针织服装功能性面料环保改进处理研究

为使服装产业推进绿色环保,实现可持续发展战略,需要对针织服装功能性面料环保方面进行改进处理.通过调查针织服装类别、功能性面料产业分布情况及面料应用范围,分析针织服装功能性面料对环境的影响.依据针织服装功能性面料环保标准,提出功能性面料环保改进处理方向,结合面料实际应用需求,采用绿色环保纤维对当前针织服装功能性面料的环保问题进行改进处理,并对改进过程中的难点进行分析,引进天丝和莫代尔实现针织服装功能性面料环保方面的改进.     

麻醉呼吸机在手术室内环境中产生的毒害气体分析及预防处理研究

麻醉呼吸机在大型手术过程中会经常使用,由于麻醉过程中会使用一定氯化物,因此会造成一定有害气体的外泄,有害气体会影响手术进度以及手术的准确程度.针对上述问题,提出麻醉呼吸机在手术室内环境中产生的毒害气体的分析以及预防方法.对麻醉呼吸机能够泄露出的有害气体影响程度以及影响范围进行估计,针对产生的有害气体设计了完整的预防系统,通过传感器的使用达到对有毒气的预防监测过程.试验结果表明,设计的有害气体预防系统能够高敏感度对有毒气体识别分析.     

污水处理厂消毒技术对抗生素抗性菌的强化去除

基于消毒技术对污水处理厂出水中总异养菌(total heterotrophic bacteria,HPC)及5种抗生素抗性菌(antibiotic resistant bacteria,ARB):氨苄霉素抗性菌(AMP)、红霉素抗性菌(ERY)、四环素抗性菌(TET)、卡那霉素抗性菌(KAN)、环丙沙星抗性菌(CIP)的去除情况研究,分析消毒技术对ARB的强化去除效果.结果表明,实际污水处理厂的紫外消毒对ARB去除率仅为18.2%~40.9%,且AMP含量最高;另外,消毒技术对ERY有选择性去除效果,对其他4种ARB无明显选择性去除效果(P0.05);最后结合次氯酸钠、臭氧、紫外消毒处理对COD、NH_4~+-N的去除效果,确定强化去除ARB的消毒方式中臭氧,次氯酸钠和紫外的最佳浓度和剂量依次为5.0 mg·L~(-1)、25.0 mg·L~(-1)和45.0 m J·cm~(-2),ARB去除率依次为45.5%~74.5%、66.1%~85.5%、68.6%~85.5%,另外次氯酸钠耦合紫外消毒强化去除ARB的效果更佳.     

关于医疗垃圾飞灰中二噁英在惰性气氛下的低温热脱附研究

以医疗垃圾焚烧炉布袋除尘器前管道内飞灰(BG)及布袋除尘器后飞灰(AG)为对象,研究不同温度及时间段下其在管式炉中的热脱附特性.结果表明,在低温氮气气氛下,热脱附作用较为明显,2种飞灰中的二噁英都有了不同程度的脱除,其中布袋前飞灰中二噁英的脱除率为82.9%～99.9%之间,毒性当量脱除率为77.3%～99.8%,布袋后飞灰中二噁英的脱除率为66.8%～99.8%之间,毒性当量脱除率为43.5%～99.6%.检测收集到的实验尾气,发现了二噁英的存在,且在300～350℃这个温度段生成量最多,且生成的有毒二噁英同系物中以OCDD为主.通过比较发现,当温度为400℃,加热时间为45 min时2种飞灰中的二噁英脱除效率最高.鉴于惰性气氛下的热脱附对处理飞灰中的二噁英具有较好的作用,可将其大规模应用于实际工程中.     

放射性废水的膜处理技术研究进展

核燃料的生产、核电厂的运行、同位素的生产和使用等过程都会产生着大量的放射性废水,为了保护环境和人类健康,这些废水必须经过安全、经济和有效的处理处置.放射性废水传统的处理方法主要包括过滤法、离子交换法、蒸发法或这几种工艺的组合.近年来,膜分离技术在放射性废水处理中得到了广泛的研究,发达国家已有应用膜分离技术处理放射性废水的实例,而我国规模化应用的实例还很少见.本文首先介绍了放射性废水的来源及组成,分析了各种放射性废水处理方法的优势和不足,包括化学沉淀法、过滤法、离子交换法、蒸发浓缩法、吸附法、生物还原/吸附法和膜分离法等.在此基础上,重点介绍了各种膜分离技术,包括微滤、超滤、纳滤、反渗透、膜蒸馏等在放射性废水处理中研究与应用现状,对已有的文献资料进行了较系统全面的分析、归纳和总结,对各种方法的优缺点及适用范围进行了比较,对膜技术在放射性废水处理中的应用前景及问题进行了讨论.最后,简要介绍了放射性废水处理产生的浓缩产物的最终处理处置,对放射性废水处理技术未来的研究和发展方向给出了建议.     

呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

乙醇处理对树脂基纳米水合氧化铁结构及其除砷性能的影响

通过考察乙醇处理对树脂基纳米水合氧化铁(D201-HFO)结构及其除砷性能的影响,评价乙醇处理在复合材料制备中的必要性.结果表明,乙醇处理后负载水合氧化铁(HFO)在D201树脂内的分散性增加,材料对砷的饱和吸附量提高约20%,且复合材料的比表面积、孔容、孔径分别增加了52%、65%、28%;但乙醇处理对复合材料的机械强度和负载HFO的晶型无影响,在pH值、离子竞争对该材料除砷性能的影响趋势方面也无明显作用,对复合材料固定床除砷性能及再生方面也无明显作用.总体而言,乙醇处理对D201-HFO复合材料实际除砷性能影响不大,从技术经济性考虑可以省略.     

含铬废水的处理技术及机理简述

介绍了废水中六价铬的来源及存在形态,以及处理含铬废水的物理、物化、化学及生物等各种工艺,并对各种工艺的机理和优缺点进行分析,展望含铬废水的治理前景。     

Biodegradation by bioaugmentation of dairy wastewater by fungal consortium on a bioreactor lab-scale and on a pilot-scale

A fungal consortium including Aspergillus niger, Mucor hiemalis and Galactomyces geotrichum was tested for the treatment of dairy wastewater. The bio-augmentation method was tested at lab-scale (4 L), at pilot scale (110 L) and at an industrial scale in Wastewater Treatment Plants (WWTP). The positive impact of fungal addition was confirmed when fungi was beforehand accelerated by pre-culture on whey (5 g/L lactose) or on the dairy effluent. Indeed, chemical oxygen demand (COD) removal yields increased from 55% to 75% for model medium, diluted milk. While after inoculation of an industrial biological tank from a dairy factory with the fungal consortium accelerated by pre-cultivation in a 1000 L pilot plant, the outlet COD values decreased from values above the standard one (100 mg/L) to values in the range of 50-70 mg/L. In addition, there was a clear impact of fungal addition on the ’hard’ or non-biodegradable COD owing to the significant reduction of the increase of the COD on BOD 5 ratio between the inlet and the outlet of the biological tank of WWTP. It was in the range of 451%-1111% before adding fungal consortium, and in the range of 257%-153% after bio-augmentation with fungi. An inoculated bioreactor with fungal consortium was developed at lab-scale and demonstrated successfully at pilot scale in WWTP.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.