Efficient low-temperature soot combustion by bimetallic Ag–Cu/SBA-15 catalysts

In this study, the effects of copper(Cu) additive on the catalytic performance of Ag/SBA-15 in complete soot combustion were investigated. The soot combustion performance of bimetallic Ag–Cu/SBA-15 catalysts was higher than that of monometallic Ag and Cu catalysts. The optimum catalytic performance was acquired with the 5 Ag_1-Cu_(0.1)/SBA-15 catalyst, on which the soot combustion starts at T_(ig)= 225°C with a T_(50)= 285°C. The temperature for 50% of soot combustion was lower than that of conventional Ag-based catalysts to more than 50°C(Aneggi et al., 2009). Physicochemical characterizations of the catalysts indicated that addition of Cu into Ag could form smaller bimetallic Ag–Cu nanolloy particles, downsizing the mean particle size from 3.7 nm in monometallic catalyst to 2.6 nm in bimetallic Ag–Cu catalyst. Further experiments revealed that Ag and Cu species elicited synergistic effects, subsequently increasing the content of surface active oxygen species. As a result, the structure modifications of Ag by the addition of Cu strongly intensified the catalytic performance.     

金催化剂在活性碳上负载活性的研究

探索了以活性炭为载体制备负载型金催化剂的可行性。大量实验表明,将金直接负载在活性炭上,不能够得到具有很好催化活性的催化剂。而以MOx/C作为复合载体能够制备得到具有较高催化活性的金催化剂。进一步探讨了焙烧条件,以及不同载体材料对金催化剂活性的影响。     

低贵金属含稀土复合型汽车排气净化催化剂研究

研究了３种低钯含稀土复合型汽车排气净化催化剂的制备工艺条件、活性和热稳定性。结果表明：所研制的催化剂对ＣＯ、ＨＣ的起燃温度分别在１８２℃～２１０℃之间；完全氧化温度在２３０℃～２５０℃之间。具有起燃温度低、活性高的特性。高温处理后，Ｔ５０％和Ｔ１００％仅上升了８℃～２４℃，说明热稳定性良好。少量贵金属Ｐｄ分浸法以及在活性氧化铝涂层上使用无机胶粘剂的制备工艺能提高催化剂的热稳定性     

TiO2/活性炭负载光催化剂的制备与光催化性能

以粒状活性炭为载体,钛酸丁酯和乙醇为原料,用溶胶-凝胶法及浸渍法制备负载型TiO2光催化剂.通过加入不同分子量和质量的聚乙二醇降低催化剂表面TiO2的粒径,增大比表面积,提高TiO2/C光催化剂的吸附性和光催化活性.以XDA、SEM、TG-DTA、比表面积、亚甲蓝吸附值、钛的负载量及对亚甲蓝的光催化降解性能对催化剂样品进行了表征.结果表明加入1.0 g PEG2000所制备的TiO2/C前驱体经过450℃焙烧后,TiO2的平均晶粒尺寸为12.9 nm,其晶型为锐钛矿型,其比表面积为997.0m2·g-1,对亚甲蓝的吸附值比活性炭基体增加22.5%,100mg·L-1的亚甲蓝溶液用该催化剂在pH为1.0～9.25范围内,2.5 h的降解率达82.5%～96%.     

铂、钯蜂窝催化剂高温老化对甲醇深度氧化的影响

本研究对铂、钯蜂窝催化剂及分别添加助化剂CeO_2或WO_3,并于500℃、700℃、900℃或1100℃下经受热老化4h后,考察催化剂比表面、晶相结构及其对甲醇深度氧化活性、产物分布及反应动力学网络变化的情况。实验证明,添加CeO_2后,降低了铂催化剂的耐高温性能,但对钯催化剂无明显影响。添加WO_3,降低了钯催化剂对甲醇的氧化活性。经X-线衍射分析证明,在1100℃高温下,WO_3与堇青石载体中的氧化镁和氧化钙发生强相互作用,生成了相应的钨酸盐。甲醇氧化反应动力学研究表明,甲醇在新鲜和高温热老化的铂催化剂上,反应动力学网络表示式是有区别的。     

