首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   1993篇
  免费   160篇
  国内免费   290篇
安全科学   316篇
废物处理   143篇
环保管理   408篇
综合类   1045篇
基础理论   177篇
环境理论   4篇
污染及防治   207篇
评价与监测   67篇
社会与环境   57篇
灾害及防治   19篇
  2024年   1篇
  2023年   15篇
  2022年   24篇
  2021年   45篇
  2020年   67篇
  2019年   60篇
  2018年   38篇
  2017年   57篇
  2016年   84篇
  2015年   73篇
  2014年   88篇
  2013年   160篇
  2012年   179篇
  2011年   168篇
  2010年   110篇
  2009年   149篇
  2008年   84篇
  2007年   123篇
  2006年   120篇
  2005年   101篇
  2004年   93篇
  2003年   102篇
  2002年   103篇
  2001年   70篇
  2000年   71篇
  1999年   55篇
  1998年   46篇
  1997年   57篇
  1996年   33篇
  1995年   32篇
  1994年   8篇
  1993年   7篇
  1992年   5篇
  1990年   1篇
  1988年   1篇
  1987年   3篇
  1986年   3篇
  1985年   1篇
  1984年   1篇
  1981年   1篇
  1979年   3篇
  1970年   1篇
排序方式: 共有2443条查询结果,搜索用时 15 毫秒
951.
对含高浓度硫酸根离子的强酸性油脂废水进行了絮凝预处理实验研究.实验表明,对COD浓度20 000~30 000 mg/L、硫酸根离子浓度约30 000 mg/L的废水,室温条件下用石灰将pH值调至7~9,投加PAC 4 g/L,快速搅拌(约180 r/min)1 min,投加PAM 20 mg/L,再慢速搅拌(约50 r/min)5 min,COD去除率可达到31.0%~43.2%,而硫酸根离子的去除率可达到90%以上,大大改善了后续生化处理的条件.  相似文献   
952.
为有效预警原油储备区储罐气体泄漏,制定气体探测器布置优化方案,以某大型原油站库为例,基于CFD法和FLACS软件模拟原油泄漏及可燃蒸汽云溢散分布,通过分析蒸汽云扩散规律,实现全方位气体探测器优化布置.结果表明:原油储罐区探测器分别布置在区块21-2、6-1、31-1、40-2,且每个罐组总计布置16处;优化设置方案可满...  相似文献   
953.
煤焦油加氢制燃料油的试验研究   总被引:2,自引:0,他引:2  
实验室研究利用煤焦油研制汽柴油替代品燃料油.以高温煤焦油为原料,选择加氢保护剂、脱金属剂及加氢精制催化剂,采用加氢工艺,脱除煤焦油中硫、氮、氧和金属等有害杂质,使煤焦油中烯烃饱和,从而改善煤焦油质量,制得合格的汽油、柴油替代品燃料油.  相似文献   
954.
针对近年来加油站三次油气回收设备排放频繁超标的问题,对加油站已投用的三次油气回收设备进行调研分析,找出导致三次油气回收设备排放超标的原因,通过数据模拟对相关结论进行验证,提出解决三次油气回收设备超标排放问题的技术提升措施。  相似文献   
955.
通过系统的监测了解吉林地区采油厂原油含水率分析仪的工作场所放射防护现状,为放射源监督管理部门提供参考依据,为保护环境、保护放射工作人员职业健康提供重要保障,为采油厂对辐射装置管理及措施提供依据.采用国家规定的标准方法对吉林省不同工作环境下的5家采油厂的45台原油含水率分析仪的周围剂量当量进行现场监测,对涉及接触原油含水...  相似文献   
956.
为揭示剪切闸板在纯剪切工况条件下(无压差、无悬重)剪切钻杆时剪切力特征,以及悬重、内外压差等复杂工况条件对剪切钻杆时剪切力和油压的影响规律。本文基于Shear Damage断裂损伤模型,通过显示动力学方法开展剪切过程仿真研究。研究结果表明:在纯剪切工况条件下,剪切力随时间增加先逐渐增加再急剧下降为0;在有悬重工况条件下,剪切力和油压随悬重增加而呈减小趋势;在钻杆内压大于外压工况条件下,剪切力和油压均随压差增大而增大;在钻杆内压小于外压工况条件下,剪切力随压差增大而减小,5in(壁厚14.50 mm)、5 in(壁厚12.70 mm)规格钻杆油压随压差增大呈先增加后减小趋势,5in(壁厚10.54 mm)规格钻杆油压随压差变化不明显,其余钻杆油压随压差增大均呈上升趋势。研究结果可为剪切闸板防喷器油压配置、结构优化、关井工艺改进等提供关键技术支撑。  相似文献   
957.
介绍了采油队安全生产巡视管理系统的组成、系统配置与工作过程,叙述了试验与应用情况,分析了其经济效益和社会效益与推广应用前景。  相似文献   
958.
宜宾植被为亚热带常绿阔叶林,植物资源十分丰富,目前对树叶开发利用主要是茶叶、挥发油、蚕桑、中药材等。本文论述了宜宾植物资源开发的种类、经济效益及其前景。  相似文献   
959.
Reef blocks made from stabilized oil ash were taken from the sea after five years in the ocean to examine the chemical behaviour of calcium. Experiments included (1) determination of the calcium leaching rate and a comparison with the rate for unexposed blocks to test the validity of a diffusion model for predicting long term (5 years) leaching rates, (2) determination of the effect of biological cover (shell) on the leaching rate, (3) determination of the leaching rate of the core of exposed reef blocks, (4) determination of the calcium content in 'ring areas' - regions of discoloration observed in sectioned exposed reef blocks, and (5) determination of the leachable fraction of the total calcium in exposed reef blocks. Results showed the presence of a pronounced calcium discontinuity zone located 3-7 cm from the outside surface of the reef blocks. Cumulated calcium release rates ranged from 2.81-3.14 μmol cm-2 day-1 for original unexposed reef blocks and the core of exposed (in the ocean for five years) blocks, respectively, to 0.47-0.50 μmol cm-2 day-1 for outside (facing sea water) surfaces of exposed reef blocks. Tank leaching studies also showed that the presence or absence of hard biological cover (shells) had little or no effect on the calcium release rate. the diffusion model normally used in modelling the chemical behaviour of calcium cannot be used to predict the long term (five years) leaching of calcium. the core of the exposed blocks released calcium at a rate similar to new, unexposed reef block material. Overall, it appears that the calcium discontinuity zone is probably responsible for restricting the release of calcium and hence the failure of the diffusion model.  相似文献   
960.
复合高分子絮凝剂处理奥里乳化油船舶压载污水的探讨   总被引:2,自引:0,他引:2  
通过大量实验,探讨了复合高分子絮凝剂PCM处理奥里乳化油污水的最佳投入量、沉降时间,并与其它絮凝剂进行了比较实验。实验表明:PCM絮凝剂处理效果明显、成本较低,适用于奥里乳化油船舶压载污水处理。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号