Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

磁性氧化石墨处理乳化含油废水及磁致增强效应

以高铁酸钾为氧化剂,基于改进Hummers法制备了新型磁性氧化石墨材料,在SEM、FTIR、氮气吸脱附和表面接触角表征基础上,探究了该材料处理乳化含油废水的效果及磁致增强效应.结果表明：相较于石墨,磁性氧化石墨比表面积增大,表面有卷曲结构并负载着Fe₃O₄颗粒,具有含氧官能团,存在疏水性较强的微观孔隙结构.在外加磁场条件下,磁性氧化石墨团聚,形成疏水性宏观孔隙结构,利于乳化油滴的吸附和附着.磁性氧化石墨处理乳化含油废水的能力远好于石墨与粉末活性炭,且处理效率与磁场强度成正相关,COD去除率可达95%以上.使用后的磁性氧化石墨进行溶剂萃取或热处理,可以循环使用.磁性氧化石墨经过4次循环使用,热再生效率为92%,溶剂萃取再生效率为86%.以上研究为乳化含油废水的处理提供了一种有效的方法.     

中国乘用车塑料的动态物质流分析

结合行业信息并基于动态物质流模型,本文对1950~2050年间中国乘用车塑料流量与存量进行了历史测算与情景分析.历史测算表明：1950~2018年国内乘用车行业累计消耗了以聚丙烯（PP）、聚氨酯（PU）等为主的塑料3278万t,产生了337万t塑料废弃物;报废汽车拆解后的车用废塑料仅28%得到回收利用.针对未来情况,本文设计了乘用车保有量、单车塑料使用量两大关键因素下的不同情景组合.结果显示车用塑料存量及废塑料产生量将大幅增长,到2050年存量将达到0.7~2.7亿t,废塑料产生量将达到500~1600万t,汽车拆解和塑料再生等相关行业对此应充分关注.到2050年车用废塑料回收率若能提升至80%,将减少376万t/a的车用废塑料填埋或焚烧,显著减少环境风险.     

农业经营规模化发展对环境效率的影响——基于地块层面的实证分析

为探析农业规模化经营与农业环境可持续性之间的关系,对农业经营规模对农业环境效率的影响进行理论分析,并在此基础上构建了物料平衡原则下农业环境效率测算模型和农业环境效率影响模型.基于2004~2016年浙江省农户水稻种植地块层面的面板数据,实证检验了土地面积、劳动投入、资本投入和农业产出等农业经营规模指标对农业环境效率的影响.结果显示,农业规模化发展将因投入和产出的扩张以多种方式影响其环境效率,其中土地面积规模与农业环境效率之间呈倒U型关系,劳动投入和资本投入对农业生产环境效率均有负向的影响,而农业产出规模的增加将促进农业环境效率的提升.     

中国报废汽车中铂族金属回收潜力估算

基于Gompertz模型预测中国2018~2050年民用汽车的社会保有量;在此基础上,采用物质流分析方法估算得出我国汽车高峰报废年限大约为9a.然后,通过市场供给A模型预测我国2018~2025年汽车报废量,结果显示,我国汽车报废量到2025年将达到2535.05万辆,并且地理空间分布极不均衡.基于上述汽车报废量的时空分布,测算不同技术发展情景下废汽车三元催化剂中的铂族金属回收潜力和需求量.结果显示：如果按照当前催化剂消耗水平,全国铂族金属的需求量均在2019年达到峰值,铂钯铑分别达到4.57,65.70,7.92t,有望实现行业内闭环供应;如果以欧盟汽车尾气治理标准为目标,而现有汽车技术不发生根本变化,需求量将大幅增加,铂钯铑分别在2020年达到峰值85.01,109.38,8.37t,存在严重的供需矛盾.为此,建议在汽车生产者责任延伸制度中,关注废催化剂的回收和再生利用,以促进前端生产环节在不同技术选择中考虑稀贵金属的供给限制.     

颗粒物分界层Mie散射激光雷达识别的sigmoid算法

基于成都市2013年6月~2015年5月期间由Mie散射激光雷达探测的大气消光系数廓线资料,发现混合层以上在颗粒物消光和分子消光之间一致存在一个S型的过渡区,利用sigmoid函数对此分布形态进行模拟,通过计算该函数上下曲率最大点所在的高度,据此提出了颗粒物分界层Mie散射激光雷达识别的sigmoid算法.针对该算法模拟效果的分析表明,颗粒物分界层过渡区附近大气消光系数理论廓线和实测廓线保持了高度的相关性,二者在春夏秋冬四季的相关系数（R）分别为0.9971±0.0052、0.9935±0.0167、0.9979±0.0038和0.9990±0.0021（均通过α=0.05的显著性检验）.基于sigmoid算法计算的颗粒物分界层过渡区与成都市温江站探空资料得到的逆温层之间存在很好的对应关系.     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

油气集输管道内防腐技术应用进展

针对油气田集输管道的内腐蚀问题,分别介绍了耐蚀材料、衬里技术、涂镀层技术与药剂防腐技术等管道内防腐技术及其现场应用效果,指出了耐蚀金属材料防腐效果显著,但存在经济效益差的缺点。为降低成本,选用双金属复合管替代耐蚀金属材料,但其焊缝位置腐蚀失效频发,成为制约其应用的薄弱环节。耐蚀非金属材料防腐效果显著,但耐高温性能与力学性能较差,受温度、压力与CO_2、H_2S、固体颗粒等介质成分的影响,衬里技术与涂镀层技术的应用范围受到限制。药剂防腐技术的防护效果与药剂类型、加药工艺密切相关,需要根据腐蚀工况监测结果进行实时调整。针对上述内防腐技术存在的问题,提出了未来内防腐技术的发展方向为改进现有内防腐技术存在的不足,提升其防护效果。同时,应开发防腐效果显著、经济成本低、施工简便、易于推广应用的防腐材料与防腐工艺技术。     

对室内装饰装修材料检测中甲醛分析方法的研究

目前室内装饰装修材料中甲醛含量的检测有六个类别,分析方法不统一,且没有一定的质量控制措施.文章对分析方法进行了改进,并且研究用水中的甲醛标样来对检测过程进行质量控制,结果较好.     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.