彩色CCD成像法测量光污染

光环境是城市人居条件的一项重要内容,光污染的监测主要是针对光环境。将色彩校正的方法应用于彩色CCD测量光环境亮度分布,并结合计算机图像处理技术,对不同的颜色转换矩阵进行实验分析,使得亮度计算值和实测值很好地吻合,得出图像RGB三刺激值与目标亮度的函数关系式。通过实验,对相机测量值与亮度计实测值进行对比,分析镜头渐晕现象...     

Predicting the variation in detection function in line transect sampling through random parameter model

A method for calibrating (localizing) detection function models in line transect sampling is proposed. The method is based on a random parameter model which supplies localized predictions of detection function parameters utilizing a few sample data points from the concerned location(s). The method has the clear advantage of being able to provide density estimates based on very few observations from a location which would be impossible through traditional methods. The method is successfully illustrated using census data on sambar (Cervus unicolor) from a set of wildlife sanctuaries in Kerala, India. The need for further research in this direction is indicated.     

Calibration for the determination of 19 trace elements in serum and urine

A fast, high-throughput and accurate method was developed for determination of Al, As, Ba, Cd, Co, Cr, Cs, Cu, Fe, Mn, Ni, Pb, Se, U, Zn, Sb, Sn, I and Hg in urine and serum by inductively coupled plasma mass spectrometry. The samples were directly analyzed after 1/20 (v/v) dilution in 0.4% (v/v) HNO₃ and 0.005% Triton X-100. Three calibration modes were tested: aqueous and matrix matching with urine and serum. The accuracy was tested using reference materials of serum, urine and spiking. Results showed that the use of matrix matching calibration reduced the interferences and improved the recoveries for Al, Co, Pb and I in urine. The matrix matching did not affect the results considerably for serum. When serum was spiked with As, Co, Cs, Pb, U, Hg, I, Ba, Al, Cr and Ni, only matrix matching presented good recoveries. Helium was used as a collision cell gas reducing effectively polyatomic interferences for Al, Mn, Cu, Ni, Cr, Zn, As and Fe. Selection of the best internal standard was carried out for each element. The use of diluted HNO₃ improved the limit of detection. Finally, the method was applied successfully in samples of urine from workers occupationally exposed.     

三波段积分浑浊度仪的检测和校准

在兰州大学半干旱气候与环境观测站(SACOL)长期观测运行的基础上,针对测量气溶胶散射特性的三波段积分浑浊度仪(TSI3563)的校准和检测问题进行了探讨.讨论了TSI浊度仪检测和校准气体的选择,零气主要使用经高效微粒空气过滤器过滤的干净空气,标准气体主要使用CO2;总结出浊度仪零气检测和标准气体检测的理论依据,每天零气检测时,散射系数的变化范围为 ,平均值范围为 ,当超出这个范围就需要进行零点设定,每3~5d进行标准气体检测时,散射系数的平均值和理论计算值的误差超出 的范围,就需要进行全校准;最后介绍了零气校准和全校准的方法.     

Modeling agricultural non-point source pollution in a high-precipitation coastal area of China

Non-point source （NPS） pollution simulation in the high-precipitation coastal areas of China is difficult because varying annual typhoon incidence leads to highly contrasting rainfall patterns in dry years and wet years. An IMPULSE （Integrated Model of Non-point Sources Pollution Processes） based NPS model of the Changtan Reservoir watershed, which is a typical high-precipitation coastal area in China, was established based on the analysis of point and NPS pollution data, a digital elevation model, and data on land-use, soil, meteorology, economy, and agricultural management practice. Pre-processed pre-rain- fall soil moisture levels were introduced during the simulation to model the effects of typhoons on hydrology. Rainfall events were simulated sequentially through the year and the model was calibrated and verified using hydrological and water quality data. Accuracy of the simulated rainfall runoff and water quality in the Changtan watershed was found to be acceptable. The study showed that the NPS modeling system could be applied to the simulation and prediction ofNPS loadings in the Changtan Reservoir watershed.     

