城市水循环中的微量污染物负荷

污水中不同的有机化合物,例如,药物、个人护理产品中的添加物、家用化学物质和工业化学等物质都对水生生态系统和人类健康带来了潜在威胁.这些污染物质的大部分在环境中含量非常低,范围在pg/L至ng/L间,因此,被称为微量污染物.这些微量污染物质对水生生态系统和人类健康的威胁表现在内分泌干扰作用、化学敏感作用,污染混合物的交互作用以及长期暴露下的慢性作用.     

长期暴露于全氟十三酸的青鳉鱼体内分布和生物富集

研究了将青鳉鱼长期暴露于不同浓度的全氟羧酸类物质全氟十三酸(PFTriDA)后的器官分布和富集系数.结果显示, PFTriDA最高富集在性腺;其次是卵、肝脏;浓度最低的部分是残体.除了性腺之外,该器官分布与野生中华鲟的一致.在相同暴露浓度下,雄鱼体内各器官的PFTriDA的含量高于雌鱼,机理模型计算进一步表明高母子传递系数是造成雌雄差异的可能原因.随着PFTriDA暴露浓度的升高,鱼体内同一器官的生物富集系数(BCF)呈现下降趋势.     

赤水河流域生物多样性保护现状和对策

基于对赤水河流域生物多样性的综合调研,分析了赤水河流域生物多样性的主要特征、流域生物多样性保护的现状、面临的机遇和潜在的压力,探讨了赤水河流域生物多样性保护的基本对策。提出赤水河流域生物多样性保护应在国家政策框架内,在流域综合管理理念指导下兼顾重点区域保护和生态廊道建设,探索流域尺度上生物多样性保护与流域社会经济协调有序发展的新型管理模式。     

碳源变化对降解2,4-D的好氧颗粒污泥性能及形态的影响

在长期运行的序批式生物反应器(SBR)中,考察了以葡萄糖和2,4-二氯苯氧乙酸(2,4-D)为混合碳源培养的好氧颗粒污泥在转换为2,4-D唯一碳源废水后,其形态、结构及对目标污染物去除功能的变化.结果表明,基质转换为2,4-D单一碳源后,好氧颗粒污泥仍保持了对目标污染物高效的去除能力.当进水2,4-D浓度为361～564mg/L,其去除率为99.2%～100%,COD平均去除率达到85.6%.混合碳源向2,4-D单一碳源转换对原好氧颗粒结构产生一定破坏作用,使其发生部分解体,粒径由513μm下降到302μm.但好氧颗粒污泥良好的耐负荷冲击使其保持了颗粒主体,通过一段时间适应调整后能够重新聚集生长,最终获得能够利用2,4-D为唯一碳源生长并具有良好沉降性(SVI20～40mL/g)的好氧颗粒污泥,粒径为489μm.扫描电子显微镜(SEM)观察结果表明,混合碳源转向单一碳源使好氧颗粒生物相丰富度降低.     

生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

垃圾渗滤液的膜生物反应器与传统生物工艺述评

采用文献调研法比较评价了膜生物反应器与传统生物工艺对垃圾渗滤液的处理效果。结果表明,渗滤液的水质特征(主要指COD)主要由渗滤液年龄决定,B/C值和渗滤液年龄对COD去除有重要影响。传统生物处理常采用多级组合工艺,渗滤液特性、工艺单元数、水力停留时间和有机负荷率等是影响COD去除的重要参数。近年来,MBR工艺的应用日益广泛,对于B/C值较低的老龄渗滤液,MBR工艺可获得更好的COD去除效果,也有利于废水的膜深度处理。     

焦化废水处理工程调试运行研究

针对焦化废水处理调试运行存在的问题,以实际运行中的焦化废水处理工程为例,介绍了其调试运行过程.指出焦化废水调试及稳定运行的控制要点,并提出调试运行过程中可能出现的问题及解决措施,为同类废水的调试和运行提供参考.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Remediation of copper polluted red soils with clay materials

Attapulgite and montmorillonite were utilized to remediate heavy metal polluted red soils in Guixi City, Jiangxi Province, China. The e ects of clay minerals on availability, chemical distribution, and biotoxicity of Cu and Zn were evaluated. The results provided a reference for the rational application of clay materials to remediate heavy metal contaminated soils. From the sorption experiment, the maximum adsorbed Cu2+ by attapulgite and montmorillonite was 1501 and 3741 mg/kg, respectively. After polluted red soil was amended with attapulgite or montmorillonite and cultured at 30 and 60 days, soil pH increased significantly compared to the control. An 8% increase in the amount of montmorillonite in soil and 30 days incubation decreased acid exchangeable Cu by 24.7% compared to the control red soil. Acid exchangeable Cu decreased with increasing amounts of attapulgite and montmorillonite, with best remediation e ect reached at a dose of 8%. Results also showed that the Cu poisoning e ect on earthworms was reduced with the addition of attapulgite and montmorillonite. Montmorillonite showed the best e ect, with the addition of a 2% dose the mortality of earthworms decreased from 60% to zero compared to the control. Our results indicated that the bioavailability of Cu in soils was reduced more e ectively with the application of montmorillonite than attapulgite.     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.