Lean methane premixed combustion over a catalytically stabilized zirconia foam burner

This study experimentally investigates lean methane/air premixed combustion in a catalytic zirconia foam burner. The burner is packed with an inert perforated alumina plate at the inlet preheating zone and with catalytic zirconia foams at the combustion zone. Catalytic foams are prepared by using a modified perovskite catalyst (LaMn_0.4Co_0.6O₃), in which the transition metal ion Co is partially substituted by Mn and supported by inert zirconia foam. Results indicate that the flame stability limits of both catalytic and inert burners expand with increasing equivalence ratios. The stable combustion region of the catalytic burner is larger than that of the inert burner. The heterogeneous catalytic combustion effect can decrease and increase the lower and upper flame stability limits, respectively. The central temperatures of the flame fronts are higher in the catalytic burner than in the inert burner. The pressure drops of the catalytic burner are almost equal to those of the inert burner in cold flows but are significantly higher than those in the inert burner in reaction flows. Less amounts of carbon monoxide, nitric oxides, and unburned hydrocarbon emissions are detected in the catalytic burner relative to the inert burner. The thermal radiation efficiencies of the catalytic burner vary between 0.24 and 0.39 and are favorably superior to those of the inert burner, ranging from 0.11 to 0.20.     

厌氧氨氧化耦合异养反硝化的脱氮性能及污泥性状

通过连续实验和血清瓶批式实验研究了厌氧氨氧化耦合异养反硝化的代谢特性。在pH 7.8、温度25℃左右、水力停留时间1.5 h和苯酚浓度18.82 mg/L的条件下,耦合反应器能长期稳定运行。结果表明,NH+4-N、NO-2-N去除率高达100%,TN去除率为87.51%。消耗的NH+4-N、NO-2-N与生成的NO-3-N之比为1∶1.49∶0.12,平均总氮容积负荷为2.53 kg/(m3·d),平均总氮去除负荷可达2.26 kg/(m3·d)。系统内异养反硝化与厌氧氨氧化存在协同和竞争关系,总氮的去除是异养反硝化菌和厌氧氨氧化菌共同作用的结果。耦合系统中ANAMMOX对TN去除贡献率达到86.72%,异养反硝化对TN去除贡献率达到13.28%(其中以NO-2-N为电子受体的反硝化比例为7.16%,以NO-3-N为电子受体的反硝化比例为5.89%)。污泥性状研究表明,颗粒污泥存在3种形式:一种是ANAMMOX颗粒污泥;一种是苯酚反硝化颗粒污泥;一种是ANAMMOX菌外面包裹苯酚反硝化菌的颗粒污泥。另外,颗粒污泥的无机组分较高。污泥扫描电镜照片显示厌氧氨氧化菌为球状,反硝化菌为短杆状。     

Influence of surfactant concentration on foliar retention of pesticides used in forestry

Abstract

Aqueous tank mixes of permethrin, fenitrothion, Bacillus thuringiensis (B.t.), diflubenzuron (DFB), and glyphosate containing different amounts of Triton® X‐114, a nonionic surfactant, were prepared. Glyphosate formed clear solutions, permethrin and fenitrothion formed emulsions, DFB and B.t provided suspensions. Emulsion stability of permethrin and fenitrothion increased with increasing surfactant level, while the emulsion drop size decreased.

Foliage of white oak, trembling aspen, white spruce and balsam fir were dipped in tank mixes of pesticides (except B.t.) labelled with ¹⁴carbon. The amount of pesticide retained on foliage was determined by liquid scintillation counting. Foliage was also dipped in non‐radioactive B.t. tank mixes, and the protein retained was determined colorimetrically. With all tank mixes, a direct relationship was observed between the mass of liquids retained on foliage and liquid viscosity. In contrast, the amount of pesticide retained was unaffected by viscosity, but was influenced by emulsion drop size. Initially, the amount of pesticide retained on foliage increased with increasing surfactant concentration. Beyond an optimum surfactant level, the emulsion drop sizes were too small and the emulsions became too stable to allow maximum retention of pesticides on foliage. With the glyphosate solutions, however, no optimum surfactant level was indicated because foliar concentrations continued to increase with increasing surfactant levels.     

