聚醚砜超滤膜接枝聚乙烯醇-氨基酸共聚物的亲水改性研究

基于聚合多巴胺的附着性及易与氨基(—NH2)等基团形成共价键的特性,本实验将聚合多巴胺作为对聚醚砜(PES)超滤膜进行表面改性的接枝中间物,将聚乙烯醇(PVA)-氨基酸共聚物接枝至PES膜表面,从而提高PES超滤膜的亲水性能.实验通过PVA与氨基酸的酯化反应形成PVA-氨基酸共聚物,将带有—NH2的共聚物与PES超滤膜表面的聚合多巴胺涂覆层形成共价键,从而将亲水的PVA-氨基酸共聚物接枝到疏水的超滤膜表面.实验利用通量的变化、红外光谱(FTIR)分析、表面接触角、场发射扫描电镜(FESEM)等手段来表征膜特征参数的变化,同时也考察了改性膜对油水乳化液的分离效率和抗污染能力.试验结果表明,经过PVA-氨基酸共聚物接枝改性的膜表面的亲水性有一定的提高,原膜接触角为91°,涂覆和接枝改性后的膜表面接触角分别为71°和53°,油水乳化液的分离实验显示,改性后的膜通量和清洗恢复率均有明显提高.     

GO-TiO2改性中空纤维膜的制备条件及抗污染性能研究

以氧化石墨烯(GO)与纳米二氧化钛(TiO_2)为改性剂,采用界面聚合法与抽滤吸附结合,对聚偏氟乙烯中空纤维超滤膜(简称原膜)进行表面改性,得到新型纳米改性膜(简称GO-TiO_2改性膜).研究改性膜的制备工艺条件及其对腐殖酸(HA)的吸附截留性能与抗污染特性.结果表明:(1)最佳制备工艺条件为:钛酸丁酯2 m L、GO 1 mg、间苯二胺1%(质量分数)、间苯二胺浸泡时间8 min、均苯三甲酰氯0.2%(质量分数)、均苯三甲酰氯浸泡时间10 min;(2)亲水性提高显著,亲水性表面为GO-聚酰胺-TiO_2复合结构,改性膜接触角由80.6°±1.8°下降到38.6°±1.2°;(3)抗污染性能提高明显.改性膜通量总衰减率由改性前的51.2%下降到35.6%,过滤周期约为原膜的2.5倍;反冲洗后膜通量恢复率由69%提高到96%.     

TiO2@palygorskite composite for the efficient remediation of oil spills via a dispersion-photodegradation synergy

• A novel and multi-functional clay-based oil spill remediation system was constructed. • TiO₂@PAL functions as a particulate dispersant to break oil slick into tiny droplets. • Effective dispersion leads to the direct contact of TiO₂ with oil pollutes directly. • TiO₂ loaded on PAL exhibits efficient photodegradation for oil pollutants. • TiO₂@PAL shows a typical dispersion-photocatalysis synergistic remediation. Removing spilled oil from the water surface is critically important given that oil spill accidents are a common occurrence. In this study, TiO₂@Palygorskite composite prepared by a simple coprecipitation method was used for oil spill remediation via a dispersion-photodegradation synergy. Diesel could be efficiently dispersed into small oil droplets by TiO₂@Palygorskite. These dispersed droplets had an average diameter of 20–30 mm and exhibited good time stability. The tight adsorption of TiO₂@Palygorskite on the surface of the droplets was observed in fluorescence and SEM images. As a particulate dispersant, the direct contact of TiO₂@Palygorskite with oil pollutants effectively enhanced the photodegradation efficiency of TiO₂ for oil. During the photodegradation process, •O₂⁻and •OH were detected by ESR and radical trapping experiments. The photodegradation efficiency of diesel by TiO₂@Palygorskite was enhanced by about 5 times compared with pure TiO₂ under simulated sunlight irradiation. The establishment of this new dispersion-photodegradation synergistic remediation system provides a new direction for the development of marine oil spill remediation.     

聚硅氯化铝混凝剂中Al(Ⅲ)水解聚合历程及铝硅作用特性研究

采用共聚与复合两种制备工艺，制备出了系列具有不同碱化度和不同Ａｌ／Ｓｉ摩尔比的聚硅氯化铝混凝剂，分析研究了ＰＡＳＣ中Ａｌ（Ⅲ）的水解－聚合历程以及聚硅酸与铝水解聚合产物的相互作用，探讨了ＰＡＳＣ溶液的酸解聚。     

膜的改性及其在环境领域应用研究进展

膜改性由于具有清洁、廉价、节能等特点,近年来得到快速发展,是解决膜污染的有效方法之一。本文综合介绍了膜的基体改性、表面改性这两种改性类型和目前常用的改性方法包括表面涂覆、表面活性剂改性、化学修饰改性、仿生改性等等,并简单介绍了膜改性在环境领域的应用,探讨了膜改性今后的发展。     

