Use of bifurcation analysis for identification of a safe CSTR operability

Exothermic reactions are the most interesting systems for safety analysis because of their potential safety problems and the possibility of exotic behavior like multiple steady states. An operability and safety analysis of an exothermic reaction (hydrolysis of propylene oxide to tri-propylene glycol with consecutive reactions in a CSTR) with cooling is reported in this work. The information obtained from the bifurcation diagram is used to identify a set of unsafe operation points, which have been chosen on the base of requirement of maximal production of the process. An important information of safe reactor operation is the time in which the operator must handle a critical situation. For this reason, dynamics simulation of a failure in the cooling medium flow rate has been done and discussed for each of the selected operation points.     

分光光度法测定测田废水中的COD_(Cr)

为了快速监测油田废水中的化学需氧量ＣＯＤＣｒ,因此采用ＴＬ－１（Ａ）型污水ＣＯＤＣｒ速测仪进行加热催化消解,然后再用分光光度比色法测定ＣＯＤＣｒ,实验中进行了方法的准确度、精确度及Ｃｌ－影响实验,并与标准的重铬酸钾法进行了对比实验,结果说明分光光度法简单快速、重现性较好、准确度较高,对同一产品的测定结果与重铬酸钾法非常一致。因此,本方法可用于油田废水中的ＣＯＤＣｒ监测。     

银洞坡金矿含氰废水处理研究

根据对银洞坡金矿的水质水量调查,采用碱性氯化法处理银洞坡金矿尾矿库的含氰废水,在去除氰化物和重金属方面都取得了较好的效果。对实验的结果进行了影响因素分析,提出了采用间歇式方法处理含氰废水的工艺方案。     

氨基黑10B褪色光度法测定痕量季铵盐型阳离子表面活性剂的研究

研究了在硫酸介质中,季铵盐型表面活性剂溴化十六烷基三甲基铵(CTMAB)、溴化十六烷基吡啶(CPB)对氨基黑10B的褪色作用,建立了褪色光度法测定痕量CTMAB和CPB的新方法,并探讨了褪色反应的机理和条件,测定CTMAB和CPB的线性范围皆为0～3×10-5mol L,摩尔吸光系数分别为1 77×104L mol·cm和1 17×104L mol·cm,用于水样中微量季铵盐型表面活性剂的测定,结果满意。     

Study on the early stage of runaway reaction using Dewar vessels

In this paper, compared with a UN cylindrical 500 mL Dewar (H.4 in the UN tests), a spherical 1 L Dewar vessel was used to study the early stages of runaway reactions of several liquid and solid samples, including three organic peroxides and a reactive material. The samples were filled in the vessels and the temperature profiles versus times at different positions of the samples were measured. As a result, the minimum temperatures, defined as the SADT, were averagely 10 K lower than those measured in the cylindrical Dewar vessels. At the same time, the temperature profiles of solids in the spherical Dewars tended to be homogeneous. The heat transfer coefficient of a spherical Dewar is only 0.18 W/K/m, one-eighth of a conventional cylindrical Dewar vessel. Meanwhile it has a low phi factor. These factors are essential to simulate low heat loss bulk conditions in the equilibrium process and at the early stage of a runaway reaction. To characterize the ability of the adiabaticity of a storage vessel, it can be seen that a spherical Dewar could simulate the plant process having critical storage size of a reactive-material, r₀, approximately 0.6 m. It is recommended that such a technique is used to investigate the SADT of an unstable material in larger scale packaging or a material with very weak heat release in industry.     

Incident investigation of mono-nitro toluene still explosion

At one of the nitro-toluene facilities, an o-nitro toluene still was in standby mode. During the standby mode feed to the still had been stopped, the column was not de-inventoried, steam flow to the reboiler was not shut off and the condenser was on total reflux. After 22 days of standby mode, steam was shut off for 5 days for annual plant maintenance. Eight days after the re-start of steam, the still exploded, hurling debris as far as one mile. The internal packing was expelled from the column and landed on the ground burning. The incident was investigated to establish the contributing factors leading to explosion. Accelerating Rate Calorimetery was extensively used to determine the onset temperature for exothermic activity in the presence/absence of a number of materials to establish the underlying cause of the accident. It was found that foulant collected in the column over a period of years accelerated the ’runaway reaction’.     

Catalytic degradation of methylene blue by Fenton like system: model to the environmental reaction

To develop more efficient chemical methods for the demineralization of organic pollutants from water bodies, which one was also mimic to the nature, a degradation of methylene blue by Fe( Ⅲ ) and H2O2 in the absence of light instead of Fe( Ⅱ ) and H2O2 was studied. Results showed that use of Fe ( Ⅲ ) is more promising than Fe( Ⅱ ). The present study reflects that Fenton reaction is more efficient, in the presence of a small amount of salicylic acid is added which is a one of the priority pollutant.     

加速量热仪在物质热稳定性研究中的应用

加速量热仪（ARC）是一种基于绝热原理设计的热分析仪器,与其它热分析仪器相比,加速量热仪可以测量克量级的固体或高闪点液体样品,具有测试样品最大,敏感度高等特点,并能够实时记录样品放热反应过程中的温度和压力变化,以过氧化氢叔丁基为例说明加速量热仪测试结果在研究物质质变热稳定性方面的应用,得到了过氧化氢叔丁基放热分解反应的温度－时间和压力－时间关系曲线以及升温速度和压力随温度变化的曲线,通过计算和分析得到了反应系统升压速率随压力的变化曲线,计算出了过氧化氢叔丁基分解反应的动力学参数表观活化能Ea和指前因子A。     

造纸黑液制备球形阳离子木质素吸附树脂

以造纸黑液中的碱木质素为原料,采用两步法制备球形阳离子木质素吸附树脂,并用扫描电镜和傅立叶变换红外光谱仪对其进行表征.第1步以造纸黑液中的碱木质素为原料,利用反相悬浮法制备球形木质素珠体,通过正交实验得出以占木质素质量1.5%的环氧氯丙烷为交联剂,吐温80为分散剂(含量为木质素质量的3%),煤油为分散相,O/W相比为3∶1,反应温度为90℃,搅拌速度为200r/min,反应时间1h为球形木质素珠体制备的最佳条件.第2步利用丙烯酰胺对球形木质素珠体接枝,得出以H₂O₂/Fe²⁺为引发剂,丙烯酰胺浓度为0.72mol/L,室温反应2h为接枝的适宜条件,在此条件下可得到离子交换容量为1.6405mmol/g的阳离子木质素吸附树脂.