活性炭纤维电极电还原产H2O2的实验研究

利用活性炭纤维作为阴极,比较了活性炭纤维电极和石墨板电极产H2O2的浓度,并对影响活性炭纤维电极产H2O2的因素(pH、电流密度和电解质浓度)进行了研究.研究发现,活性炭纤维电极电还原产生H2O2的浓度远大于石墨板电极.当实验在pH=3.00、电流密度8.89 mA/cm2和电解质(Na2SO4)浓度0.05 moL/...     

临安区域大气本底站CO_2浓度特征及其碳源汇变化研究

通过分析2006年8月～2009年7月临安区域大气本底站Flask瓶采样获得的CO2浓度特征,结合碳追踪模式的模拟结果,研究了长三角地区碳源汇变化对CO2浓度的影响.结果表明,临安区域大气本底站的CO2浓度分布在368.3×10-6～414.8×10-6之间,具有较明显的季节波动变化特征,冬季高、夏季低,浓度年较差接近...     

基于ARDL方法分析福建省资源利用与经济增长关系

运用物质流分析方法以及最新发展的自回归分布滞后模型(ARDL),对福建省1990~2008年资源利用和实际GDP二者关系进行检验和分析.采用了物质流分析指标中直接物质投入来表征区域资源利用量.ARDL边界检验结果表明,资源利用和经济增长间存在稳定的长期均衡关系.进一步通过ARDL模型揭示了区域经济增长对资源利用长期弹性系数,其值约为0.73,通过误差修正模型揭示了短期弹性系数,表明了经济增长到资源利用的长期格兰杰因果关系.对福建省经济增长和资源保护战略提出了政策建议.这一研究思路和方法具有普适性,可以适用于其他地区关于资源利用和经济增长的问题的讨论和研究.     

基于STIRPAT模型的能源消费碳足迹变化及影响因素——以江苏省苏锡常地区为例

定量研究经济社会发展对地区能源消费碳足迹的影响对区域实现低碳发展具有重要意义。论文计算了江苏省苏锡常地区1991-2008年能源消费碳足迹,采用岭回归函数对STIRPAT模型进行了拟合,采用脱钩指数分析了经济发展与能源消费碳足迹之间的关系。结果表明:①1991-2008年能源消费碳足迹平均增长速度为15.30%,能源消费碳足迹分配率以煤炭为主,石油所占比例呈波动下降趋势,天然气所占比例上升较快,能源消费碳足迹产值总体呈波动下降趋势;②经济增长是能源消费碳足迹的主要影响因素,两者关系模型拟合未出现环境库兹涅茨曲线;③经济增长与能源消费碳足迹之间处于相对脱钩与复钩的波动状态,从另一侧面验证了目前两者之间不存在库兹涅茨曲线假说的结论。     

碳源变化对降解2,4-D的好氧颗粒污泥性能及形态的影响

在长期运行的序批式生物反应器(SBR)中,考察了以葡萄糖和2,4-二氯苯氧乙酸(2,4-D)为混合碳源培养的好氧颗粒污泥在转换为2,4-D唯一碳源废水后,其形态、结构及对目标污染物去除功能的变化.结果表明,基质转换为2,4-D单一碳源后,好氧颗粒污泥仍保持了对目标污染物高效的去除能力.当进水2,4-D浓度为361～564mg/L,其去除率为99.2%～100%,COD平均去除率达到85.6%.混合碳源向2,4-D单一碳源转换对原好氧颗粒结构产生一定破坏作用,使其发生部分解体,粒径由513μm下降到302μm.但好氧颗粒污泥良好的耐负荷冲击使其保持了颗粒主体,通过一段时间适应调整后能够重新聚集生长,最终获得能够利用2,4-D为唯一碳源生长并具有良好沉降性(SVI20～40mL/g)的好氧颗粒污泥,粒径为489μm.扫描电子显微镜(SEM)观察结果表明,混合碳源转向单一碳源使好氧颗粒生物相丰富度降低.     

生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

Removal of phosphate by Fe-coordinated amino-functionalized 3D mesoporous silicates hybrid materials

Phosphate removal from aqueous waste streams is an important approach to control the eutrophication downstream bodies of water. A Fe(III) coordinated amino-functionalized silicate adsorbent for phosphate adsorption was synthesized by a post-grafting and metal cation incorporation process. The surface structure of the adsorbent was characterized by X-ray di raction, N2 adsoropion/desoprotion technique, and Fourier transform infrared spectroscopy. The experimental results showed that the adsorption equilibrium data were well fitted to the Langmuir equation. The maximum adsorption capacity of the modified silicate material was 51.8 mg/g. The kinetic data from the adsorption of phosphate were fitted to pseudo second-order model. The phosphate adsorption was highly pH dependent and the relatively high removal of phosphate fell within the pH range 3.0–6.0. The coexistence of other anions in solutions has an adverse e ect on phosphate adsorption; a decrease in adsorption capacity followed the order of exogenous anions: F?? > SO2?? 4 > NO??3 > Cl??. In addition, the adsorbed phosphate could be desorbed by NaOH solutions. This silicate adsorbent with a large adsorption capacity and relatively high selectivity could be utilized for the removal of phosphate from aqueous waste streams or in aquatic environment.     

Factors affecting the direct mineralization of CO2 with olivine

Olivine, one of the most abundant minerals existing in nature, is explored as a CO2 carbonation agent for direct carbonation of CO2 in flue gas. Olivine based CO2 capture is thermodynamically favorable and can form a stable carbonate for long-term storage. Experimental results have shown that water vapor plays an important role in improving CO2 carbonation rate and capacities. Other operation conditions including reaction temperature, initial CO2 concentration, residence time corresponding to the flow rate of CO2 gas stream, and water vapor concentration also considerably affect the performance of the technology.     

Silver impregnated carbon for adsorption and desorption of elemental mercury vapors

The Hg0 vapor adsorption experimental results on a novel sorbent obtained by impregnating a commercially available activated carbon (Darco G60 from BDH) with silver nitrate were reported. The study was performed by using a fundamental approach, in an apparatus at laboratory scale in which a synthetic flue gas, formed by Hg0 vapors in a nitrogen gas stream, at a given temperature and mercury concentration, was flowed through a fixed bed of adsorbent material. Breakthrough curves and adsorption isotherms were obtained for bed temperatures of 90, 120 and 150°C and for Hg0 concentrations in the gas varying in the range of 0.8–5.0 mg/m3. The experimental gas-solid equilibrium data were used to evaluate the Langmuir parameters and the heat of adsorption. The experimental results showed that silver impregnated carbon was very effective to capture elemental mercury and the amount of mercury adsorbed by the carbon decreased as the bed temperature increased. In addition, to evaluate the possibility of adsorbent recovery, desorption was also studied. Desorption runs showed that both the adsorbing material and the mercury could be easily recovered, since at the end of desorption the residue on solid was almost negligible. The material balance on mercury and the constitutive equations of the adsorption phenomenon were integrated, leading to the evaluation of only one kinetic parameter which fits well both the experimentally determined breakthrough and desorption curves.