螯合树脂去除丙烯酸丁酯废水中的二价阳离子

采用氨基膦酸螯合树脂C-900去除丙烯酸丁酯废水中的二价阳离子,考察了吸附温度和废水流量对树脂动态吸附性能的影响,并用Thomas模型进行动态吸附数据的拟合分析。实验结果表明,在吸附温度为35℃、废水流量为15SV的条件下,处理后出水中3种二价阳离子总质量浓度为1.0mg/L时的穿透体积为240BV,达到穿透体积时树脂对Ca²⁺,Mg²⁺,Cu²⁺的去除率分别为100%,99.2%,99.8%。     

有机玻璃颗粒流态化热裂解

废弃聚基丙烯酸甲醋（PMMA）的增长及无序堆放会对环境造成严重影响。流化床热裂解技术代表了PMMA处理技术的发展方向。在实验室规模的流化床热解装置上,对PMMA的原料特性、加热方式和温度等多因素对其热解的影响进行了研究。结果表明,PMMA的热解产物主要是气体和液体MMA,液体最大得率为91.8%。在400℃以上时,随着热解温度的升高,CO2和CO的含量增加,而MMA含量下降;采用流化气体预热方式或减小PMMA粒径的操作方式,有利于热解强度和液体产率的提高。     

Persistence of methyl <Emphasis Type="Italic">tertiary</Emphasis> butyl ether (MTBE) against metabolism by Danish vegetation

BACKGROUND: Methyl tertiary butyl ether (MTBE) is the second most highly produced industrial chemical in the US and a frequent groundwater pollutant. At the same time, MTBE is quite persistent to biotic and abiotic decomposition. The goal of this study was to find plant species that could degrade MTBE and might be used in phytoremediation. METHODS: Excised roots and leaves (0.3 g) from more than 24 Danish plant species out of 15 families were kept in glass vessels with 25 ml spiked aqueous solution for 2 to 4 days. MTBE concentrations were 1 to 5 mg/L. Samples were taken directly from the solution with a needle and injected to a purge and trap unit. MTBE and the main metabolite, TBA, were measured by GC/FID. RESULTS AND DISCUSSION: Solutions with roots of poplar (Populus robusta) and a willow hybrid (Salix viminalis x schwerinii) produced TBA in trace amounts, probably stemming from bacteria. Significant MTBE reduction (> 10%) was not observed in any of the tests. Leaves from none of the species (trees, grasses and herbs) reduced the concentration of MTBE in the solution and no TBA, nor any other known metabolite of MTBE, was detected. CONCLUSION: It was not possible to find plants capable of efficiently degrading MTBE. This gives rise to the conclusion that plants probably cannot degrade MTBE at all, or only very slowly. RECOMMENDATIONS AND OUTLOOK: For phytoremediation projects, this has, as consequence, that the volatilization by plants (except with genetically engineered plants) is the only relevant removal process for MTBE. For risk assessment of MTBE, degradation by the plant empire is not a relevant sink process.     

活性炭吸附二硫化碳解析气相色谱法测定废气中乙酸乙酯和乙酸丁酯研究

采用活性炭管吸附废气中的乙酸乙酯和乙酸丁酯,经二硫化碳萃取解析,使用DM-1色谱柱分离后FID检测.实验结果表明:(1)采用活性炭管吸附废气中的目标组份,富集效率良好,二硫化碳解析率可达92％以上;(2)当乙酸乙酯和乙酸丁酯的含量为6.8～102 ng时,测定结果的相对标准偏差分别在1.8％ ～4.2％和3.2％ ～6.1％之间(n=6);(3)当样品采集量为30 L时,方法检出限分别为0.02 mg·m-3和0.02 mg·m-3.因此,方法能满足实验对空气废气中的乙酸乙酯和乙酸丁酯的检测要求.     

The effects of benomyl and its breakdown products carbendazim and butyl isocyanate on the structure and function of tracheal ciliated cells

Abstract

The effects of the fungicide benomyl and its breakdown products, carbendazim and butyl isocyanate, were examined on canine tracheal epithelial tissue in primary culture. Changes in ciliary frequencies were monitored with an optical spectrum analysis system. Serial dilutions of the test compounds were prepared in 100% corn oil and applied to the cell cultures for intervals up to 6 hours and frequencies measured at intervals of 15 minutes to 1 hour. Benomyl and butyl isocyanate caused concentration‐dependent decreases in ciliary beat frequency. Benomyl at 300 μg/ml (3 mM) caused ciliostasis within 75 minutes of exposure. Butyl isocyanate at a molar concentration three times lower than benomyl (1 mM) caused a similar response, although within 30 minutes. The IBC₅₀ for benomyl was 0.75 mM, while for butyl isocyanate it was 0.52 mM. Carbendazim caused a moderate decrease in frequency over a 6 hour exposure period. Benomyl caused moderate to severe swelling of the mitochondria of ciliated epithelial cells with other cell organelles appearing normal. Butyl isocyanate did not cause any noticeable effect on cell ultrastructure and the apparently low rate of penetration of carbendazim into cells made it impossible to obtain an effect which justified ultrastructural analysis. It appears, at least for benomyl and butyl isocyanate, that while the physiological effect of these two compounds (inhibition of ciliary beat) is the same, the sites of action in the cell may be different.     

