四氮唑废水处理工艺设计

高浓度、高盐分的四氮唑生产废水通过三效蒸发浓缩,馏出液经铁炭氧微电解和混凝预处理,再采用水解酸化一接触氧化一反应二沉主体组合工艺进行处理。研究了该工艺所需构筑物和设备的设计与选型。该工艺在正常运行条件下,处理后出水pH6～9,COD 302mg／L,BOD5 108mg／L,SS30mg／L,色度36倍,水质达到GB8978--1996（污水综合排放标准》三级标准。     

Occurrence and migration of microplastics and plasticizers in different wastewater and sludge treatment units in municipal wastewater treatment plant

● Reduce the quantifying MPs time by using Nile red staining. ● The removal rate of MPs and PAEs in wastewater and sludge were investigated. ● MPs and PAEs were firstly analyzed during thermal hydrolysis treatment. ● The removal of PAEs from wastewater and sludge was mainly biodegradation. Microplastics (MPs) and plasticizers, such as phthalate esters (PAEs), were frequently detected in municipal wastewater treatment plants (MWTP). Previous research mainly studied the removal of MPs and PAEs in wastewater. However, the occurrence of MPs and PAEs in the sludge was generally ignored. To comprehensively investigate the occurrence and the migration behaviors of MPs and PAEs in MWTP, a series of representative parameters including the number, size, color, shape of MPs, and the concentrations of PAEs in wastewater and sludge were systematically investigated. In this study, the concentrations of MPs in the influent and effluent were 15.46±0.37 and 0.30±0.14 particles/L. The MP removal efficiency of 98.1% was achieved and about 73.8% of MPs were accumulated in the sludge in the MWTP. The numbers of MPs in the sludge before and after digestion were 4.40±0.14 and 0.31±0.01 particles/g (dry sludge), respectively. Fourier Transform Infrared Spectroscopy (ATR FT-IR) analysis showed that the main types of MPs were polyethylene terephthalate (PET), polypropylene (PP), polyethylene (PE), and polystyrene (PS). Six PAEs, including phthalate (DMP), diethyl phthalate (DEP), diisobutyl phthalate (DIBP), ortho dibutyl phthalate (DBP), butyl benzyl phthalate (BBP), and bis(2-ethyl) hexyl phthalate (DEHP), were detected in the MWTP. The concentrations of total PAEs (ΣPAEs) in the influent and effluent were 76.66 and 6.28 µg/L, respectively. The concentrations of ΣPAEs in the sludge before and after digestion were 152.64 and 31.70 µg/g, respectively. In the process of thermal hydrolysis, the number and size of MPs decreased accompanied by the increase of the plasticizer concentration.     

热水解超声组合预处理对污泥厌氧消化产气潜力的影响研究

针对城市污泥厌氧消化由于融胞困难所导致的消解速率低、产气量低等问题,采用热水解与超声组合的方法对污泥进行预处理,考察经预处理后污泥融胞效率的变化及对厌氧消化产气潜力的影响.结果显示,热水解与超声波组合工艺对污泥的破胞作用明显,在30 min热水解与0.53 W/mL超声声能密度组合工艺反应60 min条件下,相对于处理前污泥,预处理后污泥溶解性COD(SCOD)溶出率可提高41.6％,蛋白质增加值达282.7 mg/L,污泥厌氧消化的产气潜力显著增加;30 min热水解分别与0.53、0.33 W/mL超声声能密度组合工艺对污泥破胞效率的差异不大;随着超声时间的延长,在组合预处理工艺前20 min内SCOD的溶出速率较慢,20260 min时溶出速率逐渐提高.试验结果可为城市污泥厌氧消化预处理工艺的选择提供一定的理论依据.     