非离子型聚丙烯酰胺絮凝剂的制备及其絮凝性能

以丙烯酰胺（AM）和烷基酚聚醚（APAP）为单体,采用反相乳液聚合法制备了流动性好的非离子型聚丙烯酰胺絮凝剂（PAM-APAP）。考察了乳化剂和引发剂的种类、单体总质量分数、单体配比和反应温度等因素对聚合反应的影响。实验结果表明,制备PAM-APAP的最佳工艺条件为：单体总质量分数35%、m（AM）∶m（APAP）=9.0∶1.0、Span80+Tween80复配乳化剂加入量为油水总质量的7%、m（Span80）∶m（Tween80）=7.0∶1.5、V50加入量为单体总质量的1.5‰、反应温度50℃。PAM-APAP具有较好的絮凝效果,与其他絮凝剂相比用量较少,在加入量为100mg/L时,对聚合物驱油中产生的含聚合物污水的浊度去除率为87.9%,去油率为89.5%,且絮体不黏壁。     

基于最佳范化能力的BP网络隐节点数反比关系式的环境预测模型

网络结构和样本集复杂性是影响BP网络泛化能力的两个最重要因素.对一个给定的训练样本集,为了构造一个与样本集复杂性相匹配的网络结构,使BP网络具有最佳泛化能力,在分析BP网络的泛化能力(用检测误差E2表示)与网络结构和样本集复杂性之间关系的基础上,建立了含参数的BP网络检测误差E2与网络隐节点数H、样本的因子数n、样本数...     

Crystallization behavior of predominantly syndiotactic poly(β-hydroxybutyrate)

Predominantly syndiotactic poly(-hydroxybutyrate), syn-PHB, of variable syndioregularity (syndyad fractions 0.59, 0.62, 0.64, and 0.71) and molecular weight was prepared by the dibutyltin dimethoxide catalyzed ring opening of racemic-butyrolactone (BL). The crystallization behavior of the syn-PHB polymers was investigated by DSC and X-ray diffraction analyses. DSC of films after melting and annealing showed at least one, and often two distinct melting transitions occuring over a broad (often 40°C) temperature range. These results indicate that syn-PHB chain segments of variable syndioregularity form crystalline regions with very different thermodynamic stabilities. Maximum degrees of crystallinity for melt annealed 0.64- and 0.71-syn-PHB was observed at an annealing temperature (T _c ) of 30°C. AtT _c values at 45°C and higher, crystallization of relatively lower syndioregular chain segments was apparently excluded to variable degrees dependent onT _c and sample syndiotactic dyad content. After crystallization of syn-PHB samples at elevated temperatures, ambient temperature annealing resulted in an observed lower temperature melting transition at 50°C. This result showed little to no dependence on syn-PHB syndio-regularity andT _c . Both solution precipitated 0.62-syn-PHB and 0.71-syn-PHB have WAXS patterns with poorly resolved crystalline reflections superimposed on amorphous haloes indicating low levels of crystallinity (17% and 25%, respectively) and poorly formed crystals. Isothermal crystallization monitored by DSC showed that the syn- and natural origin PHB showed fastest crystallization rates at temperatures between 50°C and 70°C and 60°C and 90°C, respectively. From the dependence of the higher melting transition onT _c it was determined that the equilibrium melting temperatures for 0.62-syn-PHB (M _n =83,700 g/mol) and a 0.64-syn-PHB (M _n =11,900 g/mol) were 157 and 154°C, respectively. An Avrami analysis of syn-PHB yielded results similar to that found for natural origin PHB indicating that crystal growth occurs by a two-dimensional mechanism.Guest Editor: Dr. Graham Swift, Rohm & Haas.     

反相气相色谱法研究CPC-膨润土对VOCs的吸附作用

运用反相气相色谱法研究了20种VOCs在CPC-膨润土上的吸附平衡及吸附热．结果表明，CPC-膨润土对VOCs的吸附有较强选择性，吸附能力与有机物的分子量、分子结构、饱和蒸气压等物理化学性质有关，对苯系物和分子量较大的酯类和酮类等吸附能力较强．温度较低时，CPC-膨润土对VOCs的吸附能力较强，吸附热较大；吸附热与VOCs的沸点蒸发热相当，但比活性炭等常规吸附剂对VOCs的吸附热小。     

仿生脂肪细胞制备以及对水体中林丹去除的研究

利用生物体脂肪组织可以对脂溶性有机物有效富集的原理,通过界面聚合合成了类似脂肪细胞结构的仿生脂肪细胞,并对其结构进行了初步表征.仿生脂肪细胞具有亲水性膜以及亲脂性的内部结构,亲水性的膜允许携带脂溶性有机物的水体穿过膜,亲脂性的内含物将脂溶性有机物富集截留.仿生脂肪细胞对林丹具有较好的去除效果,15%三油酸甘油酯含量的仿生脂肪细胞与粉末活性炭具有相当的林丹去除能力.仿生脂肪细胞对林丹的去除机理包括内含物的生物富集以及膜上空腔的物理吸附两部分,而内含物的生物富集作用则是主要作用方式.