华北平原玉米-小麦轮作农田N2O交换通量的研究

以华北地区冬小麦-夏玉米轮作农田为研究对象,运用静态箱法对正常施肥及正常施肥结合秸秆还田农田N2O交换通量进行了连续1 a对比研究.正常施肥及正常施肥结合秸秆还田样地N2O全年的累积排放量分别为7.61 kg.hm-2和12.6kg.hm-2,其中秸秆还田引起N2O排放明显增加主要发生在玉米生长季节.两种处理样地在玉米季N2O的排放量占全年累积排放的57%～86%,表明华北玉米-小麦轮作体系中N2O排放主要集中在玉米季.各次施肥后10 d内N2O的累积排放量约占全年总排放量的71%～88%,显然现有化肥极大促进了华北农田N2O排放.     

多层填料生物转鼓去除NO废气的效能比较研究

生物转鼓过滤器能有效去除一氧化氮(NO)废气,为进一步提高生物转鼓过滤器的去除效能,实验改变了生物转鼓的填料结构,并与单层填料的生物转鼓进行了比较研究.结果表明,多层填料生物转鼓比单层填料生物转鼓更能有效去除NO,运行也更加稳定.8个月的连续运行实验表明,多层填料生物转鼓对NO去除率稳定在53.9％ ～93.4％之间,平均去除效率79.8％,而单层填料生物转鼓的平均去除率仅有68.7％;在相同实验条件下,空床停留时间(EBRT)可从单层填料生物转鼓的86.4 s降至多层填料生物转鼓的57.6 s.多层填料生物转鼓的最优工艺条件为,营养液量为1.3～3L,转速为0.75 r·min-1,在以葡萄糖为碳源时,TOC＞ 1250 mg·L-1后,去除效率增长幅度趋于平缓.     

乙醇处理对树脂基纳米水合氧化铁结构及其除砷性能的影响

通过考察乙醇处理对树脂基纳米水合氧化铁(D201-HFO)结构及其除砷性能的影响,评价乙醇处理在复合材料制备中的必要性.结果表明,乙醇处理后负载水合氧化铁(HFO)在D201树脂内的分散性增加,材料对砷的饱和吸附量提高约20%,且复合材料的比表面积、孔容、孔径分别增加了52%、65%、28%;但乙醇处理对复合材料的机械强度和负载HFO的晶型无影响,在pH值、离子竞争对该材料除砷性能的影响趋势方面也无明显作用,对复合材料固定床除砷性能及再生方面也无明显作用.总体而言,乙醇处理对D201-HFO复合材料实际除砷性能影响不大,从技术经济性考虑可以省略.     

Effect of ammonium on nitrous oxide emission during denitrification with different electron donors

Nitrous oxide(N2O) emission during denitrification is receiving intensive attention due to its high potential to cause greenhouse effects.In this study,denitrifiers were acclimated in sequencing batch reactors with methanol or acetate as the electron donor and nitrate as the electron acceptor.The effects of ammonium on N2O emission were examined in batch experiments with various electron donors.With the addition of ammonium,N2O emission increased under all the examined conditions compared to experiments without ammonium addition.With different electron donors,the highest ratio of N2O emission to the removed oxidized nitrogen was 0.70% for methanol,5.34% for acetate,and 34.79% for polyhydroxybutyrate.     

除镉最佳混凝剂的筛选及应用条件研究

通过采用聚合氯化铝铁（PAFC）、氯化铁（FeCl3）及聚合硫酸铁（PFS）对含镉废水的处理研究表明,三种混凝剂对含镉水体均有良好的处理效果,同等条件下,三种混凝剂对含镉水体去除率分别为98.22%、92.19%和93.63%。研究了PAFC对含镉水体的混凝沉淀效果,实验结果表明：碱性条件有利于镉离子的沉淀,当pH为9～11时,去除率可达98.00%左右;对于初始浓度为4.000 0 mg.L-1的含镉废水,经处理后,水体浓度可降至0.184 0 mg.L-1,对于初始浓度为0.400 0 mg.L-1的含镉废水,经处理后水体浓度降至0.007 2 mg.L-1;废水中投加一定量的石灰乳对PAFC除镉起一定的作用,投加量达30.00 mg.L-1时,其去除率达99.91%;通过对PAFC除镉动力学拟合,符合一级线性动力学方程。     

