The recycling cycle of materials as a design project tool

Currently, a large number of companies consider recycling of materials as an opportunity to maximize profits and to reduce the environmental impact generated by these materials after they are disposed. However, there is also a strong constraint on the use of recycled materials mainly due to the lack of technical/scientific information, which would relate their physical properties to their recycling cycle. This information should be used in the initial phase of the product design to serve as reference for the simulation of a project to point out the physical properties obtained from recycling the Projected material (Pm). Thus, it would be possible to foresee some recycling strategy to keep the good characteristics of recycled materials by encouraging their use, regardless of the product to be designed.Therefore, the Recycling Cycle of Materials (RCM) is a tool that provides scientific/technical support in the selection of materials. It uses the information related to the physical properties of the Pm as a parameter for product design after five recycling cycles. For the case study, this tool has been applied to obtain the basic material of ABS/PC blend. Subsequently, this blend was evaluated using DSC, FTIR, traction and impact methods to obtain delimiting data for the definition of the mechanical properties resulting from the application of RCM.     

北京转河河岸带生态修复对河流水质的影响

以北京转河为例,探讨一系列河岸带生态修复措施(尤其是河漫地和护岸的改造)对河流水质的影响.于2009年7～9月进行实地调查,沿河岸选取13个采样点,并定期采集水样,测定其中营养物质和溶解氧(DO)等的浓度.结果表明,转河氨氮(NH4+-N)、硝氮(NO3--N)、总磷(TP)和DO的浓度均有非常明显的季节变化.在居民用...     

催化臭氧氧化过程中溴酸盐的生成机制研究

以黄河下游某水厂滤后水为目标物,选择了9种催化剂,在间歇反应装置中研究了单独臭氧和催化臭氧氧化过程中溴酸盐（BrO 3-）的生成情况,结果表明,在催化臭氧氧化过程中,NiO、CuO、Fe3O4、Al2O3加入使BrO 3-质量分数分别降低34.0%、32.8%、29.2%、20.8%.选取Fe3 O4作为催化剂研究催化...     

污泥与煤共热解制备吸附剂及其对活性艳红X-3B的吸附性能

以污水处理站脱水污泥和煤为原料共热解制备吸附剂,将其用于活性艳红X-3B模拟染料废水的吸附处理.考察了吸附时间,温度,pH及吸附剂投加量对吸附效果的影响,并对其吸附动力学和热力学特性进行了探讨.结果表明:所制备吸附剂的碘吸附值为321.62 mg/g,产率为44.85%,比表面积为189.23 m2>/sup>/g,浸出液中未检测出重金属;吸附剂对活性艳红X-3B的去除率随吸附时间、温度和吸附剂投加量的增加均增大,并逐渐趋于平衡,而随pH的增加而减小;吸附剂对活性艳红X-3B的吸附动力学比较符合伪二级吸附动力学方程和二阶段吸附动力学方程,颗粒内扩散过程是吸附速率的控制步骤,但不是唯一的速率控制步骤;Langmuir等温方程比Freundlich等温方程更适合于描述该吸附行为;吸附焓变(ΔH0>/sup>)>0,吸附是一个吸热过程,提高温度有利于吸附的进行,吸附自由能变(ΔG0>/sup>)<0,吸附过程为自发进行,吸附熵变(ΔS0>/sup>)>0.      

垃圾渗滤液除氨脱氮新工艺初探

通过对渗滤液经矿化垃圾回灌后水质特征的分析及现有除氨脱氮工艺用于渗滤液处理的可行性分析,提出了"多级低氧硝化反硝化+氨缺氧氧化"生物脱氮工艺流程,并阐述了其工艺的处理效果。得出结论:以渗滤液回灌处理出水作为研究对象,在不外加碳源条件下,该工艺可获得92%~99%的氨氮去除率,保证出水氨氮不高于25 mg/L,同时可获得73%~89%的总氮去除率。     