Methyl Tertiary Butyl Ether (MTBE) and Other Volatile Organic Compounds (VOCs) in Public Water Systems,Private Wells,and Ambient Groundwater Wells in New Jersey Compared to Regulatory and Human-Health Benchmarks

Potential threats to drinking water and water quality continue to be a major concern in many regions of the United States. New Jersey, in particular, has been at the forefront of assessing and managing potential contamination of its drinking water supplies from hazardous substances. The purpose of the current analysis is to provide an up-to-date evaluation of the occurrence and detected concentrations of methyl tertiary butyl ether (MTBE) and several other volatile organic compounds (VOCs) in public water systems, private wells, and ambient groundwater wells in New Jersey based on the best available data, and to put these results into context with federal and state regulatory and human-health benchmarks. Analyses are based on the following three databases that contain water quality monitoring data for New Jersey: Safe Drinking Water Information System (SDWIS), Private Well Testing Act (PWTA), and National Water Information System (NWIS). For public water systems served by groundwater in New Jersey, MTBE was detected at a concentration ≥10 μg/L, ≥20 μg/L, and ≥70 μg/L at least once in 30 (2%), 21 (1.4%), and five (0.3%) of sampled systems from 1997 to 2011, respectively. For private wells in New Jersey, MTBE was detected at a concentration ≥10 μg/L, ≥20 μg/L, and ≥70 μg/L at least once in 385 (0.5%), 183 (0.2%), and 46 (0.05%) of sampled wells from 2001 to 2011, respectively. For ambient groundwater wells in New Jersey, MTBE was detected at a concentration ≥10 μg/L, ≥20 μg/L, and ≥70 μg/L at least once in 14 (2.1%), 9 (1.3%), and 4 (0.6%) of sampled wells from 1993 to 2012, respectively. Average detected concentrations of MTBE, as well as detected concentrations at upper-end percentiles, were less than corresponding benchmarks for all three datasets. The available data show that MTBE is rarely detected in various source waters in New Jersey at a concentration that exceeds the State's health-based drinking water standard or other published benchmarks, and there is no evidence of an increasing trend in the detection frequency of MTBE. Other VOCs, such as tetrachloroethylene (PCE), trichloroethylene (TCE), and benzene, are detected more often above corresponding regulatory or human-health benchmarks due to their higher detected concentrations in water and/or greater toxicity values. The current analysis provides useful data for evaluating the nature and extent of historical and current contamination of water supplies in New Jersey and potential opportunities for public exposures and health risks due to MTBE and other VOCs on a statewide basis. Additional forensic or forecasting analyses are required to identify the sources or timing of releases of individual contaminants at specific locations or to predict potential future water contamination in New Jersey.     

Modification of Aliphatic Polyesters and Their Reactive Blends with Starch

Modified polycaprolactone was synthesized by melt reaction of PCL and reactive monomers such as glycidyl methacrylate (GMA) and maleic anhydride (MAH) in the presence of benzoyl peroxide in Brabender mixer. MAH showed a different grafting phenomenon compared to GMA. The reaction mechanism was discussed with different reactive monomers. Reactive blends of the PCL-g-GMA and the gelatinized starch with glycerin were prepared and their mechanical properties and biodegradabilities were investigated. Reactive blends of PCL-g-GMA and starch showed well-dispersed starch domain in the matrix and better mechanical strength than the unmodified PCL/starch blend. However, the reaction between PCL-g-GMA and starch induced a crosslinking during the reactive blending and this crosslinking in the blend lowered the biodegradation of the blend during the composting test. The biodegradability was investigated by the weight loss and surface morphology change of the blend in the composting medium.     

RS-1型含硫有机废气燃烧催化剂

考察了RS-1型催化剂对乙硫醇、丁硫醇、二硫化碳、硫酸二甲酯、乙醇、二甲苯等有机物的氧化活动性。实验结果表明,这种催化剂对乙硫醇等含硫有机物均有较高的氧化活性,且有机硫的氧化产物SO_x不与催化剂发生化学反应。经分析检测,氧化产物SO_x放出率接近100％。在反应温度380℃,空速10000h~(-1),乙硫醇和丁硫醇浓度分别为4000—8000mg/m~3、6000—8000mg/m~3时,净化率≥99％。该催化剂适用于净化制药厂、农药厂等生产排放的含硫废气。     

CuO/γ-Al_2O_3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH（4~5）条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为：pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为：pH〉反应时间〉H2O2用量〉催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

离子液体萃取法回收废水中的醋酸丁酯

利用离子液体1-己基-3-甲基咪唑六氟磷酸盐萃取模拟废水中的醋酸丁酯。萃取液经减压蒸馏回收醋酸丁酯,离子液体也得到再生。实验结果表明:萃取率随废水与离子液体体积之比(相比)的增加而减小,随萃取时间的延长而增大,随萃取温度的升高而增大;在相比为6∶1、萃取时间为40min、萃取温度为50℃的条件下,萃取率达98.98%,醋酸丁酯纯度达99.8%;回收后离子液体可重复使用且萃取率基本不变。