研究

长庆油房庄油田水经过处理后仍具有较高的矿化度、较多的悬浮物及残留油,同时其SRB严重超标。现场处理水质不稳定,在进行回注时与地层的配伍性较差。针对这些情况,研究了一种新型的水处理工艺技术。对成垢离子调整剂、水质净化剂和成垢离子钝化剂进行了筛选,并对含油污水的成垢离子含量及比例进行了调整。运用这种技术,使油房庄油田水经处理后达到回注水的标准,且提高了与地层的配伍性。同时提出了新型水处理技术的工艺流程。     

稠油污水处理系统改造与絮凝剂筛选试验研究

河南油田井楼稠油联合站含油污水中的污油和悬浮物含量较高,超过150mg/L。为此,对该处理系统进行了改造,并对絮凝剂的筛选进行了试验。结果表明:无机絮凝剂与有机絮凝剂联合作用,可对污水中所含有的污油和有机物杂质的悬浮物产生很好的絮凝沉降效果。加药浓度、加药顺序及沉降时间均对絮凝沉降效果有一定的影响。改造后的污水处理系统实现了污水达标回注,降低了无效回注费用。同时还回收了污油,降低了药剂成本,产生了十分明显的经济效益,每年节约成本约500万元。     

新型纤维滤料的研究及应用

随着我国油田相继进入开发后期,传统的滤料及设备过滤精度已不能满足注水的要求。因此,研究并开发了具有一定抗油污能力的新型过滤材料,设计了新型的超精细过滤器系列产品。对滤料进行的室内实验结果表明,在开始过滤的近10h内,过滤后的水中含油量基本上满足注水的水质要求。在开始过滤的近20h内,滤层的水头损失随时间的变化较为平缓;随着过滤时间的延长,水头损失变化加剧。从现场实验可以看出,所设计的过滤器有良好的过滤性能和抗冲击能力。新型过滤材料的研究成功解决了油田含油污水精细过滤的问题,新型过滤器也是含油污水超精细过滤的理想产品。     

THE INFLUENCE OF CLIMATE VARIATION ON THE ESTIMATION OF LOW FLOWS USED TO PROTECT WATER QUALITY: A NATIONWIDE ASSESSMENT1

ABSTRACT: Historical flow records are used to estimate the regulatory low flows that serve a key function in setting discharge permit limits through the National Pollutant Discharge Elimination System, which provides a nationwide mechanism for protecting water quality. Use of historical records creates an implicit connection between water quality protection and climate variability. The longer the record, the more likely the low flow estimate will be based on a broad set of climate conditions, and thus provides adequate water quality protection in the future. Unfortunately, a long record often is not available at a specific location. This analysis examines the connection between climate variability and the variability of biologically based and hydrologically based low flow estimates at 176 sites from the Hydro‐Climatic Data Network, a collection of stream gages identified by the USGS as relatively free of anthropogenic influences. Results show that a record of 10 to 20 years is necessary for satisfactory estimates of regulatory low flows. Although it is possible to estimate a biologically based low flow from a record of less than 10 years, these estimates are highly uncertain and incorporate a bias that undermines water quality protection.     

ENHANCING FECAL COLIFORM TOTAL MAXIMUM DAILY LOAD MODELS THROUGH BACTERIAL SOURCE TRACKING1

ABSTRACT: Surface water impairment by fecal coliform bacteria is a water quality issue of national scope and importance. In Virginia, more than 400 stream and river segments are on the Commonwealth's 2002 303(d) list because of fecal coliform impairment. Total maximum daily loads (TMDLs) will be developed for most of these listed streams and rivers. Information regarding the major fecal coliform sources that impair surface water quality would enhance the development of effective watershed models and improve TMDLs. Bacterial source tracking (BST) is a recently developed technology for identifying the sources of fecal coliform bacteria and it may be helpful in generating improved TMDLs. Bacterial source tracking was performed, watershed models were developed, and TMDLs were prepared for three streams (Accotink Creek, Christians Creek, and Blacks Run) on Virginia's 303(d) list of impaired waters. Quality assurance of the BST work suggests that these data adequately describe the bacteria sources that are impairing these streams. Initial comparison of simulated bacterial sources with the observed BST data indicated that the fecal coliform sources were represented inaccurately in the initial model simulation. Revised model simulations (based on BST data) appeared to provide a better representation of the sources of fecal coliform bacteria in these three streams. The coupled approach of incorporating BST data into the fecal coliform transport model appears to reduce model uncertainty and should result in an improved TMDL.     

略阳电厂后部山体边坡的稳定性评价与初步治理设计

在对略阳电厂后部山体地质条件分析的基础上,采用定性分析与定量数值计算相结合的方法评价了电厂后部山体在开挖前后的稳定性问题,并对开挖后的坡体提出了相应的工程治理措施.     

给水管道振动信号的小波分析及消振研究

某核发电厂部分蒸汽和给水管道振动情况非常严重 ,以致影响到正常的安全生产。笔者从给水管道的测振出发 ,并利用 3层Daubechise对振动信号进行了小波消噪、滤波、重构处理 ,以找到影响管系振动的激励源的主要频域成分。进而利用比较成熟的结构分析软件ANSYS对管系进行了模态分析 ,得到系统的低阶固有频率和振型。根据管道振动的原因 ,在不改变管系主要特征的基础上 ,给出了简单易行的消振措施 ,实际运行情况表明消振方法效果良好。     

我国安全学科学历教育的困境与对策

我国安全形势严峻的重要原因是安全科技人才缺乏。安全学科学历教育作为我国安全科技高级人才培养的主要渠道之一,为国家造就和输送了大批安全科技人才。但是,由于安全学科学历教育体制没有很好适应市场经济的发展,遇到了不少难以解决的问题。依据对高校和煤炭企业调查所获得的资料,统计发现:目前我国安全学科学历教育所面临的主要问题是专业设置的局限性、培养目标的雷同性和课程设置的低通用性;社会对安全人才需求与目前高校安全专业招生和毕业生就业之间存在的突出矛盾。在详细调研和分析的基础上,提出了相应的安全人才后备队伍建设应采取的对策,即加大政府调控力度、实施“人才兴安”战略,深化教育教学改革、培养高素质安全人才。     

浅论建筑消防安全性能化评估技术

建筑消防安全性能化设计以其灵活性、科学性、经济性和有效性等优点受到了国际社会越来越多的重视,并在很多国家得到了应用。性能化评估作为性能化设计的核心环节,直接关系到性能化设计方案的成败。如何进行性能化评估,如何对性能化设计方案的评价和论证,如何设定相应的消防安全性能评估程序等等问题,都值得深入探讨。从建筑消防安全性能化设计的优点及其评估的重要性入手,从性能化评估的作用和必要性出发,深入分析了建筑消防安全性能化评估与性能化设计的关系;探讨了建筑消防安全性能化评估的步骤、流程、判定标准及其量化指标;并对国际上常用于性能化评估的3种典型的火灾风险评估模型进行了详细对比分析,并提出了进行性能化评估时需注意的一些关键问题。