umu试验研究饮用水氯和氯胺消毒过程中遗传毒性的变化以及消毒条件的影响

采用umu遗传毒性测试方法考察了消毒剂投加量、反应时间和消毒剂氯氮比对某饮用水厂臭氧-生物活性炭出水加氯或氯胺消毒前后遗传毒性的影响.结果表明,炭后水具有一定的遗传毒性(20～70 ng/L),加氯或氯胺消毒后遗传毒性增加.反应时间为24 h,在相同投加量下氯消毒遗传毒性(40～95 ng/L)高于氯胺消毒遗传毒性(20～40 ng/L);当氯初始投加量从0 mg/L增加到10 mg/L时,炭后水的遗传毒性先迅速增加,在0.5～1 mg左右达到极大值,然后再降低,在3～5 mg左右达到极小值后缓慢上升,但是氯胺消毒后水样遗传毒性变化规律不如氯消毒的明显.当投加量为3 mg/L时,随着反应时间从0 h延长至72 h,无论是氯消毒还是氯胺消毒,炭后水遗传毒性均是先迅速增加,在2 h时达到极大值后再下降,在18 h左右达到极小值然后缓慢上升,而且任意反应时间内,氯胺消毒的遗传毒性(20～62 ng/L)均小于氯消毒(83～120 ng/L).本试验还研究了消毒剂氯氮比对炭后水氯消毒后遗传毒性的影响.在本试验条件下,从遗传毒性的角度看,对于饮用水消毒氯胺比氯更安全,而且2种消毒方式的遗传毒性的变化规律均不同于总HAAs的变化规律.     

铅在棉秆基活性炭上的吸附动力学与热力学

以棉秆与棉秆纤维为原料,利用磷酸活化法制备了低成本的高比表面微孔棉秆基活性炭,通过静态实验研究了活性炭对水溶液中铅的吸附特性,测定了溶液pH值、吸附时间、溶液温度对吸附的影响,探讨了吸附动力学、热力学及吸附机制.根据低温液氮(N2/77K)吸附测定数据,以BET方程、BJH法及H-K法对活性炭孔结构进行了表征,以Boehm滴定、FTIR、零电荷点pHPZC测定及元素分析定量表征活性炭表面含氧官能团.结果表明,以棉秆和棉秆纤维为原料制备的活性炭的比表面积分别为1570和1731m2·g-1,含氧酸官能团含量分别为1.43和0.83mmol·g-1,均高于商业活性炭ST1300.静态吸附实验表明,棉秆基活性炭对铅有较大的吸附容量和吸附效率,最大吸附量超过120mg·g-1,溶液pH对吸附有较大的影响,吸附量随时间增大而增大,在5min内可达饱和吸附量的80%;吸附动力学数据符合假二级方程,Freundlich方程能更好地描述等温吸附行为;热力学研究表明,吸附吉布斯自由能(ΔG0)0,而焓变(ΔH0)0,说明吸附为吸热的自发反应过程,升温有利于吸附,离子交换可能在吸附过程中起了重要作用.     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

应用δ~(13)C值探讨土壤中有机碳的迁移规律

C3 植物与C4 植物具明显的δ13C值差异 ,利用这种特性 ,选取荔波茂兰喀斯特森林边缘处这个C3植物—C4 植物转换生长的地点 ,分别采集森林与农田各三个剖面的土壤样品 ,根据测定其土壤总有机碳、不同粒径及不同比重组分的δ13C值间的相互关系来推导土壤有机碳的若干迁移规律     

济南市空气污染现状及控制对策

利用2013年1—12月济南市大气监测数据,分析该市空气质量现状及时空分布特征,结果表明:2013年济南市空气主要污染物质量浓度均超过《环境空气质量标准》(GB 3095—2012)二级标准限值,空气污染严重时段为冬季采暖期,颗粒物污染严重区域为该市西部和西北部地区,SO2、NO2污染严重区为中心城区,并从点源、面源和移动源3个方面提出相应的污染防治对策。在SO2、NOx和工业烟粉尘分别减排22.5%、18.2%和31.4%的条件下,运用Models-3/CMAQ模型模拟计算得出:2015年1月和7月,济南市空气中SO2、NO2、PM10和PM2.5的质量浓度与2010年同期相比将分别降低23.9%和29.7%、11.4%和15.9%、21.9%和32.6%、13.5%和26.9%,空气质量得到明显改善。