NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

稀土在废水处理中的应用进展

综述了国内稀土金属在废水处理中的最新应用进展,总结了稀土复合吸附剂的制备方法及其在含磷、氨氮、砷、氟、铬、镉等废水处理中的效果,讨论了稀土复合混凝剂和稀土催化剂在染料、助剂、化工等高浓度有机废水处理中的应用,为找到高效环保的处理工业废水的方法提供了依据.     

利用含铬废水和含铅废水制备铬黄

利用净化后的含铬废水和含铅废水制备铬黄.采用沉淀法对废水进行净化预处理,最佳工艺条件:100mL含铬废水中加入20 g Na_2CO_3,及10 mL H_2O_2,用NaOH调节含铬废水pH为10.00;用NaOH调节含铅废水pH为2.65.将净化后的10 mL含铬废水和25 mL含铅废水混合,在55-60℃条件下反应10 min,合成的铬黄达到GB/T 3184-2008<铬酸铅颜料和钼铬酸铅颜料>的质量标准.经重金属吸附剂处理Pb~(2+)后铬黄合成滤液中的Cr~(6+)和Pb~(2+)质量浓度均达到GB8978-1996<污水综合排放标准>的指标.     

pH敏感性β-环糊精微球的制备及其吸附性能

采用反相微悬浮乳液聚合技术制备了β-环糊精(β-CD)微球,用丁二酸酐对β-CD微球进行化学改性,制备了pH敏感性β-CD(pH-β-CD)微球.通过傅里叶红外光谱仪和扫描电子显微镜对微球的结构、粒径和形貌进行了表征.探讨了亚甲基蓝模拟染料废水pH、吸附时间和微球加入量对亚甲基蓝吸附性能的影响.实验结果表明,在亚甲基蓝模拟染料废水pH为10.0、吸附时间为90 min的条件下,当pH-β-CD微球加入量为50 mg时,pH-β-CD微球吸附量为16.1 mg/g;当pH-β-CD微球加入量为250 mg时,pH-β-CD微球对亚甲基蓝的脱色率达96.2%.     

改性高岭土处理含酸性媒介染料的印染废水

用十六烷基三甲基溴化铵(CTMAB)改性的高岭土处理以水溶性酸性媒介染料为主的印染废水.实验结果表明,当CTMAB-高岭土加入量为0.6 g/L、用石灰乳控制废水pH为9.5～10.0、聚丙烯酰胺的加入量为2.0 mg/L时,废水的处理效果最佳,废水色度和COD去除率分别达到98.0%和92.0%以上,出水色度和COD达到了GB4287-92<纺织染整工业水污染物排放标准>一级排放标准.     

Liquefaction process for a hydrothermally treated waste mixture containing plastics

Most landfilled plastic waste is a mixture or is in the form of composites with incombustible wastes such as glass, metals, and ceramics. After hydrothermal treatment, including a steam-explosion process, the separation of mixed waste (MW) into organic and inorganic substances becomes easy. However, the effect of hydrothermal pretreatment on the subsequent liquefaction of organic substances from MW is not obvious. In this study, the effects on the liquefaction of polystyrene and high-density polyethylene are discussed. Moreover, optimum conditions for the liquefaction of organic substances from hydrothermally treated MW are identified. By means of this hydrothermal pretreatment, including the steam-explosion process, polystyrene and high-density polyethylene can be significantly converted to oil by liquefaction at 300°–400°C. In comparison with liquefaction of hydrothermally pretreated mixed waste (HMW) at 300°–400°C with a batch type reactor, the yield of oil increases significantly on liquefaction using a semi-batch type reactor. It is considered that the radical chain and termination reactions among the radicals from HMW were inhibited in the semi-batch type reactor. On liquefaction of HMW in a semi-batch reactor, the conversion of HMW to oil was enhanced on increasing the liquefaction temperature to 350°C and the holding time to 60 min. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

Dechlorination of polyvinyl chloride in NaOH/ethylene glycol solution by microwave heating

This study investigated the dehydrochlorination of flexible polyvinyl chloride (PVC) containing 59.2% PVC, 29.7% dioctyl phthalate (DOP), and approximately 12% stabilizers. Flexible PVC was treated with NaOH/ethylene glycol (NaOH/EG) solutions at NaOH concentrations in the range 0.5–4 mol/l and was heated in a microwave heater at a temperature between 100° and 160°C for 0–30 min. All chlorides were completely eliminated by internal heating at 160°C using microwaves for 10 min in a 1 mol/l NaOH/EG solution, and the residue was made up of hydrocarbons. The weight loss rate reached a maximum of 74.7% at a temperature of 160°C. It was discovered that the use of microwaves significantly shortened the reaction time compared to using conventional electric heaters or other external heating systems and also allowed the use of lower concentrations of NaOH. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

利用活化粉煤灰处理造纸废水的研究

通过正交试验,对粉煤灰处理造纸废水的影响因素进行了研究。研究结果表明：对粉煤灰进行活化,能增加其对造纸废水COD的去除效果;最佳的试验设计方案为：粉煤灰经40％硫酸活化、粒度160—200目、投加量为30g／100ml;影响COD去除率的大小顺序为：投加量影响最大,粒度次之,活化方式影响最小。     

铁碳微电解法在废水处理中的研究进展及应用现状

介绍了铁碳微电解法处理废水的作用机理,概述了近10年来国内外利用铁碳微电解法及其组合工艺对印染、造纸、焦化、炸药、制药等废水处理方面的研究进展及实际的应用状况.提出了铁碳微电解法在运行过程中存在的几个问题,并对今后研究工作的大体方向做了初步的探讨.