模拟雨水对工业烧渣中重金属浸出特性的研究

采用《固体废物浸出毒性浸出方法—水平振荡法》(HJ557-2010)对工业固体烧渣中重金属进行浸出试验研究,并利用火焰原子吸收分光光度法分别测定了其浸出液中的铅、铬、锌、镉、铜、铁和镍等7种重金属,用可见分光光度法测定砷,考察了模拟酸雨的pH值、液固比和浸取时间等因素对烧渣中重金属的浸出试验的影响,实验结果表明烧渣中各重金属的浸出值均未超出国家标准《危险废物鉴别标准—浸出毒性鉴别》(GB5085.3-2007)中的允许值,可直接作为建筑材料或路基材料使用。     

宁波市区近十年酸雨污染趋势分析

采用2001-2010年宁波市区降水监测数据,对宁波市区的酸雨污染现状及2001年以来的变化趋势分析,结果表明:酸雨频率居高不下,且降水酸度并未减弱,宁波市区酸雨的污染类型处于硫酸型向硫酸与硝酸混合型转变的过渡期。并根据宁波市区实际情况提出相应防治对策。     

曝气生物滤池的短程硝化特性

通过控制进水pH值实现曝气生物滤池的短程硝化。工艺运行结果表明,对于进水pH值为8.22~8.57,NH4+-N平均容积负荷为0.5 kg/(m3.d),水温为17.5~20.2℃,曝气生物滤池溶解氧质量浓度平均为4.5 mg/L的条件下能够同步实现95%的NH4+-N去除率和80%的NO2--N积累率。通过分析FA和FNA沿滤池高度的变化特征,发现滤池底部(0~5 cm)区域短程硝化反应主要由FA控制,中部(5~15 cm)区域是由FA和FNA共同掌控;而上部区域(15~50 cm)则是由FNA控制,FNA沿滤池高度的快速增加是确保工艺实现稳定亚硝酸盐积累的重要原因。     

高锰酸盐指数一酸性法空白质量控制研究

常规监测高锰酸盐指数-酸性法,通过对高锰酸盐指数空白测试与检测限、空白质控图、空白加标回收率进行测试研究,可以得到理想的监测结果。     

亚甲蓝分光光度法测定水体阴离子表面活性剂方法的探讨

LAS是地表水和地下水水质的必测项目,国标（GB7494—87）方法操作复杂,要重复萃取四次后再洗涤,有机溶剂消耗量大,而且相当的耗时,本文通过同步实验对比与分析,得出：一次性加入20mL氯仿萃取加洗涤的方法其测定结果较好,而且极大地减轻了氯仿对分析人员身体的损害程度。测定结果有较好的精密度和准确度。本方法具有可观的经济性、安全性和可操作性。     

聚硅酸对不同形态铝沉积行为的影响

针对给水管网中残余铝沉积和再溶解现象可能引起的水质问题,研究了聚硅酸对不同水解聚合形态铝沉积、再溶解的影响,并以石英微晶天平为表征手段,初步探讨了聚硅酸对不同形态铝沉积、再溶解过程影响的机理.结果表明,聚硅酸能显著改变不同水解聚合形态铝的沉积、再溶解行为.聚硅酸可与3种水解聚合形态的铝迅速结合而生成可沉积产物,但产物性质不同.以单体形态为主的Al_0与聚硅酸的反应产物性质较稳定,部分以溶解态存在,部分以非溶解态(可沉积态)存在;尽管铝的两种聚合形态Al_(13)和Al_(30)与聚硅酸反应也生成了部分可沉积产物,但随着时间的推移,这些产物又逐渐向溶解态转化.铝硅比对Al_0体系中铝的沉积溶解行为影响较小,而对Al_(13)和Al_(30)影响较大,且在0.2∶20(以Al和SiO_2计的质量比)时,沉积态铝的溶解速率最快.     

Reaction mechanism and metal ion transformation in photocatalytic ozonation of phenol and oxalic acid with Ag+/TiO2

Photocatalytic ozonation of phenol and oxalic acid （OA） was conducted with a Ag^＋/TiO2 catalyst and different pathways were found for the degradation of different compounds. Ag^＋ greatly promoted the photocatalytic degradation of contaminants due to its role as an electron scavenger. It also accelerated the removal rate of OA in ozonation and the simultaneous process for its complex reaction with oxalate. Phenol could be degraded both in direct ozonation and photolysis, but the TOC removal rates were much higher in the simultaneous processes due to the oxidation of hydroxyl radicals resulting from synergetic effects. The sequence of photo-illumination and ozone exposure in the combined process showed quite different effects in phenol degradation and TOC removal. The synergetic effects in different combined processes were found to be highly related to the properties of the target pollutants. The color change of the solution and TEM result confirmed that Ag＋ was easily reduced and deposited on the surface of Tit2 under photo-illumination, and dissolved again into solution in the presence of ozone. This simple cycle of enrichment and distribution of Ag^＋ can greatly benefit the design of advanced oxidation processes, in which the sequences of ozone and photo-illumination can be varied according to the needs for catalyst recycling and the different properties of pollutants.     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

石墨烯基磁性复合材料吸附水中亚甲基蓝的研究

建立了一种超声辅助共沉淀法制备磁性Fe3O4/氧化石墨烯(Fe3O4/GO)纳米粒子.透射电镜和磁滞回线研究表明,该复合物具有小的颗粒尺寸和超顺磁性.该磁性纳米材料可以吸附废水中的染料亚甲基蓝,实验研究了溶液pH值、吸附剂的用量、时间和温度对亚甲基蓝去除率的影响.结果表明,pH值在6~9范围内,Fe3O4/GO都能高效地吸附亚甲基蓝.反应过程在前25 min反应速率很快,到180 min内达到吸附平衡.该磁性纳米材料对亚甲基蓝的吸附符合Langmuir吸附等温模型和准二级动力学方程,吸附过程是一个自发和吸热过程.该吸附材料对亚甲基蓝吸附容量高,在313 K时Fe3O4/GO的饱和吸附量为196.5 mg·g-1.另外,可以方便地通过外部磁场分离回收吸附剂,利用过氧化氢可以再生重复使用,是一种优良的吸附染料废水的材料.