Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

NaOH预处理对稻草秸秆厌氧消化的影响

通过调控稻草秸秆预处理过程中的NaOH比例,以期提高厌氧消化的产气量及产气效率。试验结果表明,经NaOH处理过的稻草秸秆半纤维素、木质素含量有显著降低,产气量较对照组有明显增加,发酵时间有所缩短。其中NaOH质量百分数为6%的处理组产气率最高,为312mL/g(干物质);VS/TS去除率也最高,为53.8%/36.8%;累计产气量最高,发酵过程中甲烷体积分数最高37.7%。故采用质量百分数为6%的NaOH的预处理是最佳方式。     

泥炭腐殖化度的测定方法研究

泥炭腐殖化度能反映沉积物中泥炭的分解程度,常被用作恢复古气候与环境的代用指标。本文对当前泥炭腐殖化度的5种测定方法:化学计算法、碱提取溶液吸光度法、经验公式法、标准曲线计算法和灰度度量法进行了系统分析和比较,重点介绍了碱提取溶液吸光度法,并依据哈尼地区的泥炭数据,对碱提取溶液吸光度法测定泥炭腐殖化度的可行性和可靠性进行了检验。     

天津市夏季蜂窝状溶蚀器涂层溶液浓度确定的实验研究

于2013年7月1日～8月31日,在天津市南开大学理化楼楼顶,采用蜂窝状溶蚀器进行了溶蚀器涂层溶液最适浓度的探究实验.结果表明,在天津夏季,蜂窝状溶蚀器的碳酸钠涂层溶液最适浓度为3%,柠檬酸涂层溶液最适浓度为6%.含有溶蚀器系统的颗粒物采样法与传统采样法对比发现,含蜂窝状溶蚀器的采样系统所得到的PM2.5样品浓度有86%低于传统方法所得到的PM2.5样品浓度,其原因主要为1酸/碱性气体被去除,使其无法与富集在采样膜上的颗粒物发生反应,也无法吸附到颗粒物上;2溶蚀器系统采样过程中,部分颗粒物被捕集到溶蚀器上;3酸/碱性气体被去除,导致气-粒平衡被打破,部分颗粒物组分向气态转化.     

芳香酸稀溶液的络合萃取研究

络合萃取法分离极性有机物稀溶液具有高效性和高选择性。本文利用三辛胺或磷酸三丁酯为络合剂,四氯化碳、三氯甲烷、正辛醇或煤油为稀释剂,实验测定了苯甲酸、邻硝基苯甲酸稀溶液的萃取相平衡分配系数,讨论了影响因素。     

骆驼刺叶绿素荧光特性对不同程度干旱处理的响应

干旱是影响荒漠生态系统植物生长主要因素之一,研究其对干旱区植物叶绿素荧光特性影响有助于为干旱程度变化对干旱区植物生理生态影响的研究提供一定的理论依据.本文选择准噶尔盆地南缘荒漠区典型植物骆驼刺(Alhagi sparsifolia),设置0(对照)、轻度、中度和重度3种干旱程度的处理,研究干旱程度变化对骆驼刺叶绿素荧光...     

Effect of humic substances on the precipitation of calcium phosphate

For phosphorus （P） recovery from wastewater, the effect of humic substances （HS） on the precipitation of calcium phosphate was studied. Batch experiments of calcium phosphate precipitation were undertaken with synthetic water that contained 20 mg/L phosphate （as P） and 20 mg/L HS （as dissolved organic carbon, DOC） at a constant pH value in the range of 8.0-10.0. The concentration variations of phosphate, calcium （Ca） and HS were measured in the precipitation process; the crystalline state and compositions of the precipitates were analysed by powder X-ray diffraction （XRD） and chemical methods, respectively. It showed that at solution pH 8.0, the precipitation rate and removal efficiency of phosphate were greatly reduced by HS, but at solution pH ≥9.0, the effect of HS was very small. The Ca consumption for the precipitation of phosphate increased when HS was added; HS was also removed from solution with the precipitation of calcium phosphate. At solution pH 8.0 and HS concentrations ≤3.5 mg/L, and at pH ≥ 9.0 and HS concentrations ≤ 10 mg/L, the final precipitates were proved to be hydroxyapatite （HAP） by XRD. The increases of solution pH value and initial Ca/P ratio helped reduce the influence of HS on the precipitation of phosphate.     

烟气脱硫溶液中硫酸根的去除

分别采用石灰乳化学沉淀法和低温结晶法去除烟气脱硫溶液中的SO42-。实验结果表明：在室温、CaO溶液质量分数25%的条件下,石灰乳化学沉淀法对SO42-的去除率仅为59.51%,且向溶液中引入了Ca2+,产生的硫酸钙固体废物难以再生利用;采用低温结晶法处理烟气脱硫溶液,在结晶温度7 ℃、结晶时间3 h、NaOH加入量34.8 g/L的条件下,SO42-的去除率为82.04%、滤液中的ρ（Na+）为3.88 g/L。在现场工业应用试验中,采用低温结晶法去除烟气脱硫溶液中的SO42-,平均SO42-的去除率可达70.00%以上,滤液中的ρ（Na+）小于15.00 g/L。该法可有效抑制烟气脱硫溶液中SO42-含量的增加。