镍铜氧化物对吐氏酸废水臭氧氧化的催化作用

染料中间体废水等难生物降解废水是目前水处理研究的焦点。用浸渍法和附着沉淀法制备了以γ-Al₂O₃为载体的负载型镍、铜氧化物催化剂,并以催化吐氏酸废水的臭氧氧化。研究结果表明,镍、铜单组分和双组分氧化物催化剂能不同程度地提高臭氧的利用效率,其中附着沉淀法制备的Ni-Cu-Urea-1催化剂活性最高,当臭氧投加量为0.82g/L时,其臭氧化指数为1.1;助剂钾对催化剂活性的影响与制备方法有关,当用浸渍法制备时,助剂钾能提高催化剂活性,而附着沉淀法时则不利。     

净化含氮有机污染物的催化剂及工艺

介绍了两种催化剂PCN-1,PCN-2型对含氮有机物如N,N-二甲基甲酰胺(DMF)、正丁胺、环己胺、苯胺、硝基苯等深度氧化的活性及控NO_x能力。实验结果表明,由PCN-1、PCN构成的双催化剂处理DMF或DMF与甲苯、DMF与甲乙酮的混合蒸气,其氧化活性和控NO_x能力比单一催化剂为好。在240—300℃温度范围即可完全氧化,控NO_x率达98％以上,净化气无色无臭。本工艺可用于PU合成革生产线烘道排气的净化处理。     

新型汽车尾气净化催化剂的研究

研究Ｌａ－Ｃｏ－Ｃｕ－Ｍｎ－Ｃｅ－Ｐｄ催化剂的活性和热稳定性,结果表明,该催化剂具有低温活性良好、活性高以及热稳定性好的性能特点,对ＣＯ、ＨＣ氧化的Ｔ５０％和Ｔ１００％分别约为１８２℃,２３８℃和２４０℃、２６５℃,催化剂表面组分发生强相互作用形成３种活性中心,是催化剂低的起燃温度,高活性的原因。催化剂高温处理后未发生烧结,活性未下降,热稳定性良好。     

Application of red mud as a basic catalyst for biodiesel production

Red mud was investigated in triglyceride transesterification with a view to determine its viability as a basic catalyst for use in biodiesel synthesis.The effect of calcination temperature on the structure and activity of red mud catalysts was investigated.It was found that highly active catalyst was obtained by simply drying red mud at 200°C.Utilization of red mud as a catalyst for biodiesel production not only provides a cost-effective and environmentally friendly way of recycling this solid red mud waste,significantly reducing its environmental effects,but also reduces the price of biodiesel to make biodiesel competitive with petroleum diesel.     

Photocatalytic degradation of dye effluent by titanium dioxide pillar pellets in aqueous solution

Photocatalytic oxidation (PCO) process is an effective way to deal with organic pollutants in wastewater which could be difficult to be degraded by conventional biological treatment methods. Normally the TiO2 powder in nanometre size range was directly used as photocatalyst for dye degradation in wastewater. However the titanium dioxide powder was arduous to be recovered from the solution after treatment. In this application, a new form of TiO2(i. e. pillar pellets ranging from 2.5 to 5.3 mm long and with a diameter of 3.7 mm) was used and investigated for photocatalytic degradation of textile dye effluent. A test system was built with a flat plate reactor(FPR) and UV light source(blacklight and solar simulator as light source respectively) for investigating the effectiveness of the new form of TiO2. It was found that the photocatalytic process under this configuration could efficiently remove colours from textile dyeing effluent. Comparing with the TiO2 powder, the pellet was very easy to recovered from the treated solution and can be reused in multiple times without the significant change on the photocatalytic property. The results also showed that to achieve the same photocatalytic performance, the FPR area by pellets was about 91% smaller than required by TiO2 powder. At least TiO2 pellet could be used as an alternative form of photocatalyst in applications for textile effluent treatment process, also other wastewater treatment processes.     

臭氧催化氧化控制溴酸盐生成效能与机理

比较了单独臭氧氧化和金属氧化物存在下臭氧催化氧化过程中溴酸盐的生成规律,探讨了催化剂投量、溴离子浓度、水的pH值、反应温度等对臭氧催化氧化控制溴酸盐生成的影响规律及在催化剂存在下控制溴酸盐生成的机理.结果表明,催化剂投量从0 mg/L增加到250 mg/L,能减少溴酸盐生成量85.1%;当溴离子浓度为0.5、1.0、2.0 mg/L时,臭氧催化氧化分别能减少溴酸盐生成量69.2%、83.5%和15.2%,溴离子浓度变化对催化作用的影响无明显规律;pH值升高会降低催化作用的效果;反应温度在5～25℃之间时,臭氧催化氧化能降低43%～59%的溴酸根生成量(溴离子浓度1.5 mg/L),反应温度变化不影响催化效果.催化剂通过抑制臭氧对次溴酸的氧化减少了溴酸根的生成量.催化剂表面的某些基团与硫酸根络合会削弱臭氧催化氧化控制溴酸根生成的能力,因此,利用催化剂控制溴酸盐的机理与催化剂表面性质密切相关.     

非热等离子体与催化相结合去除气相低浓度苯系物

利用串齿线-简体构成的等离子体反应器,研究了非热等离子体及其与Pt/Al2O3或Mn/Al2O3催化剂组合作用下的苯系物转化率、COx产率和O3生成情况.结果表明.苯系物转化率排序为对二甲苯＞甲苯＞苯.产生非热等离子体的放电区后接Pt/Al2O3或Mn/Al2O3催化剂可提高苯系物的转化率,并使达到相同转化率所对应的电压降低1～2kV,等离子体与催化剂之间表现出明显的协同效应.非热等离子体放电与Pt/Al2O3或Mn/Al2O3催化剂组合后也有利于苯系物向COx转化及去除放电产生的O3,可使最大COx产率从80%分别提高到86%和100%,而反应器出口的最大O3浓度则从707mg·m-3分别降至339mg·dm-3和39mg·dm-3.经过等离子体反应器、催化剂以及两者组合方式的优化,等离子体放电协同Mn/Al2O3催化剂工艺有望成为处理气相低浓度有机物的实用方法.     

汽车排气污染与治理的发展和动向

简介了汽车排气污染对人类健康和生态环境的影响；描述了世界汽车增长与排气污染的现状和发展趋势；综述了汽车排气催化净化技术所面临的挑战和最新研究动向。     

液相催化脱硫技术在镍铜冶炼废气治理中的应用探讨

采用二级无喷头脱硫塔和含Mn2 /Fe2 催化剂的石灰水溶液吸收高浓度SO2技术对镍铜冶炼废气进行处理。结果表明,在确定的条件下,脱硫效率达78%以上。在同一流程中同时完成除尘与脱硫过程,设备投资少;脱硫产品石膏可作水泥制造添加剂,运行费用低;设计采用无喷嘴技术,在高pH值条件下吸收,长期运转不结垢,可靠性高。     

萃取法由废催化剂制取钼酸铵

用季胺盐作萃取剂，采用一级萃取回收废催化剂中的钼，其钼回收率可达９０％，反萃液可直接得到四钼酸铵，工艺简单，操作方便，具有显著的经济效益和一定的环境效益。