The key elements analysis of Guangdong & Shenzhen ETS & tips for China national ETS construction

The only joint effort area of provincial and municipal governments resides in Guangdong Province and Shenzhen City in China’s carbon emission trading system (ETS) pilots, which characterize the national carbon ETS plots. The present study on the operating experience from this area has important reference value for the national carbon ETS. Analysis and comparison of the key elements show many differences in coverage, total allowance, allowance allocation, and MRV mechanism between Guangdong and Shenzhen carbon ETS. The present study provides the following explanation: (1) the design characteristics of carbon ETS (e.g. coverage, total quotas, the allocation, and MRV mechanism) depend on the local geographical conditions and policy goals. The differences of economic structure in Guangdong Province and Shenzhen City result in different coverage, which then result in differences in other management elements. (2) The operating state of the carbon market is affected by overall design of carbon ETS: in the case of tighter total allowance, lower proportion of China Certified Emission Reductions, and harsher punishment, the carbon market is relatively active, which intends to produce carbon financial market. Based on deep analysis of operation characteristics of carbon ETS in Guangdong and Shenzhen, the present study suggests that (1) the allowance should be allocated freely at the beginning stage and then gradually transited to the voluntary paid auction; (2) the allowances assigned to companies shall be linked up with their energy-saving objectives; (3) the output fluctuations and economic influence on the allowance allocation should be properly handled to maintain the fairness and consistence of allowance allocation standards; (4) stable public expectation is one of the key elements to maintain the regular operation of carbon ETS; (5) constrained carbon emission behavior outside ETS can contribute to social justice; and (6) the improvement of professional skills of relevant personnel in the enterprise and independent third party can enhance carbon emissions data reliability.     

不同类型填料的三维电极/Fenton试剂法处理苯酚废水

采用不同类型填料对三维电极/Fenton试剂法处理苯酚模拟废水进行研究.结果表明.不同类型活性炭填料对苯酚去除率有很大影响,粒炭不适合做粒子电极,采用5.0 mm柱炭处理效果较好;采用石英砂与活性炭混合填料的处理效果比单一活性炭填料好,但苯酚去除率提高不明显;电解槽反应器中按比例投加涂膜活性炭和活性炭混合填料能明显提高苯酚去除率;当涂膜活性炭与活性炭体积比为1,2时,苯酚去除率最高,达96.8%.     

Ultraviolet absorbance as a proxy for total dissolved mercury in streams

Stream water samples were collected over a range of hydrologic and seasonal conditions at three forested watersheds in the northeastern USA. Samples were analyzed for dissolved total mercury (THg_d), DOC concentration and DOC composition, and UV₂₅₄ absorbance across the three sites over different seasons and flow conditions. Pooling data from all sites, we found a strong positive correlation of THg_d to DOC (r² = 0.87), but progressively stronger correlations of THg_d with the hydrophobic acid fraction (HPOA) of DOC (r² = 0.91) and with UV₂₅₄ absorbance (r² = 0.92). The strength of the UV₂₅₄ absorbance-THg_d relationship suggests that optical properties associated with dissolved organic matter may be excellent proxies for THg_d concentration in these streams. Ease of sample collection and analysis, the potential application of in-situ optical sensors, and the possibility for intensive monitoring over the hydrograph make this an effective, inexpensive approach to estimate THg_d flux in drainage waters.     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维,即只浸渍不预氧化方法处理的AK1(activated kapok),先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水,AK-2具有苯酚最大吸附量(137.00 mg/g),AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时,在静态平衡实验中,更符合Freundlich吸附等温线;在动力学实验中,更符合准一级反应。吸附亚甲基蓝时,在静态平衡实验中,AK-1更符合Langmuir模型,AK-2 、AK-3更符合Freundlich吸附等温线;在动力学实验中,更符合准二级反应。     

污泥活性炭强化SBR法处理垃圾渗滤液的实验研究

为了进一步处理垃圾渗滤液,试验采用污泥活性炭强化序批式间歇反应器（SBR）法进行处理,通过对比普通SBR法试验,得出投加污泥活性炭强化SBR法处理垃圾渗滤液的效果要远远高于普通SBR法。当污泥活性炭的投加量为1.2 g/L,容积负荷为0.5～1.5 kg BOD₅/(m³·d)时,进水1 h,曝气10 h,沉淀1.5 h,闲置1.5 h,处理效果最好,COD的去除率达到了85%,NH³-N的去除率达到了90%。     