马三峰土质边坡稳定性分析与评价

基于马三峰边坡南段土质边坡的工程地质特征现场勘查,分别运用极限平衡法和快速拉格朗日法分析了马三峰土坡的稳定性,搜索出了潜在的滑动面并计算出相应的安全系数,结果认为土坡整体是不稳定的。通过2种计算结果的对比研究,对此土坡的破坏模式及其发展趋势做出评价,认为此土质边坡破坏的力学特征为牵引式滑坡,失稳不是一次性地全部滑塌,而是分阶段滑动,破坏模式为一系列动态的平面—圆弧滑面破坏。如不及时治理,该滑坡体将会继续向后缘发展。     

边坡稳定性评价的一种半定量方法

以南京市某边坡为例,介绍了一种边坡稳定性评价的半定量方法。首先,根据边坡所处地质环境对其稳定性趋势作出分析,确定该边坡的稳定性影响因素;进而,根据对该地区同类型滑坡的统计,分析了影响因素与滑坡发生的相关性;在通过对比求和评分法得出了各影响因素的稳定性权重值之后,又根据相关性分析得出的结果,完成了影响因素的分级赋值;最后,得出了边坡稳定性的评价模型,并求出了不同降雨量情况下边坡的稳定性指数。     

强度折减有限元法中边坡失稳的塑性区判据及其应用

将抗剪强度折减法基本概念、弹塑性有限元分析原理与计算结果图形实时显示技术相结合,提出了以广义塑性应变及塑性开展区作为边坡失稳的评判依据,并与以非线性迭代收敛条件作为失稳评判指标的强度折减有限元方法进行了对比。对于天然垂直边坡的算例数值分析表明,采用广义塑性应变与塑性开展区作为失稳判据可以比较准确地预测边坡潜在破坏面的形状与位置及相应的稳定安全系数,验证了这种失稳判据的合理性。对开挖边坡和开挖支护边坡的实例计算结果表明本文方法对于复杂的边坡稳定性分析是实用的。     

螯合铁脱硫吸收剂稳定性的研究

主要对整合铁吸收剂的稳定性进行了研究。通过不同配方的整合铁吸收剂的短期循环实验,了解体系脱硫率、铁浓度随循环次数的变化。其次,通过一系列连续性吸收极限实验,测定了不同配方吸收剂的极限吸收时间(即累积脱硫量),并考察了体系的吸收反应时间与脱硫率、pH值的变化关系。     

湘江微污染饮用水源水生物过滤去除特性研究

通过试验探讨了不同滤料介质组成的生物滤柱对湘江微污染水源的处理效果。结果表明,生物过滤具有良好的去浊性能,浊度的去除是传统吸附截留和生物吸附共同作用的结果;生物过滤可有效去除微污染水源中的有机物,NH+4-N,总铁和Mn2+,提高饮用水生物稳定性。颗粒活性炭-石英砂双层滤料组合要优于石英砂单层滤料和无烟煤-石英砂双层滤料,加氯水反冲洗不利于生物滤池的运行。      

实海环境下钢壳混凝土结构局部电位监测与参比电极稳定性研究

目的 确定高纯锌、钛以及铂等3种参比电极在不同工况下的稳定性差异,以及不同参比电极针对沉管的最佳使用位置。方法 以银/氯化银参比电极的监测电位数据为钢壳的实际电位基准,通过在不同区域设计安装电位传感器,持续监测沉管不同区域的钢壳电位,以及9个多月的波动情况。结果 高纯锌参比电极所监测数据的变化趋势与钢壳实际电位数据接近,且环境介质的改变对其监测电位数值的影响不大,电位数据波动小。铂和钛参比电极在钢壳底面海泥/抛石耦合的服役环境下,其监测电位数据稳定,但是二者在海水中监测电位时,对环境介质中的溶解氧浓度、金属离子等氧化性介质较为敏感,极易受到氧化性介质的影响,导致测得的电位偏移剧烈。结论 高纯锌参比电极更适合应用于沉管侧面阴极保护电位的长期监测,铂和钛参比电极更适用于钢壳底部保护电位的长期测量。     

北京山区生态系统稳定性评价模型初步研究

在建立北京山区生态评价体系的基础上,参考有关资料和北京的实际状况确定山区生态系统稳定性评价的标准和分级,选择适当的方法确定评价因子的层次关系和重要度,建立了综合评价模型。并以北京山区的一典型区为例对评价模型进行检验,结果与实际基本相符。