鸟粪石沉淀法预处理高氨氮废水的镁盐研究

药剂费用一直是限制鸟粪石法处理高氨氮废水实际应用的主要因素。实验采用鸟粪石沉淀法预处理高氨氮废水,以磷酸氢二钠作为磷盐,就不同镁盐对高氨氮废水的处理效果进行了分析比较。实验结果表明,将氯化镁与氧化镁联用作为新型镁盐时,有很大的优势。在n（N）：n（P）：n（Mg）=1：1：1．5,n（MgCl2）：n（MgO）=1：2,反应时间为30min条件下,氨氮的去除率可以达到90％以上,与常规单独采用氯化镁的处理方法相比,镁盐药剂费用可节约2／3以上。     

壳聚糖衍生物-镁盐复配去除中性兰模拟废水色度的研究

研究了有机高分子絮凝剂NCTS-M对中性兰染料的絮凝性能。通过测量絮体的Zeta电位以及对絮体进行彩色电视显微扫描初步探讨了该絮凝过程的絮凝机理。结果表明,当投加量为30 mg/L,pH=6时,絮凝效果最明显,脱色率可达93.1%。其絮凝机理主要是压缩双电层以及高分子吸附架桥作用,以压缩双电层为基础。絮凝剂中镁离子在中性条件下对絮凝过程也起到了较强的助凝作用。     

镁合金在笔记本电脑外壳材料替代中的环境协调性评价

本文应用生命周期评价,（life cycle assessment,LCA）方法,对镁合金以及塑料这两种笔记本电脑外壳进行了初步评价和比较,结果表明镁舍金能源消耗、温室效应方面为塑料的556．31％、383．30%。但在材料的性能、资源消耗、酸化效应、生态毒理、材料的再生性等方面明显优于塑料。     

粒径对镁粉爆炸特性的影响

在简要分析了镁粉爆炸的过程和特性基础上,结合在20 L球型爆炸测试装置中对粒径D50为6,47,104,173 μm镁粉的爆炸特性实验数据,着重分析了粒径对镁粉爆炸特性所产生的影响.实验结果表明,随着粒径的增大,镁粉的爆炸危险性随之减小.     

Phytoavailability and extractability of potassium,magnesium and manganese in calcareous soil amended with olive oil wastewater

Abstract

Land disposal of olive oil wastewater using it as a soil amendment requires a knowledge of the effects that its application may produce on the status of the mineral nutrients in the plant‐soil system. A pot experiment using calcareous soil was performed in a growth chamber to examine the effects of olive oil wastewater on the availability and postharvest soil extractability of K, Mg and Mn. The experiment included 6 treatments: two rates of olive oil wastewater, two mineral fertilizer treatments containing K (which supplied K in amounts equivalent to the K supplied by the olive oil wastewater treatments), a K‐free mineral fertilizer treatment, and a control. The pots were sown with ryegrass as the test plant, harvesting 3 times at intervals of one month. Olive oil wastewater has demonstrated a considerable capacity for supplying K that can be assimilated by the plant, tending in fact to surpass the mineral potassium fertilizer tested. The application of olive oil wastewater tends to reduce the concentration of Mg in the plant, similarly to the effect of adding mineral potassium fertilizer. An enhancement of Mn availability takes place in the soil amended with olive oil wastewater, which on occasion has produced Mn concentrations in plant that could be considered phytotoxic or at least excessive. After harvesting, we observed an increase in the amount of exchangeable K in soil with added industrial wastewater. However, these increases are lower than those in soil treated with mineral potassium fertilizer. The levels of exchangeable, carbonate‐bound, organic‐bound and residual Mg in soil were higher in treatments incorporating olive oil wastewater than in those with added mineral K, with the opposite tendency occurring in the amount of Fe‐Mn oxides‐bound Mg in soil. Treatments based on olive oil wastewater, especially in high doses, increased the amount of exchangeable and carbonate‐bound Mn in soil, in comparison with treatments adding mineral fertilizers with or without K. In contrast, the addition of industrial wastewater caused a drop in the amount of Fe‐Mn oxides‐bound and organic‐bound Mn in soil.     

镁合金的大气腐蚀研究

综述了各种因素对镁合金大气腐蚀的影响,其中介绍了单一因素NaCl及两种因素协同作用对镁合金大气腐蚀的影响。同时介绍了镁合金大气电偶腐蚀的影响因素与Al含量对镁合金大气腐蚀的影响。简述了研究镁合金大气腐蚀的几种常用表征手段。     

苦土和氧化镁处理氮磷废水的对比研究

分别采用苦土、纯氧化镁为沉淀剂对模拟高浓度氮磷废水(N/P=0.8)进行了脱氮除磷研究,比较了沉淀剂投加量、pH对2种沉淀剂处理氮磷废水的影响,对沉淀产物进行XRD分析,并进行了经济效益比较。结果表明,pH是影响2种沉淀剂处理氮磷废水的主要因素,随着pH的增加,脱氮除磷效果提高,在平衡pH为9～10之间时氮磷处理效果最佳,pH继续增加,由于磷酸镁沉淀的形成使得氨氮去除率降低。此外,处理相同的废水,苦土的最佳投加量要大于纯氧化镁,但是经济效益比较结果表明,以苦土为沉淀剂处理氮磷废水可大大降低处理成本。     

磷酸铵镁沉淀法预处理垃圾渗滤液

探讨了用磷酸铵镁沉淀法预处理垃圾渗滤液时,沉淀剂种类、pH值、物质摩尔配比和反应时间等因素对氨氮去除效果的影响。得出了处理氨氮浓度为2 677.34 mg/L的垃圾渗滤液时,在兼顾所用镁盐量尽量低和处理出水氨氮或磷酸盐的残留量都比较低的较佳实验条件为:沉淀剂种类为:MgSO4.7H2O和Na2HPO4.12H2O,反应时间为20 min,pH=9.5,n(Mg)∶n(P)∶n(N)=1.3∶1.15∶1.0。在较佳实验条件下,垃圾渗滤液的NH3-N去除率为97.05%,处理出水PO34--P含量为8.35 mg/L,NH3-N含量为75.86 mg/L。对所得沉淀物进行了成分分析和X-衍射光谱、扫描电镜表征,表明大部分沉淀物为磷酸铵镁物质。     

改性膨胀石墨对含铅废水吸附特性

采用微波法在1 000 W下微波膨胀60 s制备了膨胀石墨,以乙醇为分散剂,采用超声沉淀法制备了纳米氢氧化镁,同时将纳米氢氧化镁负载到膨胀石墨孔隙中,制备出一种新型吸附剂,并采用静态吸附的方法研究了该吸附剂对铅离子的吸附效果,实验证明当改性膨胀石墨的用量为0.035 g,铅溶液的pH=4,铅溶液初始浓度为300 mg/L,吸附温度为25℃时,该吸附剂对铅离子的去除率能达到48%,吸附容量能达到105 mg/g左右。同时该吸附反应能够较好地符合Lang-muir吸附等温式以及二级动力学模型。     

Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.