火电建设项目环境影响评价基础数据库建设方案与应用

针对火电建设项目环境影响评价的特点,提出了火电建设项目环境影响评价基础数据库的资料入库格式和内容要求。结合数据库的分类统计和GIS地理信息系统的空间分析功能,提出了基础数据库的数据处理与统计分析及数据库应用系统的建设方案,并得到初步应用。     

兰州大石鸡不同生活史阶段栖息地选择的初步研究

大石鸡不同生活史阶段选择不同的栖息地．集群期选择坡度小、低海拔、东向的山坡和坟地．配对期选择坡度３０～６０°、海拔居中的栖息地,选择的栖息地范围较宽．产卵期多见于坡度小、地面环境异质性小、海拔高的农田和山坡．育雏期选择植物丛密度低、坡度小、海拔高的山坡和农田．繁殖后期选择植物丛密度低、低海拔、东向的山坡和沟底．不同生活史阶段植被覆盖度、植物高度、环境类型和坡向差异不显著,坡度差异显著,植物丛密度、海拔高度和地面环境异质性差异极显著．在各环境因子中,只有地面环境异质性对大石鸡栖息地选择的影响较显著．地形、食物和气候可能是影响大石鸡栖息地选择的根本因素．     

土壤优先流的理论研究和试验分析

在活动流场模型的基础上建立了新的溶质运移控制方程,研究了流场分形特征参数的计算方法;采用4组染色示踪试验资料,分析了活动流场模型模拟土壤水流运动和溶质运移宏观非均匀特征的适用性.模拟分析表明,活动流场模型能较准确地捕捉到土壤中的优先流特别是不稳定流的宏观运动特征;土壤存在大孔隙结构的情况下,水流和溶质将更快的迁移到深层土壤,活动流场模型模拟计算的入渗深度偏小,但大于连续性模型的模拟计算结果;当土壤中的大孔隙结构较少时,活动流场模型模拟预测的土壤含水率分布和溶质浓度分布与实测结果比较一致.     

基于损伤检测的腐蚀疲劳寿命预测概率模型

建立了飞机结构腐蚀疲劳寿命预测的4阶段概率模型,结合腐蚀疲劳损伤检测结果,通过检测的灵敏度和准确度2个随机变量来描述检测技术的可靠性;建立了检测后的修正腐蚀疲劳寿命预测概率模型,通过对比分析修正前后的腐蚀疲劳寿命分布,得出腐蚀损伤尺寸的检测结果。对腐蚀疲劳寿命的评估影响很大,并且检测技术越可靠,寿命评估越准确。     

Effect of Sweating on Insulation of Footwear

The study aimed to find out the influence of sweating on footwear insulation with a thermal foot model. Simultaneously, the influence of applied weight (35 kg), sock, and steel toe cap were studied. Water to 3 sweat glands was supplied with a pump at the rate of 10 g/hr in total. Four models of boots with steel toe caps were tested. The same models were manufactured also without steel toe. Sweating reduced footwear insulation 19–25% (30–37% in toes). During static conditions, only a minimal amount of sweat evaporated from boots. Weight affected sole insulation: Reduction depended on compressibility of sole material. The influence of steel toe varied with insulation. The method of thermal foot model appears to be a practical tool for footwear evaluation.     

Determination of Heat Loss from the Feet and Insulation of the Footwear

This study compared the methods of determining footwear insulation on human participants and a thermal foot model. Another purpose was to find the minimal number of measurement points on the human foot that is needed for insulation calculation. A bare foot was tested at 3 ambient temperatures on 6 participants. Three types of footwear were tested on 2 participants. The mean insulation for a bare foot obtained on the participant and model were similar. The insulation of warm footwear measured by the 2 methods was also similar. For thin footwear the insulation values from the participants were higher than those from the thermal model. The differences could be related to undefined physiological factors. Two points on the foot can be enough to measure the insulation of footwear on human participants (r = .98). However, due to the big individual differences of humans, and good repeatability and simplicity of thermal foot method, the latter should be preferred for testing.     

A Comparison of Two Methods of Determining Thermal Properties of Footwear

The present European Standard for footwear testing (Standard No. EN 344:1992; European Committee for Standardization [CEN], 1992) classifies footwear thermally by a temperature drop inside the footwear during 30 min at defined conditions. Today, other methods for footwear thermal testing are also available. The aim of this study was to compare EN 344:1992 with a thermal foot method. Six boots were tested according to both methods. Additional tests with modified standard tests were also carried out. The methods ranked the footwear in a similar way. However, the test according to standard EN 344:1992 is a pass-or-fail test, whereas data that is gained from the thermal foot method gives more information and allows further use in research and product development. A change of the present standard method is suggested.     

An Evaluation of the NIOSH Lifting Equation: A Psychophysical and Biomechanical Investigation

Using the results of psychophysical and biomechanical experiments, NIOSH (National Institute for Occupational Safety and Health) Recommended Weight Limit (RWL), the Lifting Index (LI), the form of the asymmetry multiplier, and the criterion for compression force were investigated. Analysis of the results indicated a significant difference between the NIOSH RWL and the reported Maximum Acceptable Weight of Lift (MAWL). Contrary to the NIOSH lifting equation, the form of the asymmetry multiplier was found to be non-linear. The overall average of peak compression force on the L5/S1 was 3685 N. Fifty-eight percent of all compression forces reported in the biomechanical experiment were found to exceed the suggested 3400 N set by NIOSH guidelines. These results support previous research findings on the validity of NIOSH guidelines.     

A Study of Computer-Based Task Performance Under Thermal Stress

A visual-visual dual computer task was designed to test the effect of the thermal environment on dual task performance. The temperatures selected for testing were 20 and 35 °C Wet Bulb Globe Temperature (WBGT). 34 volunteers were randomly assigned to 1 of the 2 temperature conditions. Individual differences in single task performance were controlled by equating the baselines of single task performance. Once individual differences in single task capacity were controlled, statistically significant differences in performance were demonstrated. Mean accuracy was computed over a 1-hr testing period in each temperature condition. Participants’ mean accuracy in the 35° condition (38.18%) was substantially lower than in the 20° condition (50.88%).     

Effectiveness of a Light-Weight Ice-Vest for Body Cooling While Wearing Fire Fighter’s Protective Clothing in the Heat

The aim of the study was to examine the effects of wearing an ice-vest (ca 1 kg) on physiological and subjective responses in fire fighters. The experiments were carried out on a treadmill in a hot-dry environment. The physical cooling effect of the ice-vest was measured with a thermal manikin. The ice-vest effectively reduced skin temperatures under the vest. On average, heart rate was 10 beats/min lower, the amount of sweating was reduced by 13%, and subjective sensations of effort and warmth were lower during work with the ice-vest compared to work without it. Thermal manikin tests indicated that the useful energy available from the vest for body cooling was rather high (58%). In conclusion, the ice-vest reduces physiological and subjective strain responses during heavy work in the heat, and may promote efficient work time by 10%.