Integrated coastal management: top-down vs. community-based approaches

In this paper, a dynamic model is developed in which coastal quality can be improved, restored, or maintained by two distinct user groups; this is done by identifying a context that ensures an increase (or a greater increase) in coastal quality in terms of specific features that characterise the user groups. The results demonstrate that integrated coastal management is always better than non-integrated management. Moreover, when there is a low degree of interest in maintaining the coastal use over time, only integrated community-based (CB) coastal management will increase the coastal quality. Even when the interest in maintaining the coastal use over time is high, an integrated CB approach is preferred if the willingness to pay for coastal improvements is great and the marginal inefficiency of investments in coastal improvements is low, because the coastal quality improves to a greater extent; if not, only an integrated top-down (TD) approach to coastal management will increase the coastal quality. These results suggest that developing countries should always adopt a CB approach; in contrast, developed countries should adopt a CB approach where local stakeholders attach direct values to the coastal quality, and adopt a TD approach where the general population attaches indirect (option or existence) values to coastal quality.     

Enhancement of turbulent scalar mixing and its application by a multihole nozzle in selective catalytic reduction of NOx

The mixing characteristics of a passive scalar in the turbulent flow of a selective catalytic reduction process were numerically and experimentally investigated, focusing especially on an injection nozzle with multiple holes for the reducing agent. The multihole injection nozzle studied has six holes that are perpendicular to the ambient flue gas flow and are located near the tip of the nozzle. Large eddy simulation was applied to the turbulent flow and mixing fields to elucidate the mixing mechanism of the proposed nozzle compared with the single-hole nozzle that is commonly used in the conventional selective catalytic reduction process. From the results, there exist broader regions of higher turbulent intensities for the multihole nozzle than for the conventional single-hole nozzle. These regions are well matched with the positions of high vorticity in the near upstream region of the jet flow issuing from the multiple holes of the nozzle. Consequently, the high turbulent intensities and vorticity magnitudes lead to intensified mixing between the flue gas and the reducing agent. Hence, the most suitable molar ratio between NOx and the reducing agent for the catalytic reaction can be easily obtained within a shorter physical mixing length as a result of the enhanced scalar mixing. Finally, the numerical results were applied to a trial design version of a multihole nozzle, and this nozzle was experimentally tested to confirm its mixing performance.     

Mixing Processes in Geophysical and Astrophysical Flows – A Conference Report

The Third ERCOFTAC conference on `Mixing in Geophysical and Astrophysical Flows' was held at the University of Sheffield over the period 12–14 April 2000. The meeting attracted over forty participants from ten different countries. Some delegates had travelled from as far as U.S.A., Venezuela, Australia, Russia and Sweden to attend the conference. Nine invited papers were presented along with twenty-seven contributed oral presentations and six posters. The main topics discussed included stratified and rotating flows, gravity waves, turbulence and mixing. The presentations are summarised in this report, which aims to provide a broad account of current topics of interest related to mixing processes in geophysical and astrophysical flows.     

厌氧系统中碱处理对污泥减量的影响

碱解预处理污泥和原污泥按一定比例进行混合后,投入厌氧反应器中进行消化,研究其对污泥减量化的影响。结果表明,该处理既可以提高污泥减量率,又能改善污泥厌氧消化性能,提高污泥产气量。当碱处理污泥和原污泥混合比为1∶3时,在混合初期由于稀释作用和水解中和作用,溶液的pH能迅速恢复到中性。SS减少48%,较对照组提高了10%;SCOD减少约80%,较对照组提高20%,而空白对照组因未发生溶胞作用,各参数值均处于较低水平,降解率也维持在较低水平。     

袋式除尘器在沥青混凝土搅拌设备上的应用

分析了沥青混凝土搅拌设备的构成以及生产沥青混凝土的工艺及烟尘特点;通过应用工程实例,指出袋式除尘器是沥青混凝土搅拌设备最理想的除尘系统之一。     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

气象因素对输变电线路电磁环境的影响

不考虑气象因素的输变电线路的电磁环境预测值与实际值之间有差距,探讨了温度、湿度、风等气象因素对输变电线路电磁环境的影响,并提出减缓措施。结果表明:温度上升,则电磁场强度及无线电干扰强度都会增强;高相对湿度下电磁场强度与湿度成正比,低湿度则无明显影响,湿度对无线电干扰的影响与线路电压有关;风使输电线发生偏移,改变空间电磁场强度。     

Molecular composition of recycled organic wastes,as determined by solid-state 13C NMR and elemental analyses

Using solid state ¹³C NMR data and elemental composition in a molecular mixing model, we estimated the molecular components of the organic matter in 16 recycled organic (RO) wastes representative of the major materials generated in the Sydney basin area. Close correspondence was found between the measured NMR signal intensities and those predicted by the model for all RO wastes except for poultry manure char. Molecular nature of the organic matter differed widely between the RO wastes. As a proportion of organic C, carbohydrate C ranged from 0.07 to 0.63, protein C from <0.01 to 0.66, lignin C from <0.01 to 0.31, aliphatic C from 0.09 to 0.73, carbonyl C from 0.02 to 0.23, and char C from 0 to 0.45. This method is considered preferable to techniques involving imprecise extraction methods for RO wastes. Molecular composition data has great potential as a predictor of RO waste soil carbon and nutrient outcomes.     

IDENTIFICATION OF DISSOLVED-CONSTITUENT SOURCES IN MINE-SITE GROUND WATER USING BATCH MIXING1

ABSTRACT: Batch-mixing experiments were used to help identify lithologic and mineralogic sources of increased concentrations of dissolved solids in water affected by surface coal mining in northwestern Colorado. Ten overburden core samples were analyzed for mineral composition and mixed with distilled water for 90 days until mineral-water equilibrium was reached. Between one day and 90 days after initial contact, specific conductance in the sample mixtures had a median increase of 306 percent. Dissolved-solids concentrations ranged from 200 to 8,700 mg/L in water samples extracted from the mixtures after 90 days. Mass. balance simulations were conducted using the geochemical models BALANCE and WATEQF to quantify mineral-water interactions occurring in five selected sample mixtures and in water collected from a spring at a reclaimed mine site. The spring water is affected by mineral-water interactions occurring in all of the lithologic units comprising the overburden. Results of the simulations indicate that oxidation of pyrite, dissolution of dolomite, gypsum, and epsomite, and cation-exchange reactions are the primary mineral-water interactions occurring in the overburden. Three lithologic units in the overburden (a coal, a sandstone, and a shale) probably contribute most of the dissolved solids to the spring water. Water sample extracts from mixtures using core from these three units accounted for 85 percent of the total dissolved solids in the 10 sample extracts. Other lithologic units in the overburden probably contribute smaller quantities of dissolved solids to the spring water.     

CONCEPTUAL DESIGN PROCEDURE FOR HYDRAULIC DESTRATIFICATION SYSTEMS IN SMALL PONDS,LAKES, OR RESERVOIRS FOR WATER QUALITY IMPROVEMENT1

ABSTRACT: Forced artificial mixing of temperature-stratified ponds, or small lakes or reservoirs, by liquid jets can enhance water quality and can also be energy efficient. Based on previous studies of jet mixing mechanics of stratified water bodies, a conceptual design approach is presented. The main “operational” and “system” design parameters are considered in the proposed method. Using minimization of a total cost estimate as a criterion, an iterative method for the selection of the number and size of the jets is developed and illustrated.