基于CWPO法处理垃圾渗滤液的CuO/TiO_2催化剂的制备及其性能研究

采用过量浸渍的方法制备CuO/TiO_2催化剂,以垃圾转运站的渗滤液为对象评价催化剂的活性及稳定性。采用XRD、SEM、BET对催化剂进行了表征,并利用催化湿式氧化法处理垃圾渗滤液。考察了制备过程中煅烧温度、煅烧时间、负载比以及浸渍液浓度对垃圾渗滤液处理效果的影响。结果表明:煅烧温度为300℃,煅烧时间为2 h,负载比为16.5%,浸渍液浓度为0.8 mol/L条件下,渗滤液COD去除率达到78.6%,脱色率达到88.2%。     

SCR脱硝机组空气预热器堵塞治理建议

燃煤机组安装SCR脱硝装置后,空气预热器堵塞成为普遍现象,严重影响机组的安全性、经济性。通过对空气预热器堵塞物成分分析,提出治理空气预热器堵塞技术路线,结合实际运行中出现的问题,探寻SCR脱硝机组氨逃逸率高、SO_3浓度高、排烟温度低的原因,并且分析这些因素对空气预热器堵塞程度的影响,建议从保持催化剂活性,确保NO_x浓度,氨逃逸率均匀分布,防止氨过喷,降低入炉煤含硫量,提高锅炉排烟温度等方面,综合治理空气预热器堵塞,并提出详细的建议。     

Effects of alkali promoters on the textural and catalytic properties of mesoporous Fe–Al–Cu catalysts for water gas shift reaction

Mesoporous Fe₂O₃–Al₂O₃–CuO catalysts promoted with alkali oxides were synthesized and used in water gas shift reaction (WGSR) at high temperatures for hydrogen purification. These chromium-free catalysts were characterized using nitrogen adsorption/desorption, hydrogen temperature programmed reduction, X-ray diffraction (XRD), and transmission electron microscopy techniques. The synthesized catalysts with narrow single-modal pore size distribution in mesopore region possessed high specific surface area. The catalytic results revealed that except Cs, the addition of other alkali promoters declined the catalytic activity. However, all catalysts showed higher catalytic performance than the conventional commercial catalyst. The results showed an optimum content of Cs promoter (3 wt.%) for the promoted Fe–Al–Cu catalyst (3 wt.% Cs-FAC), which exhibited the highest activity in WGSR at high temperature.     

SO2/SO3对选择性催化还原烟气脱硝的影响研究

研究表明，燃料燃烧过程中不同的SO2/SO3转化率对选择性催化还原（ Selective Catalytic Reduction，SCR）烟气脱硝的最低运行温度影响大，温度变化幅度为10~15℃。对燃烧高硫煤锅炉的SCR烟气脱硝，应控制更低的SO2/SO3转化率；对燃烧低硫煤锅炉的SCR烟气脱硝，通过适当提高SO2/SO3转化率，最大催化剂用量可减少一半、烟气阻力降低一半，可大幅降低SCR烟气脱硝建设成本和运行成本。     

Low-temperature VOCs oxidation performance of Pt/zeolites catalysts with hierarchical pore structure

Different zeolites supported Pt catalysts with micro-mesoporous structure were prepared by organic base tetrapropylammonium hydroxide (TPAOH) treatment and their catalytic oxidation activity for various volatile organic compounds (VOCs) were evaluated. The results reveal that the synergistic effect between Pt nanoparticles and surface acid sites plays an important role in VOCs low-temperature removal. The small size and high dispersion of Pt nanoparticles on the surface of the zeolites would promote the catalytic oxidation of aromatics and alkanes over the Pt/zeolite catalysts, while strong acidity and abundant acid sites of catalysts are in favour of the oxidation of the VOCs containing N and O heteroatoms. In addition, it was found that Pt/ZSM-5 catalyst exhibits the highest oxidation activity for various VOCs low-temperature removal amongst all the catalysts due to the balance of both Pt dispersion and abundant acid sites in the catalyst. This comprehensive consideration should be very helpful when designing and preparing novel catalysts for the low-temperature removal of VOCs.