一体式膜生物反应器中环境条件对混合液粘度的影响研究

文章研究了一体式膜生物反应器中环境条件对混合液粘度的影响,以及混合液粘度对膜过滤阻力的影响。试验结果表明：混合液的粘度主要是由胞外聚合物引起的;混合液粘度随着胞外聚合物含量的变化而变化;混合液粘度与各操作条件之间存在一定的关系U=1．586（MESS）^0．614T^-0.106（DO）^0.4697;混合液粘度与膜过滤阻力有较好的相关性。     

Dynamic temperature model for proton exchange membrane fuel cell using online variations in load current and ambient temperature

This paper presents a dynamic temperature model for a proton exchange membrane fuel cell (PEMFC) system. The proposed model overcomes the complexity of conventional models using first-order expressions consisting of load current and ambient temperature. The proposed model also incorporates a PEMFC cooling system, which depends upon the temperature difference between events. A dynamic algorithm is developed to detect load changing events and calculate instantaneous PEMFC temperature variations. The parameters of the model are extracted by employing the lightning search algorithm (LSA). The temperature characteristics of the NEXA 1.2 kW PEMFC system are experimentally studied to validate model performance. The results show that the proposed model output and the temperature data obtained from experiments for linear and abrupt changes in PEMFC load current are in agreement. The root-mean-square error between the model output and experimental results is less than 0.9. Moreover, the proposed model outperforms the conventional models and provides advantages such as simplicity and adaptability for low and high sampling data rates of input variables, namely, load current and ambient temperature. The model is not only helpful for simulations but also suitable for dynamic real-time controllers and emulators.     

纳滤膜过滤MBR出水的污染原因与清洗方法

为研究膜-生物反应器(MBR)出水对纳滤膜的污染原因及清洗方法,使用场发射扫描电镜、傅立叶变换红外光谱仪、原子力显微镜和接触角仪对经MBR出水污染的纳滤膜表面污染层进行了检测,结果表明,纳滤膜表面污染物包括有机物和无机物,所含元素包括磷、镁等,对经过不同清洗步骤的膜表面进行的检测表明,柠檬酸清洗可以去除镁和大部分磷,这些物质主要以无机形态存在于膜面污染物中;后续NaOH清洗可以进一步去除磷,这部分磷主要来自有机酸、有机磷或蛋白质等膜面污染物.污染使膜表面粗糙度由79.5 nm增大至111.2 nm,但接触角由55.6°变为62.1°,表明亲水性变化不大;酸洗后表面粗糙度显著减小至51.9 nm,接触角变为96.0°,表明有机污染物暴露出来,膜面呈现疏水性;再经碱洗后,膜面粗糙度与亲水性均接近于新膜.这些结果说明,先酸洗后碱洗的方法可以去除绝大部分的膜面污染物,进一步推知膜污染初期主要为有机污染,之后无机物的作用使污染进一步加重.     

高浓度液晶废水处理研究

针对某化工厂液晶中间体生产废水,采用Fenton预处理+水解酸化+好氧+超滤反渗透工艺进行处理,发现Fenton技术具有良好的预处理效果,对COD的去除率在50%左右,且废水可生化性从原水的0.05提高至0.38,经过水解酸化及好氧单元的降解,废水ρ(COD)可降至150~200 mg/L,再通过超滤反渗透膜处理,COD浓度可降至50mg/L以下,达到GB/T 19923—2005《城市污水再生利用—工业用水水质》要求,出水可用作稀释水或厂内冷却用水。膜浓水通过自主研发的强化蒸发装置处理,可实现废水不外排。采用该工艺对厂内实际生产废水进行现场调试运行,处理规模为5 m~3/d,原水初始pH值为2.0~4.5,ρ(COD)为7 000~10 000 mg/L。稳定运行后,生化段出水pH值为7.5~8.0;ρ(COD)为150~200 mg/L,膜处理后ρ(COD)<50 mg/L,证明运行稳定可靠。     

Effect of ozone on the performance of a hybrid ceramic membrane-biological activated carbon process

Two hybrid processes including ozonation-ceramic membrane-biological activated carbon （BAC） （Process A） and ceramic membrane-BAC （Process B） were compared to treat polluted raw water. The performance of hybrid processes was evaluated with the removal efficiencies of turbidity, ammonia and organic matter. The results indicated that more than 99% of particle count was removed by both hybrid processes and ozonation had no significant effect on its removal. BAC filtration greatly improved the removal of ammonia. Increasing the dissolved oxygen to 30.0 mg/L could lead to a removal of ammonia with concentrations as high as 7.80 mg/L and 8.69 mg/L for Processes A and B, respectively. The average removal efficiencies of total organic carbon and ultraviolet absorbance at 254 nm （UV254, a parameter indicating organic matter with aromatic structure） were 49% and 52% for Process A, 51% and 48% for Process B, respectively. Some organic matter was oxidized by ozone and this resulted in reduced membrane fouling and increased membrane flux by 25%-30%. However, pre-ozonation altered the components of the raw water and affected the microorganisms in the BAC, which may impact the removals of organic matter and nitrite negatively.     

