2008年南黄海西部浒苔暴发区有机碳的分布特征及浮游植物的固碳强度

根据2008-08-09～2008-08-13在南黄海西部绿潮(浒苔)暴发区取得的溶解有机碳(DOC)、颗粒有机碳(POC)和颗粒氮(PN)的分析数据,结合同步获得的水文环境要素资料,研究了该区域有机碳的分布特征、来源、影响因素以及浮游植物的固碳强度.结果表明,DOC的浓度范围为1.55～3.22mg/L,平均值为2.44mg/L;POC的浓度范围为0.11～0.68mg/L,平均值为0.27mg/L.DOC与POC的分布特征基本一致,呈现近岸高,外海低;表层高,底层低的趋势.POC与TSS的相关分析表明,POC与TSS整体上呈显著正相关,表明TSS的浓度和来源是控制POC浓度高低的重要因素.通过建立POC与PN的一元线性回归模型,估算了样品中PIN的含量.扣除样品中PIN的影响后,沿岸大部分海域POC/PON的平均值8,结合POC/Chl-a比值,表明沿岸海域POC主要是海洋有机质来源,并且存在降解有机物,这可能是调查期间处于绿潮暴发后期,部分浒苔开始腐烂被降解所致.应用初级生产力估算的浮游植物固碳强度的结果表明,南黄海西部绿潮(浒苔)暴发区浮游植物的固碳强度变化范围为167～2017mg/(m2·d),平均为730mg/(m2·d),该区域日固碳量达到2.95×104t.换算至整个黄海,日固碳量为28.03×104t.     

1株脱氮除磷菌的筛选及其特性研究

采用YG培养基,结合蓝白斑筛选、异染粒染色及好氧除磷能力检测等实验,从城市生活污水处理厂好氧生化池的活性污泥中分离出7株好氧除磷菌;再经硝酸盐还原产气和缺氧培养实验,筛选出1株高效脱氮除磷菌;通过16S rRNA基因同源性比较和生理生化鉴定,初步将其鉴定为Pseudomonas grimontii,命名为C18.菌株C18在好氧培养24h后,培养基中上清液磷浓度从38.7mg/L降低到2.28mg/L,除磷率达94.1%.C18在缺氧培养24h后,培养基中上清液磷浓度从44.5mg/L降低到5.21mg/L,除磷率达88.3%;上清液硝酸盐氮浓度从184.2mg/L降低到30.6mg/L,脱氮率达83.4%.菌株C18最适脱氮除磷温度为30℃;最适脱氮除磷pH为7.5.     

酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

废弃线路板热解油中酚类物质的提取与分离

将FR-4型废弃线路板热解,并对热解油中含量最多的组分-酚类物质进行分离提取.比较研究线路板热解油的分离提取方法,探索出"碱液处理-酸化-萃取-减压蒸馏"的新方法,对分离出的组分进行GCMS(气质联用)测试.结果显示运用该方法对FR-4型线路板的热解油进行提取分离,得到的总酚占热解油的62.0%,其中苯酚的最高纯度可达...     

稀土磁盘水处理方案技术经济比较

文章针对日照钢铁集团公司2150热轧水处理工程浊环水处理方案选择,对传统沉淀过滤法和先进的稀土磁盘法进行了对比和分析,稀土磁盘法在效果、占地、投资和运行维护费用上有较多优势,最终选用该工艺。     

含固率和接种比对叶菜类蔬菜垃圾厌氧消化的影响

通过叶菜类蔬菜垃圾中温批式厌氧消化实验,比较了含固率(3%、5%、7%)和接种比(1.5、2.5、3.5)对产甲烷效果的联合影响.结果表明,在研究实验参数范围内,含固率越低、接种比越高,越有利于缩短产甲烷反应迟滞期,平均日产甲烷速率越快.经过52d的培养,在含固率为3%、接种比为3.5的工况中,平均日产甲烷速率最快,达到9.5mL/(gVS·d),日最大产甲烷速率最快,达到49.8mL/(gVS·d),最早进入快速产甲烷期.当接种比为3.5时,随着含固率的升高,产甲烷速率下降,迟滞期延长,但单位底物累计产甲烷量增大,含固率7%时单位底物累计净产甲烷量为481mL/gVS.而当接种比为1.5时,含固率为5%和7%的工况均无法启动甲烷化反应,含固率为3%的工况的产气迟滞期达15d.挥发性有机酸的累积抑制甲烷化反应的启动,迟滞期随着液相中有机酸浓度的增加而延长,当有机酸浓度低于1260mg/L,甲烷化反应没有明显的迟滞期.     

