Fenton法和类Fenton法降解土壤中的二苯砷酸

本文对Fenton法与类Fenton法降解土壤中的二苯砷酸(diphenylarsinic acid,DPAA)进行了研究.考察了H2O2投加量和催化剂种类(Fe2+/Fe3+)对红壤及黑土中DPAA降解效果的影响,并采用高效液相色谱-质谱联用法(HPLC-MS/MS)对降解中间产物进行了初步鉴定.结果显示,针对红壤与黑土分别采用类Fenton法与Fenton法,在H2O2投加浓度为1 mol·L-1,含铁催化剂浓度为0.25 mol·L-1,土水比为1∶3,反应时间为1h的条件下,红壤及黑土中DPAA的降解率均可达到65%以上.HPLC-MS/MS的分析结果表明,DPAA可脱苯环形成降解产物苯砷酸(phenylarsinic acid,PAA),而PAA进一步氧化生成无机砷,这可能是Fenton/类Fenton法降解DPAA的途径之一.     

改进测定水中氨氮分子吸收光谱法的试验研究

水中氨氮含量是反应水质状况的重要指标。文章对测定水中氨氮气相分子吸收光谱法(标准号HJ/T195-2005)进行了改进试验研究。第一,对氧化剂的配比进行了改进,使氨氮的测定范围扩展至100μg。第二,对标准HJ/T195-2005中直接使用亚硝酸钠标准溶液做标准曲线的处理方式也做了探讨。通过一系列对比实验认为,应用硫酸铵标准溶液做工作曲线更加准确合理。最后应用改进后的气相分子吸收光谱法和纳氏比色法或滴定法对多种实际废水样品进行同时测定。结果表明,改进后的气相分子吸收光谱法测定氨氮的范围更宽,灵敏度更高和准确度更好。     

纳米Fe3O4/CeO2-H2O2非均相类Fenton体系对3,4-二氯三氟甲苯的降解

以浸渍法制备的新型纳米Fe3O4/Ce O2为催化剂,3,4-二氯三氟甲苯(3,4-DCBTE)为目标污染物,在Fe3O4/Ce O2-H2O2非均相类Fenton体系中对目标污染物的降解进行研究,考察催化剂的催化效果和温度、p H、H2O2投加量等因素对催化剂催化效果的影响.结果表明,以纳米Fe3O4/Ce O2作为催化剂的非均相类Fenton体系对3,4-二氯三氟甲苯的处理效果极佳;随着温度的升高,纳米Fe3O4/Ce O2的催化效果不断提高;在偏酸性环境中,p H越低催化效果越好,p H=2时反应去除效率可达96.67%;随着H2O2投加量的增加,3,4-二氯三氟甲苯的降解效率先提高后降低,投加量为15 mg·L-1时去除效果最好可达99.47%;随着催化剂投加量的增加,同样出现了处理效果先升高后降低的现象,投加量为0.5 g·L-1时催化效果最好可达99.64%.在以纳米Fe3O4/Ce O2为催化剂的非均相类Fenton体系中,3,4-二氯三氟甲苯的降解符合一级反应动力学,反应所需活化能较低只需30.26 k J·mol-1.     

生物沥浸耦合类Fenton氧化调理城市污泥

采用生物沥浸耦合类Fenton氧化工艺对城市污泥进行了调理研究.结果表明,在升华硫和Fe SO4·7H2O投量分别为3g·L-1和8 g·L-1时,污泥p H从6.9降至2.5约需1 d,满足类Fenton氧化的适宜酸性条件.生物沥浸处理后,污泥挥发性固体(VS)减少率为13.4%,污泥比阻从3.1×109s2·g-1降至1.5×109s2·g-1,降低51.6%,但仍属于难脱水污泥.沥浸污泥继续经类Fenton氧化调理,调理的最佳H2O2投量和反应时间分别为3.3 g·L-1和60 min.处理后污泥VS减少率为30.8%,污泥比阻和滤饼含水率分别为1.9×108s2·g-1和76.9%,污泥比阻降低93.9%,污泥脱水性能和稳定性能得到显著提高.此外,该联合工艺对污泥的调理效果优于类Fenton氧化单独调理.     

生物合成施氏矿物作为类芬顿反应催化剂降解甲基橙的研究

应用生物合成施氏矿物作为光助类芬顿反应催化剂促进甲基橙的降解.施氏矿物通过A.f-LX5细胞悬浮液在初始p H值2.5和28℃时氧化Fe SO43d生成,并进行X射线衍射和扫描电子显微镜表征.本研究分析了不同初始p H、H2O2浓度及催化剂装载量对在光助类芬顿反应中甲基橙氧化降解效率的影响.结果表明,生物合成施氏矿物具有较高的催化活性,并且通过羟基自由基机制使甲基橙降解.在近中性、较高Cl-、SO2-4及NO-3浓度条件下,施氏矿物仍然能保持较高催化甲基橙降解的效率.本研究验证了以生物合成施氏矿物作为催化剂的异相光助类芬顿反应是一种处理含甲基橙废水有应用前景的高级氧化技术.     

