动态膜压法测定江、污混合水体中有机物含量的探讨

用双驱动动态膜压仪测定江、污混合水中有机物含量。通过测定白龙港污水和长江水混合后的膜压和滞回环面积，用它们与相应的经典法CODCr作图，获得了滞回环面积和CODCr之间良好地线性关系，表明用动态膜压法可快速测定混合水中的有机物含量，不须加任何试剂，不会产生二次污染。同时，对实验结果进行了初步的机理探讨。     

Promotion of hexadecyltrimethyleamine bromide to the damage of Alexandrium sp. LC3 by cupric glutamate

The effect of hexadecyltrimethyleamine bromide （HDTMAB） on the removal of A lexandrium sp. LC3 under cupric glutamate stress was investigated. Toxic effect of cupric glutamate on A lexandrium sp. LC3 was significantly promoted in the presence of HDTMAB, especially at 3.0 cmc of HDTMAB. It was found that the sulfhydryl group content of the cell decreased, while the malonaldehyde content and membrane permeability increased when A lexandrium sp. LC3 was treated with HDTMAB and cupric glutamate complex, compared with cupric glutamate alone. The data suggest that HDTMAB might stimulate the damage of A lexandrium sp. LC3 by enhancing the membrane permeability.     

恶臭假单胞菌Pseudomonas putida 5-x细胞壁膜系统的Cu2+吸附性能

对1株从电镀废水中分离出的革兰氏阴性菌恶臭假单胞菌P.putida 5-x的细胞表面组分对Cu²⁺的吸附性能进行了分析研究.结果表明,分离的P.putida 5-x细胞壁膜的Cu²⁺吸附容量是完整细胞的5倍之多.细胞表面组分如肽聚糖层、细胞外膜和细胞内膜在P.putida 5-x细胞壁膜的Cu²⁺吸附过程中都发挥了作用.肽聚糖层、细胞外膜和内膜在P.putida 5-x细胞壁膜中的含量依次为细胞内膜>外膜>肽聚糖层,而它们的Cu²⁺吸附容量的大小依次为肽聚糖层>外膜>内膜.在P.putida 5-x细胞壁膜对Cu²⁺的吸附过程中,肽聚糖层贡献了不到15%的吸附容量,而细胞外膜和内膜分别贡献了30%～35%和25%～30%.P.putida 5-x细胞外膜中的磷脂含量明显比其它报道的革兰氏阴性细菌的细胞外膜高,这可能是P.putida 5-x细胞外膜具有较高Cu²⁺吸附容量的主要原因,并由此导致P.putida 5-x细胞壁膜的高Cu2+吸附容量.     

膜吸收器吸收CO2的影响因素研究

采用聚丙烯中空纤维膜吸收器,用水、NaOH和K2CO3 水溶液作为吸收剂进行高浓度CO2 吸收试验,考察了气体流率、吸收剂流率、质量分数以及流动方式对吸收率、传质系数和传质速率的影响.结果表明,随着气体流率增大,CO2的吸收率递减,总传质系数和总传质速率增加.在一定的气体流率下,吸收液流率增大,CO2的吸收率、总传质系数和总传质速率增大;吸收液浓度提高,吸收率增大,总传质系数和总传质速率提高.在气体流率较低时,质量分数为5%和8%的NaOH水溶液为吸收剂时的吸收率、总传质系数和总传质速率比较接近.随着气体流率增大,NaOH质量分数为8%时的吸收率、总传质系数和总传质速率增加的值大大超过NaOH质量分数为5%时增加的值.以水为吸收剂时,气体与吸收剂的流动方式为逆流时的吸收率、总传质系数和总传质速率高于并流时的值.     

旋转切向流聚丙烯管式膜微滤能耗分析

设计了一种新型旋转切向流聚丙烯管式膜器,实验研究了聚丙烯PA管式膜器的能耗通过建立的旋转切向流强化微滤实验装置系统,测定了聚丙烯PA管式膜器在旋转切向流和轴向流下的膜通量与能量有效利用率.实验结果表明,旋转切向流管式膜微滤比一般轴向流膜微滤的有效利用率要高得多,是一种非常有效的强化膜分离技术在实验条件下,直线切向流膜微滤和圆弧切向流膜微滤的稳态能量有效利用率比轴向流稳态能量有效利用率分别高11.185倍和14.591倍.     

A novel sequence batch membrane carbonation photobioreactor developed for microalgae cultivation

A novel SBM-C-PBR was constructed for microalgae cultivation. Membrane fouling was greatly mitigated by membrane carbonation. NH₄⁺ and P removal rates were around 80% in SBM-C-PBR. Biomass was completely retained by membrane. In this study, a novel sequence batch membrane carbonation photobioreactor was developed for microalgae cultivation. Herein, membrane module was endowed functions as microalgae retention and CO₂ carbonation. The results in the batch experiments expressed that the relatively optimal pore size of membranes was 30 nm, photosynthetically active radiation was 36 W/m² and the CO₂ concentration was 10% (v/v). In long-term cultivation, the microalgal concentration separately accumulated up to 1179.0 mg/L and 1296.4 mg/L in two periods. The concentrations of chlorophyll a, chlorophyll b and carotenoids were increased about 23.2, 14.9 and 6.3 mg/L respectively in period I; meanwhile, the accumulation was about 25.0, 14.5, 6.6 mg/L respectively in the period II. Furthermore, the pH was kept about 5.5–7.5 due to intermittent carbonation mode, which was suitable for the growth of microalgae. Transmembrane pressure (TMP) was only increased by 0.19 and 0.16 bar in the end of periods I and II, respectively. The pure flux recovered to 75%–80% of the original value by only hydraulic cleaning. Scanning electron microscope images also illustrated that carbonation through membrane module could mitigate fouling levels greatly.     

Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

硝化菌与膜生物反应器结合处理生活污水中氨氮

研究了硝化菌与膜生物反应器结合处理生活污水中氨氮，实验用水采用食堂与化粪池混合水，实验装置采用膜生物反应器，进水氨氮在4mg／L左右，出水氨氮值接近0，实验结果表明出水能够达到国家工业冷却回用水的指标要求，同时COD也降至30mg／L以下，能满足回用要求。     

聚醚砜超滤膜的研制

以聚醚砜为原料，二甲基乙酰胺为溶剂，研究了铸膜液组成和若干因素对膜性能的影响。选择适当的膜液组成和制备条件，可制得截留分子量分别为２０００，６０００，１００００的超滤膜，用该膜对α－干扰素进行分离。截留率均可达到９９％以上。     

超滤法回收PVA并回用于生产的扩大实验

本工作采黑由美国引进的超滤装置,在湖南湘潭纺织印染厂进行了从退浆废水中回收pVA的生产性扩大试验,探讨了料液温度、浓度,操作压力等因素对超滤性能的影响,并简单介绍了回收浆料回用于浆纱,织布及印染生产的情况。