酸性条件下剩余污泥中Ca2＋和Mg2＋溶出对磷回收的影响

为了在酸性条件下实现剩余污泥中磷的高效回收,对pH=3时剩余污泥水解酸化过程中氨氮、正磷酸盐和钙镁离子的溶出现象以及磷回收进行了研究分析。结果表明：当pH=3时,所溶出的氨氮、镁离子和钙离子与磷酸盐的摩尔比均大于1,能满足采用鸟粪石沉淀法或者羟磷灰石沉淀法回收磷的要求;但所溶出的钙镁离子的摩尔比大于1,会对鸟粪石沉淀法回收磷的顺利进行有较大影响;有无外加镁剂对磷回收率影响不大。采用改型后的镁型强酸性阳离子交换树脂进行离子交换可以得到较高纯度的鸟粪石沉淀产品,通过XRD检测其纯度为95％以上。     

微生物-化学水解联合作用下烟嘧磺隆的降解

从被烟嘧磺隆污染的人工湿地土壤中分离出1株能够在葡萄糖存在下降解烟嘧磺隆的微生物,通过16S rDNA序列同源相似性分析,初步鉴定该微生物为Klebsiella sp..它能够以烟嘧磺隆为唯一氮源生长,其最适生长条件为:温度35℃,初始pH为中性偏酸.水解试验表明,烟嘧磺隆在中性和碱性条件下比较稳定,在酸性条件下水解较快.生物降解试验发现,当培养液中葡萄糖浓度为5 g.L-1时,在温度35℃、初始pH为7的条件下培养10 d后烟嘧磺隆有99.4%得到降解,同时溶液的pH从7.0降低至4.0;而降低葡萄糖浓度分别为500 mg.L-1和100 mg.L-1时,培养10 d后烟嘧磺隆的降解率仅为11.7%和6.6%,溶液的pH始终在7左右.进一步研究表明烟嘧磺隆的降解是由于微生物代谢葡萄糖产生了酸性环境,pH降低引起了烟嘧磺隆水解,菌种对烟嘧磺隆降解的实质是微生物-化学水解联合作用.     

季戊四醇废水处理方法的研究

采用水解酸化一序列式活性污泥法（HA－SBR法）相结合技术处理季戊四醇废水，试验结果表明：（进水CODCR为726－1800ml/L,出水CODCR小于100ml/L,CODCR去除率为88.1%-95.8%，出水能满足国家排放标准。     

高浓度阿维菌素生产废水治理与资源回收技术研究

采用预处理一厌氧水解－二段接触氧化工艺处理阿维菌素废水，在厌氧段停留时间为１０ｈ，好氧段停留时间为６ｈ条件下，厌氧好氧段ＣＯＤ总去除率达９１％，     

对胶状部分水解聚丙烯酰胺水解度测试方法的改进

以大量的实验数据为证 ,提出胶状部分水解聚丙烯酰胺水解度测试的改进方法及其实施步骤 ,与标准方法相比 ,所提方法简便、科学、实用。在胶状聚丙烯酰胺固含量及水解度分析测试中具有实际意义。     

提高污泥碱性发酵挥发酸积累的新方法

为了加大剩余污泥在碱性条件下的水解酸化程度,本研究尝试了两种新的能促进污泥碱性发酵产酸的方式,分别是向批式的污泥碱性发酵系统中投加未灭菌发酵污泥和投加灭菌发酵污泥,结合温度的影响(10℃和35℃)分别考察了这两种方式对污泥水解酸化效果的影响.结果表明,中温有利于水解酶和产酸菌作用的发挥,增大了污泥的水解酸化程度,体系内有明显的挥发酸(VFAs)积累.35℃条件下,两种方式都在很大程度上促进了新鲜污泥的水解酸化程度,经灭菌后的发酵污泥的投加较等量的未灭菌的发酵污泥的投加效果更为显著.前者的水解速率是后者的2倍,发酵末期酸积累量为后者的1.5倍,且前者在较长的发酵时间内VFAs含量维持恒定.分析两种方式能促进污泥水解酸化的原因得到:未灭菌发酵污泥的投加是向系统中引入了一定量的产酸菌,灭菌发酵污泥的投加引入了大量的较易水解的有机底物.水解产物的增加能在更大程度上影响产酸的效果.因此,中温条件下向污泥碱性发酵系统中投加经灭菌处理后的发酵污泥是提高剩余污泥发酵产酸量更为有效的方式.     

聚硅氯化铝混凝剂中Al(Ⅲ)水解聚合历程及铝硅作用特性研究

采用共聚与复合两种制备工艺，制备出了系列具有不同碱化度和不同Ａｌ／Ｓｉ摩尔比的聚硅氯化铝混凝剂，分析研究了ＰＡＳＣ中Ａｌ（Ⅲ）的水解－聚合历程以及聚硅酸与铝水解聚合产物的相互作用，探讨了ＰＡＳＣ溶液的酸解聚。