造纸中段废水与生活污水合并深度处理工艺

采用水解酸化 CAST 混凝 复合滤池与水解酸化 接触氧化 混凝 复合滤池2种组合工艺对造纸中段废水与生活污水进行合并处理对照试验.结果表明,两种工艺都是切实可行的,二级出水均可达到<污水综合排放标准>(GB8978-1996)二级标准,深度处理出水可达中水水质要求.其中以水解酸化 CAST 混凝 复合滤池组合工艺效果最好.     

MBR工艺中溶解性有机物的分子量和EEM解析

采用凝胶过滤色谱(GFC)分子量测定技术和三维荧光(EEM)光谱技术,对平板膜-生物反应器工艺应用于餐饮废水和粪便污水处理的工程实例进行研究,对比分析2套工艺中的调节池水和出水的溶解性有机物(DOM)及污泥胞外聚合物(EPS)的性质变化.研究表明,餐饮废水处理过程的调节池水DOM中大分子(＞100 kDa)物质比例为6...     

MBR在橡胶废水处理中的应用

橡胶废水具有含盐量高、色度高、有机污染成分含量高且难于生化降解等特点。膜生物反应器(MBR)技术的核心是生化处理加微滤膜过滤,通过将MBR技术应用于橡胶废水处理的实践表明,该技术对COD、氨氮、磷酸盐的平均去除率都达到了85%以上,再辅之以药剂处理后,降低了色度和难降解有机物含量,出水水质完全符合排放标准的要求,是一种解决橡胶污水处理难题的有效途径。     

污水快速渗滤土地处理研究进展

针对RI系统的污染物去除机制、运行方式、系统恢复以及实践应用等方面的研究进展作一综述。RI技术的应用有着广阔的前景 ,必将促进我国环境保护与生态建设的发展     

城镇污水处理厂污染物总量减排现场核查要点分析

指出城镇污水处理厂总量减排存在的问题,提出从水量核查、水质核查和运行状况核查等3方面对城镇污水处理厂现场核查,以此对城镇污水处理厂COD减排进行核算。     

三步法处理大港油田12井综合废水的实验研究

根据大港油田12井综合废水的污染特征,提出了"混凝-内电解-H2O2氧化"三步处理的方法。实验结果表明:三步法处理后可以使原水的CODcr从4930mg/L降低到128mg/L,去除率达到97%。处理后水质达到国家《污水综合排放标准》(GB8978-1996)二级标准要求。     

Reduction of dissolved organic matter in terms of DOC, UV-254, SUVA and THMFP in industrial estate wastewater treated by stabilization ponds

The aim of this research was to monitor the influent and effluent water quality of the aeration, facultative and oxidation water treatment ponds of an industrial estate. This industrial estate, the largest in northern Thailand, has proposed to utilization of reclaimed treated wastewater in their raw water supply so as to cope with the yearly water shortage during the dry season. Water samples were collected four times from four sampling points and evaluated for their dissolved organic matter (DOM) content in terms of dissolved organic carbon (DOC), ultraviolet light absorbance at 254 nm (UV-254), specific ultraviolet absorption (SUVA), trihalomethane formation potential (THMFP) and trihalomethane (THM) species. Average values of DOC, UV-254, SUVA and THMFP in the influent wastewater of 12.9 mg L⁻¹, 0.165 cm⁻¹, 1.29 L mg⁻¹m⁻¹ and 1.24 mg L⁻¹, respectively, were observed. The aeration ponds produced the best results: a 54% reduction of DOC, a 33% reduction of UV-254, and a 57% reduction of THMFP. However, SUVA in the aeration pond effluent showed a moderate increase. The facultative ponds and oxidation ponds did not take part in the reduction of DOC, UV-254, SUVA and THMFP. Average DOC, UV-254, SUVA and THMFP value of the treated wastewater were 5.8 mg L⁻¹, 0.107 cm⁻¹, 1.85 L mg⁻¹m⁻¹ and 468 μg L⁻¹, respectively. Chloroform, at 72.6% of total THMFP, was found to be the predominant THM species.     

Evaluation of marine outfall with three-dimensional hydrodynamic and water quality modeling

Numerical models are often used to evaluate the potential impact of human alternation of natural water bodies and to help the design of the alternation to mitigate its impacts. In the past decade, three-dimensional hydrodynamic and reactive transport modeling has matured from a research subject to a practical analysis technology. This paper presents a practical study in which a three-dimensional hydrodynamic and water quality model [hydrodynamic eutrophication model (HEM-3D)] was applied to determine the optimal location for treated wastewater discharged from marine outfall system in the Keelung harbor and the adjacent coastal sea. First, model validation was conducted with respect to surface elevation, current, and water quality variables measured in the Keelung harbor station and its coastal sea. The overall performance of the model was in qualitative agreement with the available field data. The model was then used to evaluate several scenarios of the locations from marine outfall system. Based on model simulation results, a location at the northeast of Ho-Ping Island was recommended for adoption because the environmental impact is smaller than any other alternative.

气浮过滤法处理印染废水

高效气浮工艺是处理印染废水的有效方法,通过在溶气罐中使用高效填料、优化设计溶气释放器及使用双层快滤,可大大提高处理效果。     

应用D412螯合树脂治理含镍电镀废水的研究

本文研究了Ｄ４１２螯合树脂对Ｎｉ（Ⅱ）离子静态和动态的吸收性能,并且研究了使用Ｄ４１２树脂除去和回收电镀废水中镍的最佳条件。