Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.     

Effects of nitrogen and carbon dioxide on hydrogen explosion behaviors near suppression limit

By varying inert gas content, equivalence ratio and initial pressure, this study is aimed at investigating flame propagation behaviors and explosion pressure characteristics near suppression limit. For carbon dioxide, the weakest flame floating phenomenon is observed at Φ = 1.5 and the buoyant instability is enhanced when the equivalent ratio deviates to the rich and lean sides. For nitrogen, the buoyant instability decreases with increasing equivalent ratio. Both maximum explosion pressure and maximum pressure rise rate increase firstly and then decrease with the increase of equivalence ratio, and they decrease significantly with increasing content of carbon dioxide and nitrogen. For carbon dioxide, the critical suppression ratio of Φ = 0.6, 0.8, 1.0, 1.5 and 2.0 is 7.50, 7.18, 5.74, 3.83, and 2.87. For nitrogen, the critical suppression ratio of Φ = 0.6, 0.8, 1.0, 1.5 and 2.0 is 15.83, 11.87, 9.50, 6.33 and 4.75. Compared to nitrogen, the carbon dioxide is more effective on suppressing hydrogen explosion pressure. The adiabatic flame temperature, thermal diffusivity and mole fraction of active radicals continue to decrease with increasing content of carbon dioxide and nitrogen, which contributes to the decrease of laminar burning velocity.     

Recent application of Computational Fluid Dynamics (CFD) in process safety and loss prevention: A review

In recent years, significant progress has been made to ensure that process industries are among the safest workplaces in the world. However, with the increasing complexity of existing technologies and new problems brought about by emerging technologies, a strong need still exists to study the fundamentals of process safety and predict possible scenarios. This is attained by conducting the corresponding consequence modeling and risk assessments. As a result of the continuous advancement of Computational Fluid Dynamics (CFD) tools and exponentially increased computation capabilities along with better understandings of the underlying physics, CFD simulations have been applied widely in the areas of process safety and loss prevention to gain new insights, improve existing models, and assess new hazardous scenarios. In this review, 126 papers from 2010 to 2020 have been included in order to systematically categorize and summarize recent applications of CFD for fires, explosions, dispersions of flammable and toxic materials from accidental releases, incident investigations and reconstructions, and other areas of process safety. The advantages of CFD modeling are discussed and the future of CFD applications in this research area is outlined.     

UV Spectroscopic Monitoring of Vaporized Monoaromatic Hydrocarbons from Petroleum-Contaminated Soils

Fast and simple systems using ultraviolet (UV) absorbance were examined for on-line monitoring of monoaromatic hydrocarbons from petroleum-contaminated soils in this research. Since soil particles hinder the UV light transmittance, the absorbance measurement of vaporized monoaromatic hydrocarbons in soil gas extracted from petroleum-contaminated soils was proposed. In the fixed system that exhibited higher sensitivity than the portable one, the absorbance intensity of benzene, toluene, ethylbenzene, and xylene increased in proportion to the concentration of the contaminants. The portable system, however, was suitable for screening purpose, while it exhibited faster response. There was no interference from water, which helps the applicability of the proposed systems to the actual fields.     

水蒸气电晕放电下的烟气脱硫效果

采用多针-板式电极,在70 m³/h烟气流量范围内,研究了水蒸气浓度、烟气流量、电场强度等因素对不饱和水蒸气正直流电晕放电烟气脱硫率的影响以及水蒸气电晕放电对脉冲放电烟气脱硫率的提高.研究结果表明,实验范围内,按照NH₃∶SO₂摩尔比为2∶1添加NH3的条件下,增加水蒸气流量、增强电场强度、减少烟气流量,烟气脱硫率能提高10%,达到60%左右.同时,水蒸气电晕放电能使脉冲放电的烟气脱硫率提高5%左右,达到90%以上.     

Low‐concentration hydrogen peroxide decontamination for Bacillus spore contamination in buildings

Remediation and recovery efforts after a release of Bacillus anthracis (anthrax) spores may be difficult and costly. In addition, response and recovery technologies may be focused on critical resources, leaving the small business or homeowner without remediation options. This study evaluates the efficacy of relatively low levels of hydrogen peroxide vapor (HPV) delivered from off‐the‐shelf equipment for the inactivation of Bacillus spores within an indoor environment. Decontamination evaluations were conducted in a house using both Bacillus atrophaeus var. globigii (Bg; as surrogates for B. anthracis) inoculated on the carpet and galvanized metal as coupons and Geobacillus stearothermophilus (Gs) as biological indicators on steel. The total decontamination time ranged from 4 to 7 days. Using the longer exposure times, low concentrations of HPV (average levels below 20 parts per million) effectively inactivated Bg and Gs spores on the materials tested. The HPV was generated with commercial humidifiers and household‐strength hydrogen peroxide solutions. The presence of home furnishings did not have a significant impact on HPV efficacy. This simple, inexpensive, and effective decontamination method could have significant utility for remediation following a B. anthracis spore release, such as following a terrorist attack.     

加油站地下储油罐压力管理系统的相关研究

在当前普遍采用的加油站真空辅助式第二阶段油气回收系统中,为了避免回收到地下储油罐中的油气再次通过P/V阀排空,必须对其中气相空间的压力实施有效控制。从国外的发展情况来看,地下储油罐的压力管理系统主要分为基于膜分离技术、基于弹性气囊和基于活性炭吸附三大类,其中膜法油气回收装置在国内已经得到了较多关注。首次系统介绍了气囊式压力管理系统的工作原理及其主要结构设计,具体包括管线布局、钢制压力容器壳体、位于容器顶部封头上的接口组件和全部位于容器内的气囊等;同时对另外一种可行方案进行了分析。     

Liquefaction process for a hydrothermally treated waste mixture containing plastics

Most landfilled plastic waste is a mixture or is in the form of composites with incombustible wastes such as glass, metals, and ceramics. After hydrothermal treatment, including a steam-explosion process, the separation of mixed waste (MW) into organic and inorganic substances becomes easy. However, the effect of hydrothermal pretreatment on the subsequent liquefaction of organic substances from MW is not obvious. In this study, the effects on the liquefaction of polystyrene and high-density polyethylene are discussed. Moreover, optimum conditions for the liquefaction of organic substances from hydrothermally treated MW are identified. By means of this hydrothermal pretreatment, including the steam-explosion process, polystyrene and high-density polyethylene can be significantly converted to oil by liquefaction at 300°–400°C. In comparison with liquefaction of hydrothermally pretreated mixed waste (HMW) at 300°–400°C with a batch type reactor, the yield of oil increases significantly on liquefaction using a semi-batch type reactor. It is considered that the radical chain and termination reactions among the radicals from HMW were inhibited in the semi-batch type reactor. On liquefaction of HMW in a semi-batch reactor, the conversion of HMW to oil was enhanced on increasing the liquefaction temperature to 350°C and the holding time to 60 min. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

基于道化法(DOW)的计算机辅助软件开发

传统的评价方法费时费力,效率低下.将计算机技术与评价方法相结合是评价工作发展的趋势.介绍了为世界各国石油化工企业所广为接受的美国道化学公司(DOW)火灾、爆炸危险性指数评价法,以及根据该法的评价思路所开发的辅助软件的设计思路和功能.