用微波消解-光度法测定废钻井液中的总铬

采用微波消解-光度法处理钻井液废水中的总铬。该方法克服了常规消解方法的缺点,测定步骤简单、快速,准确性高。通过实验探讨了微波功率、加热时间、样品体积对样品消解的影响。与常压的硫酸-硝酸消解法进行比较的结果表明,用微波消解-光度法处理泥浆废水可将消解时间由原来的6h缩短为20min,加标回收率由60%提高到92%,降低了工作强度,改善了工作环境。     

Effect of 450 MHz Microwave Modulated with 217 Hz on Human EEG in Rest

Summary This study focuses on discrimination of changes, produced by low-level microwave exposure in intensity and time variability of the human EEG at rest. The power spectral density (PSD) method and nonlinear scaling analysis of the length distribution of low variability periods (LDLVP) were selected for analysis of the EEG signal. During the study, 19 healthy volunteers were exposed to a microwave (450 MHz) of 217 Hz frequency on-off modulation. The field power density at the scalp was 0.16 mW/cm². The experimental protocol consisted of ten cycles of repetitive microwave exposure. Signals from frontal, temporal, parietal and occipital EEG channels on EEG theta, alpha and beta rhythms were analysed. Exposure to microwave causes average increase of EEG activity. LDLVP analysis discriminated significant effect in time variability for 2 subjects (11%). PSD method detected significant changes in intensity for 4 subjects (21%). The effect of low-level microwave exposure is stronger on EEG beta rhythm in temporal and parietal regions of the human brain.     

不同流态下微波辐射对污水污泥性质的影响研究

通过对不同流态下微波辐射对污水污泥性质的影响进行研究,考察了不同流态下微波辐射作用处理后污泥沉降性能、脱水性能的变化,以及微波辐射作用下流态对污泥挥发性悬浮固体(VSS)溶解率、上清液中COD和污泥微观形态的影响.结果表明,流态对污泥的沉降性能和脱水性能有一定影响,微波辐射功率越高,流态对污泥沉降性能和脱水性能的影响越显著.微波辐射功率较低时,雷诺数Re越大,污泥的沉降比(SV)、比阻和泥饼含水率越小;微波辐射功率较高时,Re为2300的临界流态下污泥的沉降性能和脱水性能最好.随着Re的增大,VSS溶解率和上清液中COD升高,微波辐射功率分别为300、500、700和900W时,Re为3000的紊流流态下上清液中COD分别达到1.1、2.1、3.6和6.7g·L-1.SEM观察结果表明,微波辐射及流态产生的协同剪切应时适宜时,有利于污泥颗粒的絮凝反应,高强度的微波辐射和紊流产生的较大剪切应力导致污泥絮体被打碎.     

Pb(II) removal from water using Fe-coated bamboo charcoal with the assistance of microwaves

Bamboo charcoal(BC) was used as starting material to prepare iron-modified bamboo charcoal(Fe-MBC) by its impregnation in FeCl 3 and HNO 3 solutions simultaneously,followed by microwave heating.The material can be used as an adsorbent for Pb(Ⅱ) contaminants removal in water.The composites were prepared with Fe molar concentration of 0.5,1.0 and 2.0 mol/L and characterized by means of N 2 adsorption-desorption isotherms,X-ray diffraction spectroscopy(XRD),scanning electron microscopy coupled with energy dispersive X-ray spectrometry(SEM-EDS),Fourier transform infrared(FT-IR) and point of zero charge(pH pzc) measurements.Nitrogen adsorption analyses showed that the BET specific surface area and total pore volume increased with iron impregnation.The adsorbent with Fe molar concentration of 2 mol/L(2Fe-MBC) exhibited the highest surface area and produced the best pore structure.The Pb(Ⅱ) adsorption process of 2Fe-MBC and BC were evaluated in batch experiments and 2Fe-MBC showed an excellent adsorption capability for removal Pb(Ⅱ).The adsorption of Pb(Ⅱ) strongly depended on solution pH,with maximum values at pH 5.0.The ionic strength had a significant effect on the adsorption at pH < 6.0.The adsorption isotherms followed the Langmuir isotherm model well,and the maximum adsorption capacity for Pb(Ⅱ) was 200.38 mg/g for 2Fe-MBC.The adsorption processes were well fitted by a pseudo second-order kinetic model.Thermodynamic parameters showed that the adsorption of Pb(Ⅱ) onto Fe-MBC was feasible,spontaneous,and exothermic under the studied conditions,and the ion exchange mechanism played an significant role.These results have important implications for the design of low-cost and effective adsorbents in the removal of Pb(Ⅱ) from wastewater.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。     

改性活性碳纤维电芬顿降解苯酚废水性能研究

采用微波改性、硝酸改性、磷酸改性及氨水改性等方法改性活性碳纤维(ACF-0),依次标记为ACF-1、ACF-2、ACF-3和ACF-4.以改性前后的活性碳纤维为阴极,电芬顿催化处理苯酚模拟废水,考察不同的改性方法对H2O2生成量、COD去除率、苯酚去除率及其中间产物的影响.结果表明,微波改性活性碳纤维的吸附性能及电催化活性最优,相比未改性活性碳纤维,经微波或酸碱改性后的活性碳纤维反应体系中,H2O2生成量均有所增加.苯酚在各电芬顿催化体系中的去除率大小依次是:ACF-1>ACF-3>ACF-4>ACF-2>ACF-0;COD去除率大小依次是:ACF-1>ACF-4>ACF-3>ACF-2>ACF-0,说明微波及酸碱改性有利于提高活性碳纤维的催化性能.此外,苯酚降解中间产物的生成也会受到改性方法的影响.     

微波及其组合工艺强化污泥厌氧消化研究

为提高剩余污泥的厌氧消化效能和脱水性能,考察了微波及其组合污泥预处理工艺的强化污泥厌氧消化效果,同时考察了预处理-厌氧消化过程的污泥理化特征及其脱水性能.结果表明,微波及其组合工艺可以强化污泥厌氧消化产甲烷,其中微波-过氧化氢-碱(0.2)的强化效果最为显著,不仅30 d累计产甲烷量比对照组增加了13.34%,而且产甲烷速率也得到了提升.与单独微波处理相比,过氧化氢、碱的投加显著提高了溶解性COD的释放量,这表明微波、过氧化氢、碱之间的协同作用能有效破碎污泥,进而强化厌氧消化效果;微波-酸预处理后的污泥具有良好的脱水性能,毛细吸水时间(CST)只有9.85 s,污泥脱水性能的改善与其表面电性、粒径分布的变化密切相关;不同预处理条件下的污泥经过厌氧消化后,污泥脱水性能较为接近.     

双组分VOCs的催化氧化及动力学分析

考察了微波加热与管式炉加热下挥发性有机化合物(VOCs)甲苯与氯苯的催化氧化性能,并对双组分VOCs的反应动力学进行了分析.结果表明,VOCs的竞争吸附使得双组分中甲苯和氯苯的转化率比单组分降低3%~12%;微波的"热点效应"与"非热效应"使得VOCs转化效率明显优于管式炉加热,尤其是氯苯的转化率提高了31%~38%;微波加热降低了氧化反应温度和处理能耗.动力学分析表明,微波加热下甲苯和氯苯的反应活化能比管式炉加热下减少了2146 J·mol-1和1450J·mol-1,微波加热下氯苯的化学反应速率常数是管式炉加热的35倍,甲苯的反应速率常数提高了6倍.