分光光度法测定染料废水中的对氨基酚

以由地洛试剂为氧化剂，用分光光度法测定染料废水中对氨基酚的含量，进行了波长，贝特洛试剂用量及显色时间等分析条件的选择。精密度和准确度实验结果表明，该准确，快速，可用于染料废水中对氨基酚的测定。     

Degradation of antipyrine in the Fenton-like process with a La-doped heterogeneous catalyst

A La-doped Co-Cu-Fe catalyst was synthesized for the antipyrine (ANT) removal. The La-doped catalyst had higher ANT removal than the control (95% vs. 54%). La reduced the particle size and increased the specific surface area of catalyst. The aim of this study was to synthesize a novel lanthanum (La) doped catalyst and to investigate antipyrine removal in wastewater using the Fenton-like process with the catalyst. The La-doped Co-Cu-Fe catalyst was synthesized using the modified hydrothermal method. Results showed that the La-doped catalyst had higher specific surface area and lower particle size than the catalyst without La doping (i.e., the control) (267 vs. 163 m²/g and 14 vs. 32 nm, respectively). Under the conditions of catalyst dosage 0.5 g/L, H₂O₂ concentration 1.70 g/L, and NaHCO₃ 0.1 g/L, the antipyrine removal within 60 min using the Fenton-like process with the La-doped catalyst was much higher than that with the control (95% vs. 54%). The hydroxyl radical concentration with the La-doped catalyst within 60 min was two times higher than that with the control (49.2 vs. 22.1 mg/L). The high catalytic activity of La-doped catalyst was mainly attributed to its high specific surface area based on the X-ray photoelectron spectroscopy result. Our La-doped catalyst should have great potential to remove antipyrine in wastewater using the heterogeneous Fenton-like process.     

Carbon nanotubes-incorporated MIL-88B-Fe as highly efficient Fenton-like catalyst for degradation of organic pollutants

CNTs were incorporated into MIL-88B-Fe to get a new Fenton-like catalyst (C@M). Fe(II) was introduced in C@M to get a fast initiation of Fenton-like reaction. Fe(II) content in C@M was related with oxygen-containing functional groups on CNTs. C@M shows efficient catalytic degradation of pollutants over a wide pH range. Iron-based metal organic frameworks have been verified to be efficient heterogeneous Fenton catalysts due to their open pore channels and highly uniform distribution of metallic centers. In these catalysts, however, the iron element is mainly in the form of Fe(III), which results in a process required to reduce Fe(III) to Fe(II) to initiate Fenton reaction. To address this problem, carbon nanotubes (CNTs) with electron-rich oxygen-functional groups on the surface were incorporated into the metal organic frameworks (MIL-88B-Fe) to improve Fe(II) content for an enhanced Fenton-like performance. The prepared CNT@MIL-88B-Fe (C@M) showed much stronger catalytic ability toward H₂O₂ than MIL-88B-Fe. The pseudo-first-order kinetic constant for phenol degradation by C@M (0.32 min^–1) was about 7 times that of MIL-88B-Fe, and even higher than or comparable to the values of reported heterogeneous Fenton-like catalysts. Moreover, the Fenton-like system could effectively degrade various kinds of refractory organic pollutants and exhibited excellent catalytic activity over a wide pH range (4–9). XPS analysis confirmed that Fe(II) content of the catalyst gradually increased with CNT loadings. Electron spin resonance analysis showed that the signal intensity (•OH) of C@M was much higher than MIL-88B-Fe, which was consistent with the degradation efficiency of pollutants. Furthermore, the Fe(II) content of the catalyst gradually increased along with the oxygen-functional group content of CNTs. The result demonstrated that oxygen-containing functional groups of CNTs have a significant impact on the enhanced catalytic performance of C@M. This study provides a new insight to enhance Fenton reaction by using nanocarbon materials.     

紫外-Fenton试剂的作用机理及在废水处理中的应用

本文研究了紫外光、铁离子对过氧化氢的催化分解作用.证实了紫外光和铁离子对过氧化氢的催化分解存在协同效应,并通过研究三价铁离子与紫外光的相互作用,探讨了协同效应产生的机理.UV-Fenton试剂对硝基苯、十二烷基苯磺酸钠(DBS)模拟废水的处理结果表明:将紫外光引入Fenton试剂可大大提高Fen-ton试剂的氧化性能,对生物难降解或难化学氧化的有机污染物具有良好的处理效果.     

酸性降水中甲醛的测定方法及其稳定性研究

本文研究了测定酸雨中游离甲醛和络合甲醛总量的方法，在液相中ＨＣＨＯ与Ｓ（Ⅳ）络合生成ＨＭＳＡ，通过加入Ｉ２丙酮溶液使甲醛游离出，再使用ＮａＳｈ试剂（乙酰丙酮和铵）在６０℃水浴中显色３０ｍｉｎ后在４１５ｎｍ光度测定，甲醛总量的检出率≥９７％。１９９２年夏季用该方法测定北京市雨水，其络合甲醛和游离甲醛各占５０％左右。测定甲醛总量时，雨样的最佳保护剂是ＮａＨＳＯ３。测定游离甲醛时，雨样的最佳保护剂是Ｈｇ