固定化假单胞菌降解油烟废气的研究

将从受油烟废气污染严重的土壤中分离筛选的具有较强降解油烟能力的假单胞菌利用活性炭为填料吸附固定后制成填料床生物反应器。实验考察了进气浓度、气体流量、气体停留时间、容积负荷等对油烟去除率的影响,初步研究了生物反应器的抗冲击能力。结果表明,活性炭填料对菌体具有良好的吸附能力,当油烟进气浓度小于100 mg/L,气体流速小于8 L/h,停留时间大于30 s,容积负荷为2.6～18.9 g油烟废气/(m³·h),生物反应器的降解效率可达到95%以上,且活性炭填料床反应器具有较强的抗冲击能力。     

Ru/γ-Al_2O_3和Ru/AC催化剂的制备及其对氨氧化反应的催化性能

分别以γ-Al_2O_3和活性炭(AC)为载体,采用浸渍法制备了Ru质量分数均为2.0%的Ru/γ-Al_2O_3和Ru/AC催化剂,并用X射线衍射仪和透射电子显微镜等方法对催化剂结构进行了表征.实验结果表明:Ru/AC中Ru沉积在AC表面,分散度较低;而Ru/γ-Al_2O_3中Ru进入到γ-Al_2O_3内部,形成了一种高度分散体系.Ru/γ-Al_2O_3对氨的催化活性高于Ru/AC,氨在Ru/γ-Al_2O_3和Ru/AC上的起活温度分别为200 ℃和266 ℃,T_(90)(氨去除率达90%时的反应温度)分别为267℃和320 ℃.随混合气体空速增大,Ru/γ-Al_2O_3催化剂的T_(90)逐渐升高,气体空速分别为3 600,4 800,5 400 h~(-1)时,T_(90)分别为235,266,303 ℃.随反应前混合气体中氨质量分数增加,氨的去除率降低.     

The accounting method and application of CO2 emissions responsibility by the electricity sector at the provincial level in China

When accounting the CO₂ emissions responsibility of the electricity sector at the provincial level in China,it is of great significance to consider the scope of both producers’ and the consumers’ responsibility,since this will promote fairness in defining emission responsibility and enhance cooperation in emission reduction among provinces.This paper proposes a new method for calculating carbon emissions from the power sector at the provincial level based on the shared responsibility principle and taking into account interregional power exchange.This method can not only be used to account the emission responsibility shared by both the electricity production side and the consumption side,but it is also applicable for calculating the corresponding emission responsibility undertaken by those provinces with net electricity outflow and inflow.This method has been used to account for the carbon emissions responsibilities of the power sector at the provincial level in China since 2011.The empirical results indicate that compared with the production-based accounting method,the carbon emissions of major power-generation provinces in China calculated by the shared responsibility accounting method are reduced by at least 10%,but those of other power-consumption provinces are increased by 20% or more.Secondly,based on the principle of shared responsibility accounting,Inner Mongolia has the highest carbon emissions from the power sector while Hainan has the lowest.Thirdly,four provinces,including Inner Mongolia,Shanxi,Hubei and Anhui,have the highest carbon emissions from net electricity outflow- 14 million t in 2011,accounting for 74.42% of total carbon emissions from net electricity outflow in China.Six provinces,including Hebei,Beijing,Guangdong,Liaoning,Shandong,and Jiangsu,have the highest carbon emissions from net electricity inflow- 11 million t in 2011,accounting for 71.44% of total carbon emissions from net electricity inflow in China.Lastly,this paper has estimated the emission factors of electricity consumption at the provincial level,which can avoid repeated calculations when accounting the emission responsibility of power consumption terminals（e.g.construction,automobile manufacturing and other industries）.In addition,these emission factors can also be used to account the emission responsibilities of provincial power grids.     

有机废气中VOC的回收方法

介绍了炭吸附法、冷凝法和膜分离法回胥机废报中ＶＯＤ的原理、工艺流程和工业应用情况，并对这些方法进行了比较，指出了适用范围。