FeⅡ(EDTA)络合协同RDB去除NO废气效能及过程分析

为进一步提高一氧化氮(NO)的去除效率,在新型生物转鼓反应器(rotating drum biofilter,RDB)中,以FeⅡ(EDTA)络合协同RDB生物转鼓的耦合技术强化难水溶性NO的气液传质速率,提高生物还原效能为目标进行了研究.结果表明,适量FeⅡ(EDTA)被添加到RDB底部营养液后,能迅速吸收气相中的NO并生成FeⅡ(EDTA)-NO络合物,进而可通过反硝化实现同步脱氮和络合剂再生.在转速0.5 r.min-1、空床停留时间(EBRT)57.7 s、温度30℃、pH 7～8的实验条件下,RDB的净化效能随络合剂的投加而显著改善;FeⅡ(EDTA)质量浓度从0增至500 mg.L-1后,NO去除率从61.1%提高到97.6%,去除负荷从16.2 g.(m3.h)-1上升到26.7 g.(m3.h)-1.分析了FeⅡ(EDTA)络合协同净化NO的反应过程,建立了NO净化效率与FeⅡ(EDTA)添加浓度的关联方程,可较好地拟合实验数据.     

胶州湾及邻近海域表层海水中一氧化氮浓度分布及其影响因素探讨

2011年2～3月利用化学发光法对胶州湾及邻近海域表层海水中一氧化氮(NO)浓度进行了监测.结合水文、化学和生物等要素的同步观测资料,对该海域NO浓度分布及其影响因素进行了探讨.结果表明,胶州湾内表层海水中NO浓度为0.080～0.493 nmol.L-1,平均值为(0.292±0.146)nmol.L-1,胶州湾外NO浓度为未检出～0.435 nmol.L-1,平均值为(0.160±0.130)nmol.L-1.总体来说,胶州湾表层海水中NO浓度呈现出自湾内向湾外递降的分布趋势,陆地径流和人为活动可能对NO浓度的分布造成一定程度的影响.胶州湾及邻近海域表层海水中NO浓度比开阔大洋高1个数量级.周日变化研究表明,NO浓度具有一定的变化特征,最大值出现在15:00,这可能主要受光照的影响.影响NO浓度分布的因素比较复杂,可能主要受亚硝酸盐、光强和pH等因素的影响.结果表明,2011年春季胶州湾及邻近海域表层海水是大气NO的源,通量约为1.09×10-15 mol.(cm2.s)-1.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

Effect of C/N ratio, aeration rate and moisture content on ammonia and greenhouse gas emission during the composting

Gaseous emission (N₂O, CH₄ and NH₃) from composting can be an important source of anthropogenic greenhouse gas and air pollution. A laboratory scale orthogonal experiment was conducted to estimate the effects of C/N ratio, aeration rate and initial moisture content on gaseous emission during the composting of pig faeces from Chinese Ganqinfen system. The results showed that about 23.9% to 45.6% of total organic carbon (TOC) was lost in the form of CO₂ and 0.8% to 7.5% of TOC emitted as CH₄. Most of the nitrogen was lost in the form of NH₃, which account for 9.6% to 32.4% of initial nitrogen. N₂O was also an important way of nitrogen losses and 1.5% to 7.3% of initial total nitrogen was lost as it. Statistic analysis showed that the aeration rate is the most important factor which could affect the NH₃ (p = 0.0189), CH₄ (p = 0.0113) and N₂O (p = 0.0493) emissions significantly. Higher aeration rates reduce the CH₄ emission but increase the NH₃ and N₂O losses. C/N ratio could affect the NH₃ (p = 0.0442) and CH₄ (p = 0.0246) emissions significantly, but not the N₂O. Lower C/N ratio caused higher NH₃ and CH₄ emissions. The initial moisture content can not influence the gaseous emission significantly. Most treatments were matured after 37 days, except a trial with high moisture content and a low C/N ratio.