Spatial cost efficiency in waste paper handling: the case of corrugated board in Sweden

This paper analyzes the spatial cost efficiency of the Swedish legislation regarding waste disposal handling. We focus on the case of corrugated board and recognize that the different counties in Sweden possess different economic prerequisites in terms of waste paper recovery and utilization potential. We employ data for six corrugated board mills and 20 counties and a non-linear programming model to identify the least cost strategy for reaching the politically specified recycling target of a 65% recovery rate for corrugated board. That is, the total costs of recovering a minimum of 65% in each county are calculated and compared with the case when the country as a whole recovers 65% of all old corrugated board is collected but there exist no uniform target for each county. The conclusion is that from an efficiency point of view the recovery efforts should be concentrated to the highly populated and urbanized counties, and not be uniformly divided throughout the country. In the base case, the results suggest that the cost efficient county-specific recovery rates should range from 51 to 72%.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

UASB启动运行特征及互营丙酸氧化菌定量分析

为揭示升流式厌氧污泥床（UASB）反应器启动运行效能与互营丙酸降解菌群数量之间的关系,以稀释的玉米淀粉生产废水为底物,考察了UASB启动期的运行特征,并采用实时荧光定量PCR技术（qPCR）分析了互营丙酸降解菌群（丙酸氧化菌和产甲烷菌）的演替规律.结果表明,在进水COD 2000mg/L和水力停留时间（HRT）24h条件下,经过38d的连续运行,COD去除率达到了91.9%.当HRT分阶段缩短至8h时,比产甲烷速率达到了315LCH₄/（kg COD·d）,且形成了沉降性能良好的颗粒污泥.qPCR检测结果表明,至少有5种已鉴定的丙酸氧化菌存在于UASB反应器中.Pelotomaculum propionicum为接种污泥中的主要丙酸氧化菌,约占检测到丙酸氧化菌总数的45.7%.它的数量随着HRT缩短不断减少.而Syntrophobacter sulfatireducens和S.wolinii的数量随着HRT缩短不断增加,并在启动完成时达到最大值,分别为1.3×10³,5.5×10³个16S rRNA基因拷贝数/ng DNA,演替成为成熟颗粒污泥中的优势丙酸氧化菌群.Methanobacterium和Methanosarcina为接种污泥中的主要氢营养型产甲烷菌和乙酸营养型产甲烷菌,其数量随着HRT的缩短而逐渐减少,而Methanospirillum和Methanosaeta的数量随HRT的缩短逐渐增加,成为成熟颗粒污泥中的优势产甲烷菌群.     

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

用EXCEL进行精密度-偏性分析质控数据处理

利用EXCEL强大的数据处理功能，可以方便地对精密度—偏性分析质控数据进行处理，具有较高的推广价值。     

消泡剂硅油I在工业废水氨氮测定中的应用

对色泽较深，含杂质量较高的废水加硅油I以抑制测定中蒸馏产生的泡沫．结果表明，在250ml水样中加硅油IO．10～1．25ml，即可收到理想效果．硅油I性质稳定，不随水蒸汽蒸出，对测定无干扰．     

泰州市环境空气中挥发性有机物分布特征

于2018年4—9月对泰州市环境空气中挥发性有机物(VOCs)组分开展现场观测,结合观测数据分析该市大气中VOCs的时空分布特征。结果表明:观测期间泰州市环境空气中VOCs平均摩尔比为45.1 nmol/mol,其中含氧挥发性有机物占比为57.8%;受周边排放源和地理位置影响,下风向点位的VOCs测定值高于其他点位;VOCs月均最高值出现在6月,与臭氧月均最高值出现时间一致,7—9月气团出现老化,导致臭氧生成能力减弱;观测期间VOCs中甲苯/苯(T/B)比值范围为0.201 9～5.130 3,且大部分T/B比值2,说明溶剂、油气和液化石油气挥发等排放源对泰州市环境空气中VOCs的影响较为显著。     

计算机图像识别的烟气自动监测

介绍了计算机图像识别的烟气排放自动监测方法，它由监控点图像处理系统和监控中心自动监控系统组成。该方法可应用于工业企业烟气排放的自动检测，若有超标排放，系统自动发出警告，显示出该超标排放的点位和烟气林格曼黑度的级别，特别适用于网络信息化管理。     

小型废电池填埋焚烧处置的健康风险分析

对废电池采取填埋、焚烧处置所引起的健康风险进行了分析，采用3种模型，分别研究了废电池随城市固体废物一起完全填埋处置，一起完全焚烧处置，一起部分填埋处置和部分焚烧处理时，可能引起的健康风险，由分析可知，镉镍电池焚烧过程将引起不可接受的致癌风险，填埋废电池也会引起重金属非致癌风险，提出在现阶段没有单独收集分类管理的条件下，对于小型废电池应采取填埋焚烧联合处置的办法，但应避免镉镍电池的焚烧，在建立了收集体系后，应该分类进行资源化和无害化管理。     

New method for determination of arsenic contentin tail gases during semiconductor processing

ＮｅｗｍｅｔｈｏｄｆｏｒｄｅｔｅｒｍｉｎａｔｉｏｎｏｆａｒｓｅｎｉｃｃｏｎｔｅｎｔｉｎｔａｉｌｇａｓｅｓｄｕｒｉｎｇｓｅｍｉｃｏｎｄｕｃｔｏｒｐｒｏｃｅｓｓｉｎｇＷｅｎＲｕｉｍｅｉ，ＰｅｎｇＹｏｎｇｑｉｎ（Ｉｎｓｔｉｔｕｔｅｏｆｍｉｃｒｏｃｏｎｄｕｃ...