Potential bioremediation of mercury-contaminated substrate using filamentous fungi isolated from forest soil

The use of filamentous fungi in bioremediation of heavy metal contamination has been developed recently. This research aims to observe the capability of filamentous fungi isolated from forest soil for bioremediation of mercury contamination in a substrate. Six fungal strains were selected based on their capability to grow in 25 mg/L Hg2+-contaminated potato dextrose agar plates. Fungal strain KRP1 showed the highest ratio of growth diameter, 0.831, thus was chosen for further observation.Identification based on colony and cell morphology carried out by 18S rRNA analysis gave a 98%match to Aspergillus flavus strain KRP1. The fungal characteristics in mercury(Ⅱ) contamination such as range of optimum pH, optimum temperature and tolerance level were 5.5–7 and 25–35℃ and 100 mg/L respectively. The concentration of mercury in the media affected fungal growth during lag phases. The capability of the fungal strain to remove the mercury(Ⅱ) contaminant was evaluated in 100 mL sterile 10 mg/L Hg2+-contaminated potato dextrose broth media in 250 mL Erlenmeyer flasks inoculated with 108spore/mL fungal spore suspension and incubation at 30℃ for 7 days. The mercury(Ⅱ) utilization was observed for flasks shaken in a 130 r/min orbital shaker(shaken) and nonshaken flasks(static) treatments. Flasks containing contaminated media with no fungal spores were also provided as control. All treatments were done in triplicate. The strain was able to remove 97.50%and 98.73% mercury from shaken and static systems respectively. A. flavus strain KRP1 seems to have potential use in bioremediation of aqueous substrates containing mercury(Ⅱ) through a biosorption mechanism.     

硅胶表面壬基酚印迹材料的制备及其固相萃取应用

采用表面分子印迹技术,以壬基酚为模板分子,4-乙烯吡啶为功能单体,乙二醇二甲基丙烯酸酯为交联剂,通过溶胶凝胶法在无定型硅胶表面合成了壬基酚分子印迹聚合物。通过扫描电镜和红外光谱表征证明成功在硅胶表面合成了表面印迹聚合物。对印迹聚合物吸附性能考察的结果表明,该印迹聚合物对壬基酚仅15 min左右达到吸附平衡,去除率达75.13%,具有明显的快速吸附性和良好的选择吸附性。与C18柱相比,该分子印迹聚合物为填料的固相萃取柱对纺织品中的壬基酚具有显著的选择性分离和富集的能力,对壬基酚的加标回收率为86.4%~95.3%,相对标准偏差为2.8%~4.9%,表现出较高的回收率和准确性。     

环境样品中甲基汞测定方法的研究进展

甲基汞可通过血脑屏障引起中枢神经系统永久性损伤,毒性很强,因此环境样品中甲基汞的准确测定具有重要意义。文章对近年来环境样品中甲基汞的提取与富集技术及分析测定方法进行了归纳和总结。系统介绍了酸/碱提取、微波/超声辅助提取等样品前处理方法及其溶剂萃取等富集方法。通过比较分析,总结了不同环境样品适用的前处理方法。同时,对各色谱-质谱/光谱联用方法在甲基汞测定时的应用进行了归纳和比较。全自动形态汞/总汞分析仪(MERX)将环境样品中甲基汞的富集与分析有机结合,实现了环境样品中甲基汞的富集和分离与定量分析的一体化,提高了分析效率,是值得推荐的方法。