HYDROLOGIC MODELING AT THE WATERSHED SCALE USING NPSM1

ABSTRACT: The Nonpoint Source Model (NPSM) was chosen for nonpoint source pollutant modeling within three different watersheds. The first step in using NPSM, hydrologic calibration, is discussed here for three 8‐digit Hydrologic Unit Codes (HUCs) from the White River Basin in Indiana (Driftwood HUC), the Albemarle‐Pamlico River Basin in Virginia and North Carolina (Contentnea HUC), and the Apalachicola‐Chattahoochee‐Flint River Basin in Alabama, Georgia, and Florida (Ichawaynochaway HUC). Model predicted flows were compared statistically with USGS gauge data at the HUC outflow points for an uncalibrated and calibrated model run for the period from January 1, 1990, through December 31, 1992, and a validation run for the period from January 1, 1993, through December 31, 1995. Least squares regression of NPSM predicted flows versus USGS gauge data were 0.75, 0.44, and 0.69 for the calibration runs and 0.71, 0.69, and 0.64 for the validation runs in the Driftwood, Contentnea, and Ichawaynochaway HUCs, respectively. Nash Sutcliffe coefficient values were not as strong, ranging from ?0.66 to 0.45 for the calibration runs and 0.31 to 0.37 for the validation runs of the model. The Ichawaynochaway HUC proved the most difficult to calibrate indicating that the model may not be as useful in some geographic locations.     

单推三校正系数在光离子化检测器应用中的测量研究

在利用光离子化检测器监测单推三推进剂贮存环境时,必须首先要知道单推三相对于光离子化检测器校准气体的校正系数。通过简要介绍了校正系数的测量计算原理,并进行实验测量计算,求得单推三的校正系数。     

SENSITIVITY CONSIDERATIONS WHEN MODELING HYDROLOGIC PROCESSES WITH DIGITAL ELEVATION MODEL1

ABSTRACT: The purpose of this paper is to investigate the sensitivity of a hydrologic models to the type of DEM used. This was done while modeling basin water quality with 1:24,000 and 1:250,000 U.S. Geological Survey DEMs as input to model hydro‐logical processes. The manner in which the model results were sensitive to the choice of raster cell size (scale) is investigated in this study. The Broadhead watershed, located in New Jersey, USA, was chosen as a study area. Curve numbers were estimated by a trial and error to match simulated and observed total discharge. Monthly runoff for the watershed was used in the calibration process. Higher runoff volumes were simulated by the model when the 1:24,000 DEM were used as input data, probably due to the finer resolution which simulated increased average slope and hence higher estimated runoff from the watershed. As the simulated slope of the watershed is flatten with the 1:250,000 DEM, the response of stream flow was delayed and simulated less runoff volume.     

单级活性污泥过程数学模型ASM2D参数的灵敏度分析

利用单级活性污泥模拟流程对ASM2D参数的灵敏度进行了研究,发现在67个化学计量系数及动力学常数中,有22个参数需在应用中进行校核．该项研究结果为ASM2D实际应用中减少需校核参数的个数提供了依据．     

Critical ranges of pollution indices: a tool for predicting soil metal pollution under long-term wastewater reuse

A greenhouse experiment was conducted in pots, for two years (2015–2016), in Amaliada, Greece, using a randomized block design, including six treatments with mixtures composed of Zn, Mn, Cd, Co, Cu, Cr, Ni, and Pb, each metal taking part in the mixture at concentrations of 0, 10, 20, 30 40, and 50 mg/kg soil in four replicates each. Beta vulgaris (beet) was used as a test plant. The aim of the experiment was to calibrate the following pollution indices: “pollution load index,” “elemental pollution index,” “heavy metal load,” and “total concentration factor,” in order to determine the level of soil pollution under variable levels (low to very high) of metal mixtures. The irrigation of the plants was conducted with treated municipal wastewater based on field capacity and percent wilting point. The above pollution indices were classified into four soil pollution classes, i.e., “optimum,” “low,” “high” and “very high” on the basis of percent dry matter plant losses.