EFFECT OF SOIL STERILIZATION BY MERCURIC CHLORIDE ON HERBICIDE SORPTION BY SOIL

Microbial inhibitors such as mercuric chloride are frequently used to sterilize soil or soil–water slurries in experimental studies on the fate of xenobiotics in the environment. This study examined the influence of mercuric chloride additions to soil–water slurries on the sorptive behaviour of a phenoxy herbicide (2,4-D) in soil. The results demonstrated that mercuric chloride strongly decreased the capacity of the soil to retain herbicides, and that the interference of mercuric chloride with herbicide sorption increased with increasing soil organic carbon contents. Because of the competitive sorption between mercuric chloride and the phenoxy herbicide, we conclude that mercuric chloride may not be a good soil sterilization procedure for use in xenobiotic fate studies.     

Bioaccessibility of polychlorinated biphenyls in workplace dust and its implication for risk assessment

Human exposure to bioaccessible PCBs via indoor dust is limited around the world. In the present study, the workplace dust sample from commercial office, hospital, secondary school, shopping mall, electronic factory and manufacturing plant were collected from Hong Kong for PCBs analyses. Total PCBs concentrations ranged from 46.8 to 249 ng g⁻¹, with a median of 107 ng g⁻¹. Manufacturing plant showed the highest concentration among all of sampling sites. PCB 77 was found as the dominant congeners. The bioaccessibility of PCBs in small intestinal juice ranging from 8.3% to 26.0% was significantly higher than that in gastric condition, ranging from 4.8% to 12.4%. In addition, significant negative correlations (p < 0.05) were observed between K_OW and bioaccessibility for all workplace dust samples. Risk assessment indicated that the averaged daily dose of dioxin-like PCBs via non-dietary intake of workplace dust, considering the bioaccessibility of PCBs, were much lower than the TDI of dioxins (2.3 pg WHO-TEQ kg bw⁻¹ d⁻¹) established by Joint FAO/WHO Expert Committee on Food Additives.     

Converging hazard assessment of gold nanoparticles to aquatic organisms

The gold nanoparticles (Au-NPs) are being increasingly used because of their huge diversity of applications, and consequently, elevated levels in the environment are expected. However, due to their physico-chemical properties and functionalization a high variety of Au-NPs can be found, and complete toxicological information for each type of Au-NPs still lacks, and even, the toxicological information for the same species is sometimes contradictory. Therefore, hazard assessment should be done case by case. Hence, the objective of this study was to obtain ecotoxicological information of the same Au-NPs in aquatic organisms and to find a rationale for Au-NPs toxicity. For such a purpose, bare and hyaluronic acid capped Au-NPs (12.5 nm) along with Au-NPs bulk material were tested on freshwater algae, Daphnia and zebrafish. Results showed that while gold nanoparticles were found to be harmless to the tested organisms, the soluble gold showed to be toxic to algae and Daphnia, with an LC₅₀ between 1 and 2 mg L⁻¹. Comparing our results with those gathered in the literature, it appears that a common hazard assessment of Au-NPs on the studied organisms can be elucidated.     

化学沉淀法强化常规工艺应急去除水中的镉

在常规工艺基础上,通过投加氢氧化钠,实验进行了应急去除重金属镉的研究。实验结果表明,该方法能有效去除饮用水水源的镉,效果稳定,可进行应急处理。对pH、镉初始浓度和混凝剂投加量3个影响因素的灰色关联分析表明,3个因素对镉去除效果影响的大小排序为:滤后水pH>混凝剂投加量>镉初始浓度。在水源镉突发污染时,在原有常规水处理工艺基础上,通过控制滤后水pH可实现对重金属镉的去除,pH的控制值与水源水质有关。     

利用钢铁盐酸酸洗废液在填料塔中制备FeCl3

以钢铁盐酸酸洗废液为原料,亚硝酸钠为催化剂,氧气为氧化剂,在填料塔中催化氧化制备三氯化铁。考察了反应温度、催化剂加入量和添加方式、循环流量等对制备三氯化铁的影响。实验结果表明,在优化的工艺条件为料液预热温度为60 ℃、催化剂加入量为钢铁盐酸酸洗废液总质量的0.30%、料液循环流量6.0 m³/h的条件下,反应80~120 min,酸洗废液中的Fe²⁺完全氧化为Fe³⁺。     

吐温80与氢氧化钠耦合强化剩余污泥溶胞效果的研究

利用吐温80的润湿、渗透作用,将其与氢氧化钠耦合应用于剩余污泥的溶胞。结果表明,吐温80的存在能有效提高氢氧化钠对剩余污泥的溶胞效果;而同样的溶胞效果下,吐温80的存在能降低溶胞的环境温度。吐温80与氢氧化钠耦合剩余污泥溶胞工艺的最佳工艺条件为：吐温80投加量100 mg/L、作用时间15 min,先加吐温80再加氢氧...     

聚合氯化铝污泥对磷的吸附动力学及热力学

聚合氯化铝污泥（polyaluminium chloride sludge,PACS）是指以聚合氯化铝（PAC）为混凝剂的城镇给水厂在生产过程中所产生的污泥。采用批量吸附实验考察了PACS对磷的吸附动力学及热力学行为。结果表明,吸附反应发生1 h后,PACS对磷的吸附量达到平衡吸附量的75%～90%,随后PACS对磷的...     

固定床中粒状脱硫剂除尘效率的研究

建立了非稳态过滤下的固定床颗粒层除尘效率模型.该模型尽可能地包含了影响固定床颗粒层除尘的参数,反映了沉积粉尘对除尘效率的影响;研究了以粒状脱硫剂为滤料的固定床在不同颗粒层厚度、空床气速、粒径下的除尘效率.结果表明,在颗粒层厚度为400～800 cm、空床气速≤0.4 m/s的条件下,颗粒层的除尘效率可达90％以上.     

防风抑尘网设计要点及参数的确定

介绍了堆场起尘、防风抑尘网抑尘的机理和国内外防风抑尘网研究结果,结合实际工程设计的经验,分析了防风抑尘网设计要点和主要参数,提出防风抑尘网设计的意见和建议。     

300MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。