Feasibility of honeycomb monolith supported sugar catalyst to produce biodiesel from palm fatty acid distillate (PFAD)

Carbon coated monolith was prepared by sucrose solution 65 wt.% via dip-coating method. Sulfonation of incomplete carbonized carbon coated monolith was carried out in order to synthesize solid acid catalyst. The textural structure characteristics of the solid acid catalyst demonstrated a low surface area and pore volume. Palm fatty acid distillate (PFAD), a by-product of palm oil refineries, was utilized as oil source in biodiesel production. The esterification reaction subjected to different reaction conditions was performed by using the sulfonated carbon coated monolith as heterogeneous catalyst. The sulfonation process had been performed by using vapour of concentrated H₂SO₄ that was much easier and efficient than liquid phase sulfonation. Total acidity value of carbon coated monolith was measured for unsulfonated sample (0.5 mmol/g) and sulfonated sample (4.2 mmol/g). The effect of methanol/oil ratio, catalyst amount and reaction time were examined. The maximum methyl ester content was 89% at the optimum condition, i.e. methanol/oil molar ratio (15:1), catalyst amount (2.5 wt.% with respect to PFAD), reaction time (240 min) and temperature 80 °C. The sugar catalyst supported on the honeycomb monolith showed comparable reactivity compared with the sugar catalyst powder. However, the catalyst reusability studies showed decrease in FFA% conversion from 95.3% to 68.8% after four cycles as well as the total acidity of catalyst dropped from the value 4.2 to 3.1 mmol/g during these cycles. This might be likely due to the leaching out of SO₃H group from the sulfonated carbon coated monolith surface. The leaching of active species reached a plateau state after fourth cycle.     

基于N，N─二甲基苯胺与NO_2~－─对氨基苯磺酸重氮盐的偶联反应示波极谱法测定NO_2~－

报道了利用Ｎ，Ｎ─二甲基苯胺为偶联试剂的Ｃｒｉｅｓｓ反应以示波极谱法测定ＮＯ_２~－的测试方法。在拟定的实验条件下，ＮＯ_２~－在４．０×１０~－３～４．８×１０~－１μｇ／ｍｌ范围内与极谱波波高呈良好的线性关系。环境水测定的相对标准偏差小于ｌ％，回收率在９７％～１０１％之间。     

从自燃煤矸石中提取聚合铝铁(PAFC)的试验研究

采用盐酸酸浸的方法从自燃煤矸石中提取聚合铝铁，对煤矸石的粉碎粒径、酸浸盐酸的浓度及用量、酸浸的温度等工艺条件进行了试验研究。结果表明，从100g自燃煤矸石中，可提取19．85g固体聚合铝铁，成品的Al2O3含量33％、Fe2O3含量16％、盐基度70％。     

Evaluation of the biodegradability of copolyesters containing aromatic compounds by investigations of model oligomers

Model oligo esters of terephthalic acid with 1,2-ethanediol, 1,3-propanediol, and 1,4-butanediol have been investigated with regard to their biodegradability in different biological environments. Well-characterized oligomers with weight-average molar masses of from 600 to 2600 g/mol exhibit biodegradation in aqueous systems, soil, and compost at 60°C. SEC investigations showed a fast biological degradation of the oligomer fraction consisting of 1 or 2 repeating units, independent of the diol component used for polycondensation, while polyester oligomers with degrees of polymerization higher than 2 were stable against microbial attack at room temperature in a time frame of 2 months. At 60°C in a compost environment chemical hydrolysis also degrades chains longer than two repeating units, resulting in enhanced degradability of the oligomers. Metabolization of the monomers and the dimers as well by the microorganisms could be confirmed by comparing SEC measurements and carbon balances in a Sturm test experiment. Based on these results degradation characteristics of potential oligomer intermediates resulting from a primary chain scission from copolyesters consisting of aromatic and aliphatic dicarbonic acids can be predicted depending on their composition. These results will have an evident influence on the evaluation of the biodegradability of commercially interesting copolyesters and lead to new ways of tailor-made designing of new biodegradable materials as well.     

Enzymatic degradation of poly([R,S] β-hydroxybutyrate)

The synthetic analogue of a bacterially produced polyester, poly(-hydroxybutyrate) (PHB) was synthesized from racemic -butyrolactone using anin situ trimethyl aluminum-water catalyst. The polymer was fractionated into samples differing in molecular weight and isotactic diad content. The latter was closely related to degree of crystallinity. The biodegradation of these fractions were examined by monitoring mass loss over time in the presence of anAlcaligenes faecalis T1 extracellular bacterial poly(-hydroxybutyrate) depolymerase. The fraction with high isotactic diad tacticity content showed little or no degradation over a 50 hour incubation period, whereas the fraction of intermediate isotactic diad content degraded in a continuous steady fashion at a rate that was less than that for bacterial PHB. The low isotactic diad fraction underwent a rapid initial degradation, followed by no further mass loss. The presence of stereoblocks in the polymer structure of the various fractions was an influence on the degree of susceptibility towards degradation and is related to sample crystallinity.     

ClO2处理含铁,锰及细菌饮用水的应用研究

为了除去水中高含量的铁，锰及细菌，采用ＣｌＯ２氧化Ｆｅ＾２＋，Ｍｎ＾２＋和灭菌的方法。研究结果表明，处理后水平铁，锰都末检出，细菌指标符合国家饮用水标准。此法具有工艺简单，操作方便，反应速度快，去除率极高，不产生致癌物质ＴＨＭ、且能很好地除水中的异味及色度等优点。此法适用于各种生活给水系统。     

二氧化硫排放总量控制若干问题的思考

根据国家《“十一五”规划纲要》对削减二氧化硫排放总量的要求，在对电力行业脱硫现状及前景的具体阐述中指出实现这个目标的可能性，并从多方面对二氧化硫总量控制的关键问题进行了详尽的论述与分析。     

南昌市环境空气质量分析和控制

利用多年的环境监测数据,分析南昌市环境空气中主要污染物尘类、二氧化硫和氮氧化物产生的原因,并提出有效控制上述污染物的具体措施。     

Mechanical and Barrier Properties of Biodegradable Films Made from Chitosan and Poly (Lactic Acid) Blends

Biodegradable film blends of chitosan with poly(lactic acid) (PLA) were prepared by solution mixing and film casting. The main goal of these blends is to improve the water vapor barrier of chitosan by blending it with a hydrophobic biodegradable polymer from renewable resources. Mechanical properties of obtained films were assessed by tensile test. Thermal properties, water barrier properties, and water sensitivity were studied by differential scanning calorimeter analysis, water vapor permeability measurements, and surface-angle contact tests, respectively. The incorporation of PLA to chitosan improved the water barrier properties and decreased the water sensitivity of chitosan film. However, the tensile strength and elastic modulus of chitosan decreased with the addition of PLA. Mechanical and thermal properties revealed that chitosan and PLA blends are incompatible, consistent with the results of Fourier transform infrared (FTIR) analysis that showed the absence of specific interaction between chitosan and PLA.     

金沙江对硫酸的缓冲性能分析

本文分析了金沙江对硫酸的缓冲特征，建立了江水的缓冲曲线方程，并且验证了此方程的有效性，证明用此方程预测硫酸进入金沙江后江水pH值的变化情况，其预测准确度在0.2个pH单位内。