超高强度钻杆低温断裂性能及裂纹扩展特征研究

超高强度钻杆在冬季低温环境下容易发生脆性断裂事故,为了从断裂力学角度揭示其冷脆现象的本质,采用ZBC2302-D型示波冲击试验机,获得了不同温度下超高强度钢在冲击断裂过程中的力-位移曲线,并对比分析了冲击功、起裂功和裂纹扩展功之间的变化关系。采用国家标准GB 4161—2007中的计算公式,计算了冲击试样的裂纹扩展量Δa和阻抗应力强度因子K_R;同时,引入K_R阻力曲线,得到超高强度钻杆在不同温度下的剩余强度图。结果表明,当冲击试样开始出现裂纹时,随温度降低,钻杆的初始起裂应力有所增加,出现硬化现象。当钻杆出现一定长度的裂纹时,随温度降低,阻抗应力强度因子越来越小,而且降低速度越来越快,剩余强度也表现出相同的变化趋势。随温度降低,材料抵抗裂纹扩展的能力逐渐下降,表明钻杆在低温下更容易断裂。     

煤矿火灾烟气流动传播过程仿真研究

煤矿发生火灾后会生成大量有毒气体并产生火风压,烟气在火灾动力的影响下出现状态紊乱,研究煤矿火灾烟气流动传播过程对控制火情有着重要意义。基于国内外研究现状,对燃烧及风流特点进行分析,建立了煤矿火灾烟气流动数学模型,并利用CFD软件进行仿真。研究表明:无通风工况下的烟气为对称流动;随着风速增加,出口处温度降低,烟气向风流入口处的流速减小。     

Selective collection as a pretreatment for indirect solid recovered fuel generation

Effective selective collection (SC) has been increasing in many countries of the European Union. As a consequence the composition of residual municipal solid waste (RMSW) is changing not only because of economic development, but also due to the collection system. The input of RMSW treatment plants is thus not homogeneous. This paper analyses two case studies involving a total of five SC scenarios and their impact on the generation of solid recovered fuel (SRF) with/without bio-drying, post-treatment and packaging take back programs (TBPs). These case studies are based on two types of SC: kerbside and drop-off. The latest regulation on SRF classification is taken into account: energy content, Cl and Hg concentrations are assessed and discussed. The role of the respirometric index (RI) is also analyzed. Results show that when SC is highly efficient RMSW can be classified directly as SRF, but only if the introduction of RI does not set stringent respirometric targets. The role of packaging TBPs is important as the residual waste remaining after the packaging has been processed, can be valorized increasing the lower heating value (LHV) of the residual RMSW and minimizing the streams that should be landfilled. The source separation of food waste has a significant impact on the suitability of bio-drying: when the SC of food waste is very efficient, its percentage in the RMSW may be too low for effective bio-drying.     

氢安全研究现状及面临的挑战

氢能具有储运便捷、来源多样、洁净环保等突出优点,许多国家把发展氢能作为重要的能源战略。氢安全是氢能大规模商业化应用的重要保障。在分析国内外氢安全领域近年来最新研究进展的基础上,依次从氢泄漏与扩散、氢燃烧与爆炸、氢与金属材料相容性及氢风险评价等方面,系统总结了国内外氢安全研究面临的挑战,并对我国氢安全的发展提出了建议。     

Performance evaluation of reverse logistics enterprise – an agent-based simulation approach

Reverse logistics (RL) has been applied in many industries and sectors since its conception. Unlike forward logistics, retracing consumer goods from the point of consumption to the point of inception is not a well-studied process. It involves many uncertainties such as time, quality and quantity of returns. The returned products can be remanufactured, have parts harvested, or be disposed safely. It is important to implement these activities in a cost-effective manner. The aim of this research is to measure the performance of the RL enterprise with the help of an agent-based simulation model. The major entities in the RL network are considered as Agents that can act independently. There are several different agents: collector agent, sorting-cum-reuse agent, remanufacturing agent, recycler agent, supplier agent and distributor agent. The individual performances of the agents are measured and recommendations are given to improve their performance, leading to the enhancement of the total performance of the RL enterprise. The approach is applied to a case study involving cell phone remanufacturing.     

An investigation on the fuel savings potential of hybrid hydraulic refuse collection vehicles

Refuse trucks play an important role in the waste collection process. Due to their typical driving cycle, these vehicles are characterized by large fuel consumption, which strongly affects the overall waste disposal costs. Hybrid hydraulic refuse vehicles offer an interesting alternative to conventional diesel trucks, because they are able to recuperate, store and reuse braking energy. However, the expected fuel savings can vary strongly depending on the driving cycle and the operational mode. Therefore, in order to assess the possible fuel savings, a typical driving cycle was measured in a conventional vehicle run by the waste authority of the City of Stuttgart, and a dynamical model of the considered vehicle was built up. Based on the measured driving cycle and the vehicle model including the hybrid powertrain components, simulations for both the conventional and the hybrid vehicle were performed. Fuel consumption results that indicate savings of about 20% are presented and analyzed in order to evaluate the benefit of hybrid hydraulic vehicles used for refuse collection.     

