生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

Factors affecting the direct mineralization of CO2 with olivine

Olivine, one of the most abundant minerals existing in nature, is explored as a CO2 carbonation agent for direct carbonation of CO2 in flue gas. Olivine based CO2 capture is thermodynamically favorable and can form a stable carbonate for long-term storage. Experimental results have shown that water vapor plays an important role in improving CO2 carbonation rate and capacities. Other operation conditions including reaction temperature, initial CO2 concentration, residence time corresponding to the flow rate of CO2 gas stream, and water vapor concentration also considerably affect the performance of the technology.     

Silver impregnated carbon for adsorption and desorption of elemental mercury vapors

The Hg0 vapor adsorption experimental results on a novel sorbent obtained by impregnating a commercially available activated carbon (Darco G60 from BDH) with silver nitrate were reported. The study was performed by using a fundamental approach, in an apparatus at laboratory scale in which a synthetic flue gas, formed by Hg0 vapors in a nitrogen gas stream, at a given temperature and mercury concentration, was flowed through a fixed bed of adsorbent material. Breakthrough curves and adsorption isotherms were obtained for bed temperatures of 90, 120 and 150°C and for Hg0 concentrations in the gas varying in the range of 0.8–5.0 mg/m3. The experimental gas-solid equilibrium data were used to evaluate the Langmuir parameters and the heat of adsorption. The experimental results showed that silver impregnated carbon was very effective to capture elemental mercury and the amount of mercury adsorbed by the carbon decreased as the bed temperature increased. In addition, to evaluate the possibility of adsorbent recovery, desorption was also studied. Desorption runs showed that both the adsorbing material and the mercury could be easily recovered, since at the end of desorption the residue on solid was almost negligible. The material balance on mercury and the constitutive equations of the adsorption phenomenon were integrated, leading to the evaluation of only one kinetic parameter which fits well both the experimentally determined breakthrough and desorption curves.     

有机质对土壤气相抽提去除四氯化碳效率的影响

某重要岩溶地下水源地因附近农药厂排放含四氯化碳污水而受到严重污染,实验采用土柱通风试验模拟土壤气相抽提(SVE),研究环境温度为20℃,通风速率为40mL/min,土壤含水率10%,而土壤有机质含量分别为3.02%和0.13%条件下的两种供试土壤中四氯化碳污染物的去除过程.结果表明,土柱通风能有效去除土壤中的四氯化碳污...     

电厂二氧化碳捕捉技术对比研究

由于全球温室效应的不断加剧,发展二氧化碳捕捉技术变得十分必要.通过分析燃烧前捕捉、燃烧后捕捉和富氧燃烧捕捉三种二氧化碳捕捉方式流程及其特点,指出三种不同的二氧化碳捕捉技术的发展现状以及应用途径.通过具体对比现有二氧化碳捕捉技术的工作原理以及优缺点,针对现有的几种具体的二氧化碳捕捉技术进行详细的分析,积极应用各种物理、化...     

福建省能源消费碳排放和低碳能源发展研究

能源消费导致的碳排放对全球气候变化带来严峻挑战.区域经济迅速发展,不但对区域能源安全提出挑战,也对碳减排提出新的课题.文章总结了改革开放以来福建省能源消费的特点和趋势,计算由能源消费引起的碳排放量.研究表明,虽然碳强度有显著下降,但是碳排放总量增长比较明显,特别是从2000年开始,增长幅度加大.利用Kaya恒等式对碳排...     

淀山湖沉积物碳-氮垂直分布特征

近年来,经过一系列污染治理措施,淀山湖的营养水平持续下降,但每年仍有不同程度的蓝藻水华暴发,严重影响其作为水源地的安全性。为了进一步探讨淀山湖水质改善策略,本研究对淀山湖沉积物营养状况进行了调查研究,分析了淀山湖沉积物碳、氮分布特征及垂直变化规律,并用沉积物肥力评价了淀山湖沉积物营养程度。结果表明,淀山湖沉积物营养盐存在明显的富集作用,二十多年来沉积物碳、氮含量大幅上升,表层沉积物均属于重污染状态。空间分布上,沉积物营养盐北部高,南部低,北部样点大部分属于重污染状态,南部样点基本属于中污染状态。垂直分布上,受航道回淤与北部围网养殖影响,部分样点营养盐垂直分布规律不显著,其他样点均表现出随深度增加营养盐显著降低的趋势。除出水口D1样点外,淀山湖有机质与TN表现出显著的同源相关性,表明有机质是淀山湖内源负荷的主要来源。     

活性污泥吸附絮凝中纤板废水的研究

利用实验室培养的活性污泥吸附絮凝预处理中纤板废水中的悬浮物和有机物。研究结果表明,当污泥投加量为6~9 g/L,废水pH值为6,吸附絮凝时间为30 min,沉淀时间为30 min时,处理效果最好,对废水中SS,COD和SCOD的去除率分别为29%,24%和17%左右。该方法为含高悬浮物、高有机物工业废水的预处理开辟了新途径。     

Inhibitory effects of nisin-coated multi-walled carbon nanotube sheet on biofilm formation from Bacillus anthracis spores

Multi-walled carbon nanotube（MWCNT） sheet was fabricated from a drawable MWCNT forest and then deposited on poly（methyl methacrylate） film. The film was further coated with a natural antimicrobial peptide nisin. We studied the effects of nisin coating on the attachment of Bacillus anthracis spores, the germination of attached spores, and the subsequent biofilm formation from attached spores. It was found that the strong adsorptivity and the super hydrophobicity of MWCNTs provided an ideal platform for nisin coating. Nisin coating on MWCNT sheets decreased surface hydrophobicity, reduced spore attachment, and reduced the germination of attached spores by 3.5 fold, and further inhibited the subsequent biofilm formation by 94.6% compared to that on uncoated MWCNT sheet. Nisin also changed the morphology of vegetative cells in the formed biofilm.The results of this study demonstrated that the anti-adhesion and antimicrobial effect of nisin in combination with the physical properties of carbon nanotubes had the potential in producing effective anti-biofilm formation surfaces.