Evidence for biodegradation and volatilisation of dissolved petroleum hydrocarbons during in situ air sparging in large laboratory columns

Laboratory column experiments run for up to 13 days compared air sparging of groundwater contaminated by dissolved petroleum hydrocarbons in sterile and non-sterile aquifer sediments as well as uncontaminated sediments and groundwater. Loss of dissolved BTEX compounds in the contaminated columns was very rapid, occurring through volatilisation. The majority of the dissolved total organic carbon (TOC) persisted for much longer periods however. A direct comparison between losses from sterile and non-sterile columns suggested a negligible contribution of biodegradation to the removal of TOC. This was difficult to confirm through examination of O₂ utilisation because oxidation of a small amount of reduced sulphur in the aquifer materials was the dominant sink for O₂. Despite this, it was possible to conclude that less than 22% of the removal of TOC was through biodegradation during the first three days of air sparging.     

南昌市环境空气质量分析和控制

利用多年的环境监测数据,分析南昌市环境空气中主要污染物尘类、二氧化硫和氮氧化物产生的原因,并提出有效控制上述污染物的具体措施。     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

钯离子液相催化氧化低浓度磷化氢

采用Pd^2＋液相催化氧化低浓度PH3,考察了Pd^2＋浓度、O2体积分数、PH3质量浓度、混合气流量、反应温度等因素对Pd^2＋吸收液去除低浓度PH3效果的影响。实验结果表明,采用10mL Pd^2＋浓度为0．112mol／L的水溶液作为吸收液净化含低浓度PH3的混合气,在反应温度22℃、O2体积分数5％、PH3质量浓度850mg／m^3、混合气流量190mL／min的条件下,印min之内PH3去除率保持在90％以上。Pd^2＋浓度越高、O2体积分数越大、反应温度越高,PH3去除率越高;混合气流量越大,PH3去除率越低;反应温度越低、O2体积分数越大,PH3去除率的下降速率越小。     

树脂吸附-Fenton试剂氧化法处理水杨醛生产废水

采用树脂吸附-Fenton试剂氧化法处理水杨醛生产废水。XF-01树脂和XF-02树脂静态吸附水杨醛生产废水时,COD去除率均在85％以上,挥发酚去除率均高于90％。XF-02树脂对水杨醛生产废水的处理效果更佳。动态吸附随废水流量增大,吸附出水的COD和挥发酚质量浓度均增加。适宜的废水流量为15BV,树脂的最佳脱附温度为80℃。在连续4批的吸附-脱附实验中,吸附出水的平均COD约为1200mg／L,平均挥发酚质量浓度小于10mg／L。在Fenton试剂氧化中,铁屑和铁粉的催化效果差别很小,都好于FeSO4·7H2O。以铁屑为催化剂、H2O2溶液加入量为1％时,氧化出水的COD小于150mg／L,挥发酚质量浓度小于0．5mg／L。     

短程硝化—厌氧氨氧化组合工艺在脱氮领域的研究进展

基于全程硝化反硝化的传统生物脱氮工艺在硝化过程中需要大量氧气供应,反硝化过程需要有机物作为碳源,存在能耗与药耗过大的问题.为了降低废水脱氮的成本,短程硝化(PN)—厌氧氨氧化(ANAMMOX)组合工艺(PNA工艺)得到了高速发展.综述了PNA工艺的影响因素,重点介绍了4种基于PN与ANAMMOX原理开发的衍生PNA工艺...     

负载型纳米TiO2光催化降解水中微量溶解性间二甲苯

以高压汞灯为光源 ,采用浸涂 -烧结法制备的负载型纳米TiO2 作为光催化剂 ,通过对水中微量溶解性间二甲苯的光催化氧化过程的研究表明 ,初始浓度在 6 .6 8— 17.36mg/L的范围内 ,间二甲苯的光催化反应遵循表观一级反应动力学规律 ,反应的表观速率常数随溶液初始浓度的增大而减小 ,半衰期则随初始浓度的增大而增加 ,经 1.5h反应后 ,溶液中间二甲苯的去除率从 17.36mg/L的 5 4 .4 4 %增加到 6 .6 8mg/L的 75 .90 %。     

二段生物接触氧化工艺在中水回用中的特性研究

以规模小区生活污水为水源,对采用聚丙烯网状填料和强化炉渣组合填料的二段生物接触氧化工艺（以下简称二段法）进行了试验研究,试验针对本工艺的各项技术指标、影响因素以及各相关参数进行了较系统的试验测试。结果表明,反应器在第一接触氧池HRT为20 min、气水比为6∶1和第二接触氧池HRT为25 min、气水比为5∶1条件下,接触氧化池达到最佳降碳条件;反应器在第一接触沉池上升流速5.5 m/h和第二接触沉池上升流速4.5 m/h条件下,接触沉淀池达到最佳处理条件。     

Assessment of population exposure to particulate matter pollution in Chongqing, China

To determine the population exposure to PM(10) in Chongqing, China, we developed an indirect model by combining information on the time activity patterns of various demographic subgroups with estimates of the PM(10) concentrations in different microenvironments (MEs). The spatial and temporal variations of the exposure to PM(10) were illustrated in a geographical information system (GIS). The population weighted exposure (PWE) for the entire population was 229, 155 and 211 microg/m(3), respectively, in winter, summer and as the annual average. Indoor PM(10) level at home was the largest contributor to the PWE, especially for the rural areas where high pollution levels were found due to solid fuels burning. Elder people had higher PM(10) exposure than adults and youth, due to more time spent in indoor MEs. The highest health risk due to particulate was found in the city zone and northeast regions, suggesting that pollution abatement should be prioritized in these areas.     

生物过滤技术在大气污染控制中的应用

生物过滤是控制大气污染的经济有效技术,具有较好的发展前景。本文介绍了生物过滤技术处理废气的研究,应用历史,现状,和生物过滤理论,分析了工艺的使用范围,设计及运行控制要点,列举了应用的范例。