关于水中硫化物测定几个影响因素的探讨

本文通过改变实验室温度、显色时间、是否加入乙酸锌-乙酸钠、稀释水的酸碱性等试验条件,探讨硫化物的最佳测定条件。试验结果表明,在温度为18~22℃、稀释水p H在8~10、使用液中加入乙酸锌-乙酸钠时,采用亚甲基蓝分光光度法测定硫化物标准样品,可以得到较准确的测定结果。     

高效产H_2O_2气体扩散电极的研究

采用C/PTFE气体扩散电极在无隔膜体系中进行H2O2发生工艺研究,探讨了石墨和Vulcan XC-72碳黑两种碳材料以及电解电压、p H值对该反应过程的影响.结果表明,在较低的空气流量(1.41 cm3·min-1·cm-2)下,以Vulcan XC-72碳黑为表面的气体扩散电极相比石墨电极有较高的H2O2产率和电流效率,碱性条件比酸性条件下H2O2产率和电流效率更好;在2.6 V恒定电压下,2 h后,H2O2浓度达到了250 mg·L-1,电流效率从69.8%降到44.7%,单位产量能耗从5.87 k Wh·kg-1升高到9.16 k Wh·kg-1.     

Effect of hydrogen sulfide in comparison to atorvastatin on endothelial damage in cholesterol-fed rabbits

Hydrogen sulfide (H₂S) is an endogenous gaseous molecule, functioning as a physiological regulator. This study aimed to investigate the role of H₂S in atherosclerosis. Rabbits receiving high cholesterol were given atorvastatin (10 mg/kg/day, orally) or sodium sulfide (1.1 mg/kg/day, intramuscular) 2 weeks after commencement of high-cholesterol diet and continued for 4 weeks. Serum lipid profiles, lipid peroxidation indexed as malondialdehyde, glutathione, superoxide dismutase, the vascular adhesion molecule-1, and aortic vascular endothelial growth factor were determined. Rabbits receiving a high-cholesterol diet showed elevated levels of total serum cholesterol, triglycerides, low-density lipoprotein cholesterol, malondialdehyde and vascular adhesion molecule-1, and aortic vascular endothelial growth factor expression and lower levels of high-density lipoprotein cholesterol, glutathione, and superoxide dismutase. Treatment with atorvastatin and sodium sulfide has beneficial effects on serum lipid profile, oxidative damage, vascular adhesion molecule-1, and aortic expression of vascular endothelial growth factor.     

Improving the Synthesis Gas Quality in Catalytic Gasification of Rice Straw by an Integrated Hot-Gas Cleaning System

This research investigates an enhanced removal rate of tar and trace pollutants (e.g. hydrogen chloride and hydrogen sulfide, H₂S) in the gasification of rice straw, using an integrated in situ tar reduction and hot-gas cleaning technique. The gasification temperature was set at 900°C and equilibrium ratio (ER) was 0.30 in the gasifier. In the in situ tar reduction method, the catalyst, dolomite with an amended ratio of 0–15% was introduced to the gasifier. The integrated hot-gas cleaning system applied a multi-packed tower to remove the tar, sulfur and/or chlorine byproduct in syngas at 250°C. The packed materials composed of zeolite, calcined dolomite and activated carbon. The experimental results indicated that the tar concentration of syngas was approximately 20 g/kg. However, in catalytic gasification with 5% dolomite addition, the tar concentration reduced to 17 g/kg. The tar reduction efficiency was approximately 15% by an in situ dolomite addition. When applying the integrated hot-gas cleanup system, the tar was virtually eliminated. The total tar elimination rate was almost 100% and the cleaned syngas could be applied in other energy utilization equipment. On the other hand, the H₂S and HCl concentration were 101 ppmv and 991 ppmv, respectively. After the integrated syngas cleaning system, the H₂S and HCl were decreased to 7.9 ppmv and 410 ppmv with a removal efficiency of 92.1% and 58.6%, respectively. It can be concluded that combining the in situ method with the integrated syngas cleaning system can effectively reduce the amount of byproduct and enhance the syngas quality in the gasification of rice straw.     

Characteristics and anthropogenic sources of carbonyl sulfide in Beijing

Atmosphericmixing ratios of carbonyl sulfide (COS) in Beijingwere intensivelymeasured from March 2011 to June 2013. COS mixing ratios exhibited distinct seasonal variation, with a maximumaverage value of 849 ± 477 pptv in winter and a minimal value of 372 ± 115 pptv in summer. The seasonal variation of COS was mainly ascribed to the combined effects of vegetation uptake and anthropogenic emissions. Two types of significant linear correlations (R² > 0.66) were found between COS and CO during the periods from May to June and from October to March, with slopes (ΔCOS/ΔCO) of 0.72 and 0.14 pptv/ppbv, respectively. Based on the emission ratios of COS/CO from various sources, the dominant anthropogenic sources of COS in Beijing were found to be vehicle tire wear in summer and coal burning in winter. The total anthropogenic emission of COS in Beijing was roughly estimated as 0.53 ± 0.02 Gg/year based on the local CO emission inventory and the ΔCOS/ΔCO ratios.     

