气相中芥子气模拟剂2-CEES在SO42-/TiO2上的光催化消除

与传统洗消法相比,光催化技术消除军用毒剂具有高效和无二次污染等优点,但TiO2 的活性较低且易于失活以致难于实际使用.采用稀硫酸对TiO2 进行表面修饰制备出了SO2 -4/TiO2 催化剂,在连续流动微分反应器上考察其对芥子气模拟剂2 chloroethylethylsulfide(2 CEES)的光催化降解活性和稳定性,并与TiO2 进行了比较.结果表明,硫酸化处理不但可提高TiO2 的活性也可提高其活性稳定性,其中以2 0 0℃焙烧所得样品ST2 0 0的性能最好.还研究了反应温度和水蒸气对ST2 0 0上2 CEES光催化降解的影响,发现在90℃反应,催化剂有较高的活性和稳定性;当给2 CEES初始浓度<6 1 μL·L-1 的体系中添加30 . 5mL·L-1 的水蒸气时,催化剂可维持长久的高活性.还发现将SO2 -4/TiO2 负载在γAl2 O3 、SiO2 和木质活性炭(AC)上可提高SO2 -4/TiO2 的活性和稳定性,其中以SiO2 载体最佳.     

载铁活性炭对水中草甘膦吸附性能研究

通过浸渍-焙烧法制备载铁活性炭,并用SEM电镜分析了载铁活性炭表面形态,研究了载铁活性炭(Fe-AC)对草甘膦溶液的吸附等温线和吸附动力学,并分析了各种影响因素对载铁活性炭吸附性能的影响.实验表明,Freundlich方程可以对Fe-AC草甘膦吸附等温线进行很好拟合,最大吸附量约为5.8mmol/g;其吸附动力学过程用Lagergren方程拟合,吸附速率常数在0.088min-1左右,且随着温度的升高逐渐减小.根据Kannan & Sundaram颗粒内扩散模型拟合,颗粒内扩散速率常数kp大于10mg·min-1/2/g,并随着起始温度的升高而减小.由于草甘膦的存在形态和Fe-AC材料表面性质的变化,AC-Fe对草甘膦的吸附能力随水溶液的pH升高而降低.NaCl的存在产生拮抗效应使得Fe-AC对草甘膦的吸附容量大大下降,随着NaCl浓度增加至4g/L后,盐析效应开始占主导地位,使得Fe-AC的吸附容量略有增加;由于草甘膦分子的空间位阻效应和亚磷酸根与载铁活性炭表面形成较强的络合物,使得随亚磷酸根浓度的升高Fe-AC对草甘膦的吸附量持续下降.     

Carbofuran removal in continuous-photocatalytic reactor: Reactor optimization,rate-constant determination and carbofuran degradation pathway analysis

Carbofuran (CBF) removal in a continuous-flow photocatalytic reactor with granular activated carbon supported titanium dioxide (GAC-TiO₂) catalyst was investigated. The effects of feed flow rate, TiO₂ concentration and addition of supplementary oxidants on CBF removal were investigated. The central composite design (CCD) was used to design the experiments and to estimate the effects of feed flow rate and TiO₂ concentration on CBF removal. The outcome of CCD experiments demonstrated that reactor performance was influenced mainly by feed flow rate compared to TiO₂ concentration. A second-order polynomial model developed based on CCD experiments fitted the experimental data with good correlation (R² ～ 0.964). The addition of 1 mL min^?1 hydrogen peroxide has shown complete CBF degradation and 76% chemical oxygen demand removal under the following operating conditions of CBF ～50 mg L^?1, TiO₂ ～5 mg L^?1 and feed flow rate ～82.5 mL min^?1. Rate constant of the photodegradation process was also calculated by applying the kinetic data in pseudo-first-order kinetics. Four major degradation intermediates of CBF were identified using GC-MS analysis. As a whole, the reactor system and GAC-TiO₂ catalyst used could be constructive in cost-effective CBF removal with no impact to receiving environment through getaway of photocatalyst.     

Evaluation of oasis ecosystem risk by reliability theory in an arid area： A case study in the Shiyang River Basin, China

Ecosystem risk is a new concept in understanding environmental problems. It is important to study and develop quantitative methods for regional ecosystem risk analysis. In this study, some new indicators and methods for measuring oasis ecosystem risk were established using reliability theory. These indicators are linked to water resource, which is the key restricting factor in arid area oasis ecosystems. They have clear meanings and can also be compared in different arid area oases. A case study in the Liangzhou oasis of the Shiyang River Basin in China shows how to calculate these ecosystem risk indicators. The results of the case study are as follows： the reliability indicator, risk indicator, stability indicator, and integrated loss indicator of the Liangzhou oasis are 0.686, 0.314, 0.743, and 0.301, respectively. This means that the reliability degree of the oasis＇s ecosystem safety is 68.6%; the degree of risk that it is unsafe is 31.4%; the stability degree is 74.3%; and 30.1% of the oasis＇s area is supported by over-exploiting underground water and damaging the lower reaches of the ecosystem. This result can be used as a guide in controlling and managing ecosystem risk in the research area.     