经口摄入土壤多溴联苯醚生物可给性变化及影响因素的体外消化模拟

误食土壤是污染物(如多溴联苯醚)人体(主要是儿童)暴露的重要途径,人体消化道内污染物吸收的生物可给性是针对此种暴露方式进行定量风险评估的有效途径之一.本研究采用体外消化实验模拟3种不同有机碳含量的天然土壤中典型多溴联苯醚(BDE-28、BDE-47、BDE-99和BDE-153)在胃和小肠消化液中的释放,验证部分消化释放的多溴联苯醚因消化残留固相表面的再吸附造成低估实际生物可给性,并通过不同水土比的拟合计算予以校正.结果表明,校正后的消化率普遍高于校正前;就不同土样而言,BDE-28、BDE-47、BDE-99和BDE-153在不同初始暴露浓度条件下平均提升比例范围分别为14.3%~42.3%、11.1%~32.1%、4.9%~12.3%和0.0%~7.7%.因此,未经校正的消化率会显著低估PBDEs消化道内的生物可给性,尤其是低溴代组分及PBDEs初始浓度较高或高TOC含量的土样.校正后BDE-28、BDE-47、BDE-99和BDE-153的消化率分别维持在21.9%~54.7%、18.8%~43.1%、13.4%~27.2%和9.3%~19.9%.此外,PBDEs的消化率与其辛醇-水分配系数的对数lg KOW呈显著负相关;而与土壤TOC含量及PBDEs初始暴露浓度的相关性并不显著,尤其是高溴代组分.     

Mitigation of eutrophication caused by wastewater discharge: A simulation-based approach

Mitigation of eutrophication, intensified by excessive nutrient load discharge in wastewaters regulated by restrictive legal requirements, remains one of today’s most important global problems. Despite implementation of the Water Framework Directive, the Urban Wastewater Directive and the HELCOM recommendations, the actual condition of surface water is still not satisfactory. In response to the above, the study presents an alternative approach for surface water protection against eutrophication based on the selection of appropriate nutrient removal technologies. An activated sludge model simulation was used to enable the identification of environmentally justified nutrient removal systems with lowest eutrophication potential of treated wastewater conditioned by bioavailable nutrient forms content. Based on the outcome of the study, the 3-stage Bardenpho system was identified as the most efficient for bioavailable phosphorus removal, while the Johannesburg system proved to have the highest efficiency for bioavailable nitrogen removal. The proposed eutrophication mitigation approach underlines the need for a reconsideration of current legal regulations which ignore nutrient bioavailability and key eutrophication limiting factors.     

坡岸截留强化处理设施在不同运行条件下对农业面源污染物去除效果

对坡岸截留强化处理设施在不同温度、不同雨强、不同降雨间隔条件下处理农业面源污染进行中试试验研究.结果表明,水温从20℃下降至4.3℃,COD、TN、NH+4-N、TP去除率下降了15.58%、48.93%、42.26%、57.75%;降雨强度由0.65mm·min-1增加1倍至1.30 mm·min-1,COD的平均去除率低了15.19%,TN、NH+4-N的去除效率相当,TP的去除效率提高了11.21%,但COD、TN、NH+4-N、TP单位面积去除的总量却提高了26.27%、68.3%、32.6%、104.2%;降雨间隔从2 d增加到4 d时对COD去除的影响不大,但使NH+4-N、TN的处理效率提高19.31%、13.95%,对TP的单位面积去除量提高71.43%,但去除总量有限.     

燃煤电厂烟塔合一排烟风洞试验与数值模拟对比分析

近年来,燃煤电厂烟塔合一烟气排烟对近距离环境影响的不确定性,使其在国内的推广过程受到一定限制。准确判断烟塔合一排烟的环境影响,对于我国现有燃煤电厂烟气污染物的排放有着巨大的工程价值和明显的现实意义。利用国家环境保护某重点实验室中风洞试验平台,对燃煤电厂烟塔合一烟气污染物在近距离的扩散和传输行为,进行物理风洞试验以及数值模拟计算,并进行对比分析。结果表明:德国Austal2000模式的浓度预测并不精确;数值风洞也有其差异性,而物理风洞的结果在很大程度上符合现有的理论及国内工程实际。