Use of additive and pretreatment to control odors in municipal kitchen waste during aerobic composting

The effects of adding a bulking agent and chemically pretreating municipal kitchen waste before aerobic composting were studied using a laboratory-scale system. The system used 20-L reactors and each test lasted 28 days. The objective was to decrease NH₃ and H₂S emissions during composting. The bulking agent, dry cornstalks, was mixed with the kitchen waste to give a mixture containing 15% (wet weight) bulking agent. A combined treatment was also conducted, in which kitchen waste mixed with the bulking agent was pretreated with ferric chloride (FeCl₃). Less leachate was produced by the composted kitchen waste mixed with bulking agent than by the kitchen waste alone, when the materials had reached the required maturity. The presence of cornstalks also caused less H₂S to be emitted, but had little impact on the amount of NH₃ emitted. The FeCl₃ was found to act as an effective chemical flocculant, and its presence significantly decreased the amounts of NH₃ and H₂S emitted. Kitchen waste mixed with cornstalks and treated with FeCl₃ emitted 42% less NH₃ and 76% less H₂S during composting than did pure kitchen waste.     

Sulfide oxidation in fluidized bed bioreactor using nylon support material

A continuous fluidized bed bioreactor (FBBR) with nylon support particles was used to treat synthetic sulfide wastewater at different hydraulic retention time of 25, 50 and 75 min and upflow velocity of 14, 17 and 20 m/hr. The effects of upflow velocity, hydraulic retention time and reactor operation time on sulfide oxidation rate were studied using statistical model. Mixed culture obtained from the activated sludge, taken from tannery effluent treatment plant, was used as a source for microorganisms. The diameter and density of the nylon particles were 2-3 mm and 1140 kg/m³, respectively. Experiments were carried out in the reactor at a temperature of (30 ± 2)℃, at a fixed bed height of 16 cm after the formation of biofilm on the surface of support particles. Biofilm thickness reached (42 ± 3) μupm after 15 days from reactor start-up. The sulfide oxidation, sulfate and sulfur formation is examined at all hydraulic retention times and upflow velocities. The results indicated that almost 90%-92% sulfide oxidation was achieved at all hydraulic retention times. Statistical model could explain 94% of the variability and analysis of variance showed that upflow velocity and hydraulic retention time slightly affected the sulfide oxidation rate. The highest sulfide oxidation of 92% with 70% sulfur was obtained at hydraulic retention time of 75 min and upflow velocity of 14 m/hr.     

Clostridium papyrosolvens厌氧发酵产氢研究

采用分批培养研究了从高浓度厌氧产氢活性污泥中筛选的优势菌种Clostridium papyrosolvens的发酵产氢能力.结果表明:该菌有较强的高糖耐受性和耐酸性,当葡萄糖浓度为30 g/L、pH阶段性控制在4.5时,发酵44 h葡萄糖消耗率为83.7%,总产气量达到3 081.3 mL/L,最高产气率为187.5 mL L-1 h-1,氢气含量为67.5%,比产氢率达1.06 mol(H2)/mol(葡萄糖).研究中选用了廉价的发酵产氢培养基,以玉米浆为氮源,以还原铁粉作氧化还原电位控制剂,省去了牛肉膏、蛋白胨等昂贵氮源以及L-半胱氨酸、维生素、无机离子等高成本组分,显著降低了纯菌发酵的培养基成本,获得了较好的产氢效果.图5表2参23     

硫化氢浓度测定方法的比较和建议

本文研究了过滤式防毒面具滤毒罐防护硫化氢性能试验中,采用用碘量法和紫外光度法对硫化氢浓度测定的对比。通过试验证明了,碘量法测得的硫化氢的浓度均偏低。结果表明:紫外光度法具有良好的准确度和精确度,适用于长时间测定硫化氢混合气体浓度。     

火电机组氢冷系统安全评价

国外已经对火电厂的安全评价工作进行了一定的研究,但是国内对此项工作的研究还是比较匮乏,尤其对火电厂危险化学品更缺乏相关的安全评价方法及研究。在火力发电厂实际生产中,需使用到大量易燃、易爆危险化学品,由于使用、存储不当,极易造成重大事故。根据某火电厂实际情况,结合安全评价的基本程序,运用道(DOW)化学火灾、爆炸危险指数评价法对火电机组氢冷系统(GRH)单元进行了评价。结果显示,GRH单元的本质危险性很大,经过安全措施补偿后危险性较轻,说明利用道氏法对火电厂危险化学品使用状况进行评价,能够比较准确地反映被评价单位的实际情况,根据评价结果和存在的问题提出有针对性的对策措施,进一步改善火电机组运行环境的安全。评价结果可为火电厂提高安全管理水平提供有价值的参考。