火灾下钢框架结构热-力耦合模拟与性能分析

基于"自然火灾安全概念"(NFSC)的基本思想,提出了火灾下钢结构热-力耦合模拟方法。利用ANSYS的参数化设计语言,建立了ANSYS软件与OZone火灾分析软件的数据接口,实现了火灾分析软件与大型有限元软件的耦合运用。基于火灾模拟软件OZone的分析结果,利用APDL语言,对钢框架结构进行了真实火灾场景下的热-力耦合模拟。研究表明:钢框架结构在真实火灾场景下,受非均匀变热流影响,结构内部将产生热应力梯度和应力牵移现象;同时钢框架中钢梁固接时,火灾初期变形较小,当达到某个关键时间点后将开始大的变形破坏,其主要原因是钢框架内部产生塑性铰,即钢梁由固接变为铰接,释放了对钢梁的约束。     

基于人体皮肤热模型的热防护服评价方法研究

在热防护服热防护性能测试装置基础上,用自行研制的新型耐高温模拟皮肤传感器代替铜片热流计测量通过应急热防护服装面料的热流量,将热流量作为热波皮肤模型边界条件,得到人体皮肤表层下80μm处的温度值,从而得到一定条件下人体真实皮肤达到二级烧伤所需时间,用其评价热防护服用织物的热防护性能,并将热波皮肤模型(TWMBT)的测试值与Pennes模型以及铜片热流计的测试结果进行分析比较。采用热波皮肤模型分析织物层下的"皮肤"防热时间更接近实际皮肤达到二级烧伤时间值,可较为精确的量化织物热防护性能,为应急救援热防护服装的热设计提供理论依据。     

亚热带稻田生态系统CO2通量的季节变化特征

为估算和评价稻田生态系统碳源/汇强度及其对大气CO₂浓度变化的贡献,研究了稻田生态系统与大气间CO₂交换通量的季节变化特征及其影响因素.采用涡度相关技术对我国亚热带稻田生态系统CO₂交换通量进行了连续监测,在数据剔除、校正和差补的基础上,对瞬时CO₂通量值进行计算求得日CO₂通量值和年CO₂通量值,并对CO₂通量季节变化及其与主要气象因子的关系进行了探讨.结果表明,稻田生态系统光合吸收CO₂通量（GPP）、呼吸排放CO₂通量（R_eco）和净吸收CO₂通量（NEE）的季节变化均呈6～9月较高,1～5月和10～12月较低的对称分布.其中5～9月水稻生长时期的NEE总量占年总量的80%以上,对年NEE总量起决定性作用.光合有效辐射（PAR）和日平均气温（T_a）是GPP与NEE季节变化的最主要影响因子,二者与GPP和NEE分别存在显著的二元线性关系.年净吸收CO₂总量为2?475.6 g/(m²·a),这表明我国亚热带稻田生态系统是大气CO₂的汇.     

基于部分湿式氧化法的污泥资源化研究

介绍了部分湿式氧化法的基本原理,指出COD去除率是判断是否部分湿式氧化的重要指标。用高压反应釜进行污泥处理,在一定的温度、压力和适合氧气量的条件下,考察了COD去除率、有机物降解率、pH值、过滤性能等随反应时间的变化。试验结果表明,通过控制反应时间,可以实现污泥的部分湿式氧化。考察了污泥经过部分湿式氧化后产物的性质,包括颗粒分布、有机物含量、养分含量和重金属等项目,分析结果表明,产物具有良好的资源化前景。     

微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

重金属离子快速检测技术研究与应用进展

在突发环境污染事件和区域生态风险筛查中迫切需要环境样品中重金属离子的快速检测技术手段。环境样品中重金属离子的快速检测技术有电化学方法和生物学方法。电化学检测方法主要是阳极溶出伏安法(AnodicStripping Voltammetry,ASV),可以同时检测多种重金属离子,有标准化认证的产品,但是检测成本相对较高。随着纳米粒子技术(Nanoparticles,NPs)和石英微天平分析技术(Quartz Crystal Microbalance,QCM)的引入,ASV法的检测成本将不断降低;生物检测方法包括免疫检测(Immunoassay,IA)和功能DNA(Functional DNA)检测技术。重金属离子的免疫检测技术样品通量大,检测成本低,已经广泛用于食品行业,其中汞离子的免疫检测方法已经成为环境样品标准检测方法之一。免疫检测传感器技术将拓展重金属离子的快速检测的应用空间。功能DNA传感器检测的研究为重金属离子的快速检测提供了新的技术手段,但是这些仅限于实验室研究,还没有达到实际应用的水平。     

ENN精粹

托特尼斯最具前瞻性的生态解决之道《观察家》2011年2月6日位于英格兰西南部的托特尼斯,为我们提出了可能是世界上最具前瞻性的生态解决之道。它是城镇转型运动的先锋实践者,推行本土化设计和城镇规模的运作模式,种植粮食与提高能源效率双管齐下,气候变化和石油峰值的问题在这里迎刃而解。