Pyrolysis of rice husk and sawdust for liquid fuel

The paper is focused on studying how to convert rice husk and sawdust into liquid fuel. Rice husk, sawdust and their mixture were pyrolyzed at the temperature between 420℃ and 540℃, and the main product of liquid fuel was obtained. The experimental result showed that the yield of liquid fuel heavily depended on the kind of feedstock and pyrolysis temperature. In the experiments, the maximum liquid yields for rice husk, sawdust and their mixture were 56% at 465 ℃, 61% at 490℃ and 60% at 475℃ respectively. Analysis with GC-MS and other apparatus indicated that the liquid fuel is a complicated organic compound with low caloric value and can be directly used as fuel oil without any up-grading. As a crude oil, the liquid fuel can be refined to be vehicle oil.     

某基岩区工业固体废物填埋场地递进式场地环境调查实例

针对某基岩区简易封场后的固体废物填埋场,采用多层次、递进式调查策略,配合使用地球物理探测、直压式土壤快速取样、现场快速检测等技术,分3个阶段开展填埋场及其周边环境调查。第1阶段,调查地质环境特征,开展地球物理探测;第2阶段,调查填埋物、渗滤液主要组分及对周边积水、农田土壤、民用井水的污染情况;第3阶段,划定重点污染区域,开展土壤和地下水污染调查。调查结果显示,填埋区已发生明显渗漏,对邻近区域土壤、地下水及地表积水造成了一定污染,但未对周边农用地土壤、民用井水质等产生不利影响,总体处于可控范围。提出,通过削减污染源,切断污染物迁移、暴露途径,消除已有污染影响,长期跟踪监测等多项管控治理措施进行综合整治。     

Characteristics of stable biodiesel emulsion fuel with the aid of lipophilic surfactant,polyglycerol polyricinoleate (PGPR)

ABSTRACT

Biodiesel emulsion fuel is reported as one of the most feasible options capable of generating lower NOx emission than that from fossil fuels. However, oil and water in the emulsion fuel are easily separated and unstable. The aim of the present study is to consider the production and stability of biodiesel emulsion fuel by using tetraglycerin ester (CR-310), i.e., one of lipophilic surfactant, polyglycerol polyricinoleate (PGPR) and biodiesel, i.e., Waste cooking Oil Methyl Ester (WOME) produced based on waste cooking oil. The corresponding heat rate, water content, and viscosity are measured. Emphasis is placed on the effects of water content and surfactant on biodiesel emulsions. It is found that: (i) stable emulsion fuel is obtained by adding at least 2.0% of CR-310 and is maintained over 1 month, (ii) there is no effect of water content on stable emulsion fuel if CR-310 is used over 2.0%, and (iii) the viscosity of emulsion fuels is higher than that of the biodiesel fuel and is gradually increased with an increase in the water content.     

Fine-resolution mapping of wildfire fuel types for Canada: Fuzzy logic modeling for an Alberta pilot area

The Canadian Forest Fire Danger Rating System (CFFDRS) is used daily across Canada for evaluating forest fire danger. Fuel-type information is one of the inputs required by the models used in the CFFDRS. In this project, three fuel-type maps with a 25 m resolution were produced for a pilot study area located in Alberta using land cover only; land cover and biomass; and, land cover, biomass and leaf area index data derived from satellite imagery. The relationships between inputs and fuel types were determined mainly by the opinions of forest fire scientists and incorporated into a computer program using fuzzy set methodology. Not all the CFFDRS fuel types could be distinguished using these inputs; three of the coniferous types had to be grouped into one common fuel type. Overall accuracy was between 74 and 83% based on ground-truth comparisons. The most accurate map resulted from land cover and biomass data. Detailed accuracy assessment indicated that the overall accuracy increased up to 86% if ambiguous fuel type identification was considered. No combination of inputs was able to define a fuel type with absolute certainty, which is a reflection of differing expert opinions and the small number of inputs used to produce the maps.     

气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

Effects of compression ratio,swirl augmentation techniques and ethanol addition on the combustion of CNG–biodiesel in a dual-fuel engine

The diminishing resources and continuously increasing cost of petroleum in association with their alarming pollution levels from diesel engines has led to an interest in finding alternative fuels to diesel. Emission control and engine efficiency are two of the most important parameters in current engine design. The impending introduction of emission standards such as Euro IV and Euro V has forced research towards developing new technologies for combating engine emissions. This paper examines the effects of compression ratio, swirl augmentation techniques and ethanol addition on the combustion of compressed natural gas (CNG) blended with Honge oil methyl esters (HOME) in a dual fuel engine. The present results show that the combustion of HOME and 15% ethanol blend with CNG induction in a dual-fuel engine operated in optimized parameters at an injection timing of 27° Before Top Dead Centre and a compression ratio of 17.5 resulted in acceptable combustion emissions and improved brake thermal efficiencies. The implementation of swirl augmentation techniques increased brake thermal efficiencies (BTEs) and considerably reduced combustion emissions such as smoke, HC, CO and NO_x. The addition of ethanol also increased BTEs. However, at more than 15% of ethanol in HOME, NO_x emissions increased dramatically.     

火电燃料消费过程对资源环境的影响评估

我国以化石能源为主要燃料的火电生产导致了严重的资源枯竭和环境污染问题,定量评估火电燃料消费对资源环境的影响是区域可持续发展研究的重要内容。在估算火电燃料燃烧及运输、生产过程中排放的主要大气污染物的基础上,利用成分法计算相应的生态足迹,定量评估火电燃料消费过程对资源环境的影响。结果表明：我国1 kW〖DK〗·h火电的燃料消费过程中排放的CO2、CH4、NOx、SO2、烟尘分别为107 kg、993×10-3 kg、646×10-3 kg、260×10-3 kg、202×10-2 kg;全国火电燃料消费占用的生态足迹由2000年的50 67444万hm2,增加到2007年的123 84208万hm2,年均增长1362％;CO2和NOx的生态足迹平均比重高达836％,是影响资源环境的主要因子,SO2、烟尘与CH4三者合计仅164%,对资源环境的冲击相对较小     

Development of a hybrid microbial fuel cell (MFC) and fuel cell (FC) system for improved cathodic efficiency and sustainability: the M2FC reactor

In an effort to improve the efficiency and sustainability of microbial fuel cell (MFC) technology, a novel MFC reactor, the M2FC, was constructed by combining a ferric-based MFC with a ferrous-based fuel cell (FC). In this M2FC reactor, ferric ion, the catholyte in the MFC component, is regenerated by the FC system with the generation of additional electricity. When the MFC component was operated separately, the electricity generation was maintained for only 98 h due to the depletion of ferric ion in the catholyte. In combination with the fuel cell, however, the production of power was sustained because ferric ion was continually replenished from ferrous ion in the FC component. Moreover, the regeneration process of ferric ion by the FC produced additional energy. The M2FC reactor yielded a power density of up to 2 W m⁻² (or time-averaged value of approximately 650 mW m⁻²), density up to 20 times (or approximately six times based on time-averaged value) higher than the corresponding MFC system.