生化-砂滤-光催化氧化处理苎麻脱胶废水

根据苎麻脱胶废水的水质特点 ,选择了水解酸化 -接触氧化 -砂滤 -光催化氧化处理工艺 ,结果表明 ,出水水质达到了GB8978 1996二级排放标准 ,大部分指标达到了一级排放标准。该工艺具有针对性强、占地面积少、运行稳定、处理费用低、操作管理方便、无二次污染等优点 ,值得推广应用     

水解酸化-好氧工艺处理感光材料有机废水研究

感光材料有机生产废水含有多种合成有机物，其BOD5／CODer比值为0．46～0．48，可生化性良好，经水解酸化处理后该废水的BOD5／CODcr的比值可提高至0．54～056，平均增加了17％左右。水解酸化－好氧串联工艺对该废水总的处理效果表明：在废水CODer进水浓度2000～2500mg／L范围内，CODer总去除率可达95％左右，BOD5总去除率可达97％左右；水解酸化后好氧生化系统的动力学半速度常数Ks＝103mg／L，最大比降解速度K＝5．0／日。     

新农药环境化学行为研究(V)-—三氟羧草醚(Acifluorfen)在土壤和水环境中的滞留、转化

从如下几方面研究了三氟羧草醚在土壤－水环境中的化学行为：一是土壤对该药的吸附，结果表明，吸附强度与土壤理化特性密切相关，Ｆｒｅｕｎｄｌｉｃｈ常数ｋｆ＝０．９４Ｗｏｍ＋０．６５Ｗｃｌａｙ－９．５９ｐＨ（ｒ＾２＝０．９４）；二是吸附机理研究，发现三氟羧草醚能与碱金属以外的许多金属离子形成配合物，并证实了与ＣＵ＾２＋形成的双核桥联合物的可能性；三是实验指出它在水中避光有一定的稳定性，不易水解；四是它在〈     

水解酸化—厌氧工艺处理高浓度抗生素废水研究

研究了水解酸化与厌氧消化组合工艺处理高浓度抗生素废水,结果表明,水解酸化反应器最大CODcr容积负荷达到 16.84kg/m3·d,复合厌氧反应器CODcr容积负荷达到8.57kg/m3·d;系统进水SO42-浓度为1325mg/L,CODcr/SO42-值最低达到 3;CODCr与SO42-总去除率分别为75.5％和95.2％,对各种抑制物质和冲击负荷表现出很好的适应性。     

HA-SBR法在制药废水中的应用

介绍SBR法在制药废水中的应用及工艺流程.通过处理COD从3600mg/l降到130mg/l.COD总去除率达到96%,出水可以达标排放.     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

Protozoan colonization on artificial substrates in relation to water quality in a tropical Indian harbour

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎａｑｕａｔｉｃｅｃｏｓｙｓｔｅｍｓｂｉｏｌｏｇｉｃａｌｃｏｍｍｕｎｉｔｉｅｓａｒｅｒｅｍａｒｋａｂｌｙｃｏｍｐｌｅｘｉｎｂｏｔｈｔｈｅｉｒｏｐｅｒａｔｉｏｎａｎｄｒｅｓｐｏｎｓｅｔｏａｎｔｈｒｏｐｏｇｅｎｉｃａｃｔｉｖｉｔｉｅｓ.Ｔｈｉｓｈａｓｌｅｄｍａｎｙｉｎｖｅｓｔｉｇａｔｏｒｓｔｏｃｏｎｄｕｃｔｌａｂｏｒａｔｏｒｙａｎｄｆｉｅｌｄｓｔｕｄｉｅｓｆｏｒｅｖａｌｕａｔｉｎｇｔｈｅｅｃｏｌｏｇｉｃａｌｒｉｓｋｐｏｓｅｄｂｙｈｕｍａｎｓｔｏｅｃｏｓｙｓｔｅｍ(Ｃａｉｒｎｓ…     

水解酸化＋两级生物接触氧化处理高盐度水产品加工废水

介绍了“水解酸化＋两级生物接触氧化”处理水产品加工废水的运行效果和工程实例，结果表明：对C1^-浓度平均6000mg／L的高盐度水产品加工废水，系统对COD、SS、氨氮的去除率分别超过了88％、90％、85％，出水COD、SS、氨氮分别低于100mg／L、70mg／L、15mg／L，出水完全可以达到《污水综合排放标准》（GB8978—1996）一级排放标准。     

Comparison of mesophilic and thermophilic anaerobic digestions of thermal hydrolysis pretreated swine manure: Process performance, microbial communities and energy balance

Anaerobic digestion (AD) of swine manure (SM) commonly shows low biogas output and unsatisfactory economic performance. In this study, thermophilic AD (TAD, 50 ± 1 °C) was combined with thermal hydrolysis pretreatment (THP, 170 °C/10 bar), to investigate its potential for maximizing biogas yield, securing successful digestion and microbial diversity, as well as improving energy balance. Four lab-scale continuously stirred tank reactors were operated for 300 days and compared with each other, i.e., reactor 1 (raw SM fed in mesophilic AD: RSM-MAD), reactor 2 (THP-treated SM fed in MAD: TSM-MAD), reactor 3 (RSM-TAD), and reactor 4 (TSM-TAD). The results showed that THP was efficient to increase methane production of SM, TSM-TAD mode led to the highest methane yield (129.8 ± 40.5 mL-CH₄/g-VS/day) among the tests (p < 0.05). Although TAD was more likely to induce free ammonia (> 700 mg/L) or volatile fatty acids (> 6000 mg/L) accumulation compared with MAD in start-up phase, TSM-TAD treatment mode behaved a sustainable digestion process in a long-term operation. For TSM-TAD scenario, higher Shannon–Weaver (3.873) and lower Simpson index (0.061) indicated this mode ensured and enlarged the diversity of bacteria communities. Phylum Bathyarchaeota was dominant (59.3%−90.0%) in archaea community, followed by Euryarchaeota in the four reactors. RSM-MAD treatment mode achieved the highest energy output (4.65 GJ/day), TSM-TAD was less effective (−17.38 GJ/day) due to increased energy demands. Thus improving the energetic efficiency of THP units is recommended for the development of TSM-TAD treatment mode.     

Treatment of black liquor from the papermaking industry by acidification and reuse

Two different kinds of black liquor from the papermaking industry were treated by acidification and reuse. The experimental parameters and conditions were discussed in detail. The experimental results indicated that the treatment process mentioned in this article is an effective process for the treatment of black liquor from the papermaking industry. By the treatment, the solid materials in black liquor are transferred into two by-products and the other components are reused or evaporated. Thus, no wastewater except some condensation water would be discharged in pulping process and the problem of oollution of black liauor would be effectively solved.