一种新型聚四氟乙烯膜在油田采出水的试验研究

本实验装置原水为大庆油田采出水,经过0.1μm聚四氟乙烯膜处理后要求达到SS≤1.0 mg/L、粒径中值≤1μm和0il≤5.0 mg/L的标准,然后再回注。实验结果表明:在预处理出水稳定在0il≤15.0 mg/L、SS≤5.0 mg/L、粒径中值≤3μm条件下,该水质作为膜系统的进水时,膜的出水水质中粒径中值不达标,SS和oil含量能达到设计要求。在预处理出水水质超出设计范围时,膜的出水水质中SS超标,而oil和粒径中值能达标。     

xDLVO理论解析微滤膜海藻酸钠污染中pH值影响机制

用extended Derjaguin-Laudau-Verwey-Overbeek(xDLVO)理论定量解析不同pH值下海藻酸钠微滤膜污染过程中的界面相互作用,评价范德华力(LW)、双电层作用力(EL)、极性力(AB)对海藻酸钠微滤膜污染的相对贡献.结果表明,在pH5~9范围内,AB相互作用能起着关键作用,决定了总界面相互作用能的性质与强度.不同pH值下海藻酸钠微滤膜污染趋势(K)为pH 5 > pH 7 > pH 8 > pH 9. 由于与海藻酸钠之间的界面作用为引力,疏水性膜在过滤初期膜污染更为严重;污染后期亲、疏水性膜污染行为差异不明显,因为此时海藻酸钠之间的排斥性界面作用为主导.初始、后期阶段K值分别与膜-海藻酸钠界面自由能、海藻酸钠-海藻酸钠界面自由能有较强的线性相关性,说明xDLVO理论可以有效预测不同pH值下海藻酸钠微滤膜污染行为.     

染整废水深度处理纳滤工艺膜污染成因分析

为调查棉针织染整废水纳滤脱盐系统膜污染的类型和成因,使用电感耦合等离子发射光谱仪、扫描电子显微镜-EDX能谱仪、傅里叶变换红外光谱仪、热重分析仪、高倍光学显微镜和X射线荧光光谱仪,从膜进水水质、膜过程污染状况和膜清洗效果等三方面进行了联合互补检测和综合分析.结果表明,棉针织染整废水脱盐过程中纳滤膜的污染类型包括无机污染、有机污染和微生物污染;干燥(105℃)的污染物成分组成中结合水所占质量分数约8.2%,有机成分所占质量分数约41.0%,无机成分所占质量分数约50.8%;在无机污染物中铁盐污染较为突出,有机污染物所包含的主要官能团为—OH、—CH和—CC,微生物污染物中包含原生动物和后生动物;短期膜污染和长期膜污染分析结果表明有机污染和微生物污染的形成需要长时间的累积效应;纳滤膜清洗试验结果表明,有机污染和微生物污染是引起膜通量下降的主要原因,两者对膜通量影响的贡献率约53.3%.     

Feasibility and simulation model of a pilot scale membrane bioreactor for wastewater treatment and reuse from Chinese traditional medicine

The lack and pollution of water resource make wastewater reuse necessary. The pilot scale long-term tests for submerged membrane bioreactor were conducted to treat the effluents of anaerobic or aerobic treatment process for the high-strength Chinese traditional medicine wastewater. This article was focused on the feasibility of the wastewater treatment and reuse at shorter hydraulic retention time （HRT） of 5.0, 3.2 and 2.13 h. MLSS growth, membrane flux, vacuum values and chemical cleaning periods were also investigated. The experimental results of treating two-phase anaerobic treatment effluent demonstrated that the CODfilt was less than 100 mg/L when the influent COD was between 500-10000 mg/L at HRT of 5.0 h, which could satisfy the normal discharged standard in China. The experimental results to treat cross flow aerobic reactor effluent demonstrated that the average value of CODfilt was 17.28 mg/L when the average value of influent COD was 192.84 mg/L at HRT of 2.13 h during 106 d, which could completely meet the normal standard for water reuse. The maximum MLSS and MLVSS reached 24000 and 14500 mg/L at HRT of 3.2 h respectively. Membrane flux had maximal resume degrees of 94.7% at vacuum value of 0.02 MPa after cleaning. Chemical cleaning periods of membrane module were 150 d. A simulation model of operational parameters was also established based on the theory of back propagation neural network and linear regression of traditional mathematical model. The simulation model showed that the optimum operational parameters were suggested as follows： HRT was 5.0 h, SRT was 100 d, the range of COD loading rate was between 10.664-20.451 kg/（m3.d）, the range of MLSS was between 7543-13694 mg/L.     

陶瓷膜处理啤酒洗瓶废碱液的膜污染和清洗再生

研究了陶瓷膜过滤啤酒洗瓶废碱液膜污染机理,提出了相应的清洗再生方案。对比研究了硝酸、盐酸、次氯酸钠、三聚磷酸钠4种清洗剂单独使用和复合使用的清洗再生效果。试验表明:0.20%硝酸+0.55%次氯酸钠+0.15%三聚磷酸钠复合清洗再生陶瓷膜,膜通量恢复率在85%以上。陶瓷膜连续运行两个月,清洗再生效果稳定,具有工程实用价值。