Number concentration and size distributions of submicron particles in Jinan urban area： Characteristics in summer and winter

The aerosol number concentration and size distribution were measured with the newly developed Wide-range Particle Spectrometer in summer and winter of 2006 at the urban site of Jinan City.Here reported the characteristics of fine particles of the different observation seasons.Relative high number concentrations for the particles in the diameter range of 10-500 nm were observed in both seasons.It was found that the dominant number distributed in particle diameter smaller than 100 nm and the percentage over the number concentration of all air particles is much higher than what has been measured in other urban sites over the world.The number mean diameter in summer was much smaller than in winter,strongly suggesting the different origin of ultrafine particles in different seasons.That is, particles in ultrafine mode mainly came from nucleation and new particle formation in summer while from traffic emission in winter. The diurnal variation also supported this point.Number concentration in the diameter range of 10-200 nm got their peak values at noontime,well correlated with the mixing ratio of SO_2 and the intensity of solar radiation in summer.While in winter,those in the same diameter range showed the main peaks during the traffic hours happened in the morning and evening.     

Di（2-ethylhexyl）phosphoric acid-coconut oil supported liquid membrane for the separation of copper ions from copper plating wastewater

Permeation of Cu(II) from its aqueous solution through a supported liquid membrane (SLM) containing di(2-ethylhexyl)phosphoric acid (D2EHPA) carrier dissolved in coconut oil has been studied. The effects of Cu(II), pH (in feed), H2SO4 (stripping) and D2EHPA (in membrane) concentrations have been investigated. The stability of the D2EHPA-coconutoil has also been evaluated. High Cu(II) concentration in the feed leads to an increase in flux from 4.1 × 10-9 to 8.9 × 10-9 mol/(m2·s) within the Cu(II) concentration range 7.8×10-4-78.6×10-4 mol/L at pH of 4.0 in the feed and 12.4 × 10-4 mol/L D2EHPA in the membrane phase. Increase in H2SO4 concentration in strip solution leads to an increase in copper ions flux up to 0.25 mol/L H2SO4, providing a maximum flux of 7.4 × 10-9 mol/(m2·s). The optimum conditions for Cu(II) transport are, pH of feed 4.0, 0.25 mol/L H2SO4 in strip phase and 12.4 × 10-4 mol/L D2EHPA (membrane) in 0.5 (m pore size polytetrafluoroethylene (PTFE) membrane. It has been observed that Cu(II) flux across the membrane tends to increase with the concentration of copper ions. Application of the method developed to copper plating bath rinse solutions has been found to be successful in the recovery of Cu(II). rane. It     

负载型TiO2催化臭氧化去除腐殖酸的实验研究

以实验室自制的负载型TiO2为催化剂,研究了其对水中溶解性腐殖酸的催化臭氧化效能。结果表明负载型TiO2对臭氧化去除溶解性腐殖酸有明显的催化作用,反应25min,对腐殖酸的去除率可达到86.8%,较单独臭氧化提高了28.8%;通过Na2CO3对催化反应的影响间接推断TiO2催化臭氧化反应遵循自由基反应的原理;实验最佳条件为:催化剂涂膜层数6层、焙烧温度700℃、溶液pH=10、放电电流0.4A、反应溶液初始浓度10mg/L;催化剂重复使用8次后,其催化活性变化较小,溶液中无钛离子溶出。     

有机膨润土负载纳米铁去除废水中硝基苯

用具有良好吸附能力的有机膨润土作载体,通过FeSO4与NaBH4反应制得负载型的纳米铁(NZVL/CTMAB-Bent),用XRD、BET对其性能进行了表征.以硝基苯为目标污染物,试验了 -NZVI/CTMAB-Bent对不同起始浓度硝基苯的去除作用,考察了介质PH对其去除效率的影响,并与相同铁含量的纳米铁(NZVI)进行了比较.此外.还对NZVI/CTMAB-Bent还原硝基苯的机理进行了探讨.结果表明,NZVI/CTMAB-Bent对硝基苯的去除能力远高于相同铁含量的NZVI.也明显优于相同含量的有机膨润土和相同铁含量的NZVI对硝基苯去除率的加和.     

芳烃燃烧钯催化剂的研究--载体、制备方法对催化活性的影响

以苯蒸气作为催化燃烧气，研究了３ 种不同载体和３ 种不同制备方法对金属负载型钯催化剂芳烃催化燃烧性能的影响，并用ＳＥＭ 对催化剂的表现形貌进行了分析．结果表明，载体及催化剂制备方法不同，催化剂的活性及耐热性不同．经一定的高温预处理后的含有稀土的ＦｅＣｒＡｌ 合金作载体性能较另两种载体优良；并提出了该催化剂较好的制备方法．     

Mo-TiO2/AC光催化剂的制备及可见光降解L-酸的研究

采用溶胶-凝胶法制备了Mo⁶⁺掺杂TiO₂光催化剂,并将其负载于粒状活性炭上,以1-萘酚-5-磺酸(L-酸)为模型反应物,研究了对L-酸的光催化作用并讨论了不同光源以及负载次数对L-酸的去除率和溶液的总有机碳去除率的影响.结果表明, Mo⁶⁺掺杂扩大了TiO₂催化剂的光谱响应范围.负载于活性炭上的掺杂二氧化钛为锐钛矿相,粒径约为17.8　nm.负载次数增多,催化剂的活性下降.Mo⁶⁺的掺杂不影响负载催化剂的紫外光活性及对L-酸的吸附能力.100　mg·L^-1的L-酸溶液加0.4 g催化剂,在可见光下反应4 h,掺杂催化剂对L-酸和溶液总有机碳的去除率分别为57%和53%,而未掺杂的催化剂去除率分别为13%和10%.催化剂反复使用4次,催化活性没有变化.