亚热带稻田生态系统CO2通量的季节变化特征

为估算和评价稻田生态系统碳源/汇强度及其对大气CO₂浓度变化的贡献,研究了稻田生态系统与大气间CO₂交换通量的季节变化特征及其影响因素.采用涡度相关技术对我国亚热带稻田生态系统CO₂交换通量进行了连续监测,在数据剔除、校正和差补的基础上,对瞬时CO₂通量值进行计算求得日CO₂通量值和年CO₂通量值,并对CO₂通量季节变化及其与主要气象因子的关系进行了探讨.结果表明,稻田生态系统光合吸收CO₂通量（GPP）、呼吸排放CO₂通量（R_eco）和净吸收CO₂通量（NEE）的季节变化均呈6～9月较高,1～5月和10～12月较低的对称分布.其中5～9月水稻生长时期的NEE总量占年总量的80%以上,对年NEE总量起决定性作用.光合有效辐射（PAR）和日平均气温（T_a）是GPP与NEE季节变化的最主要影响因子,二者与GPP和NEE分别存在显著的二元线性关系.年净吸收CO₂总量为2?475.6 g/(m²·a),这表明我国亚热带稻田生态系统是大气CO₂的汇.     

应用质子变化滴定测量法监测氨氧化的化学计量关系

开发了一套监测批式废水生物处理系统质子变化的自动滴定测量装置.装置由批式反应器、数据自动采集与保存系统和药品自动投加系统组成.通过实际测量活性污泥氨氧化反应中氢离子产生量与氨消耗量的化学计量比值,考察自动滴定测量装置的测试精度.在1L的反应器中改变氨氮浓度(以N计)分别为1.67、3.33、8.33、16.66和30.00mg/L下实测比值与其理论值十分接近,相对误差在2.09%～6.34%之间;保持氨氮浓度16.66mg/L,在1、2、3和4L的反应器中实测比值相对误差在2.09%～-18.57%之间,随反应器体积增大而明显增大.反应器系统中的碳酸氢盐和氨盐缓冲体系,特别是在较大容积反应器中的滴定动态效应是导致测试误差的重要原因.研究成果为滴定测量方法在废水生物处理过程中监测质子变化提供了一种重要方法.     

重庆环境准入制度透视

2008年3月10日,重庆市政府印发了《重庆市工业项目环境准入规定》,标志着在全市正式建立了工业项目环境准入制度。3年多来,通过环境准入制度的严格实施,进一步规范了招商引资和建设项目的前期工作,促进了产业结构调整,优化了工业项目布局,提高了资源环境利用效率。3年多来,全市累计不予受理、不予审批不符合准入条     

从璧山之痛到“治污典范”——重庆璧南河治污攻坚战

14条受污染的次级河流肯定能治好,璧南河就是最好的例子!2010年9月29日,在全市主城区次级河流综合整治现场工作会上,璧南河污染治理经验被作为次级河流治污典范向全市推广。璧南河,璧山境内最大的次级河流,璧山的母亲河,主河道全长73千米,流域面积441平方千米,涉及璧山境内9个镇街,县域70%以上的经济总量分布在沿河流域。水黑如墨,臭不可闻,鱼虾绝迹曾经是其真实的写照,老百姓怨声载道。按照     

城市水循环中的微量污染物负荷

污水中不同的有机化合物,例如,药物、个人护理产品中的添加物、家用化学物质和工业化学等物质都对水生生态系统和人类健康带来了潜在威胁.这些污染物质的大部分在环境中含量非常低,范围在pg/L至ng/L间,因此,被称为微量污染物.这些微量污染物质对水生生态系统和人类健康的威胁表现在内分泌干扰作用、化学敏感作用,污染混合物的交互作用以及长期暴露下的慢性作用.     

基于部分湿式氧化法的污泥资源化研究

介绍了部分湿式氧化法的基本原理,指出COD去除率是判断是否部分湿式氧化的重要指标。用高压反应釜进行污泥处理,在一定的温度、压力和适合氧气量的条件下,考察了COD去除率、有机物降解率、pH值、过滤性能等随反应时间的变化。试验结果表明,通过控制反应时间,可以实现污泥的部分湿式氧化。考察了污泥经过部分湿式氧化后产物的性质,包括颗粒分布、有机物含量、养分含量和重金属等项目,分析结果表明,产物具有良好的资源化前景。     

微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.