石油开发废水中氯化物的测定──氯离子选择电极法

用氯离子选择电极法测定油田废水中氯化物是一种新方法。通过电极响应平衡速度试验、干扰消除试验、方法适应性试验等，探讨了温度对能斯特斜率的影响；ＰＨ对测定值的影响；总离子强度调节缓冲溶液（ＴＩＳＡＢ）的选择。本方法分析速度快，测定浓度范围宽，操作简便，成本低，值得推广。     

三维电极电解硝基苯废水处理实验研究

以涂膜活性炭-活性炭为填充粒子,对三维电极电解硝基苯废水进行了研究。通过实验探讨了投盐量、槽电压、主电极间距、反应时间及初始浓度对电解硝基苯废水的影响。结果表明,三维电极在电极间距为9mm、槽电压为20V、硫酸钠投加量为1.5g/L、pH值为6、电解时间为90min的条件下,硝基苯去除率可达90%以上。在三维电极电解作用下,硝基苯转化为可生化和低毒的苯胺,苯胺在三维电极电解作用下还可以得到进一步的降解。     

溶出伏安法中电极的操作技术

电极性能的优劣是完成溶出伏安分析的关键,本文就三电极体系中电极的选择、处理、安装、使用、维护方法等方面作了较详细的说明和探讨,提高了方法的精密度和准确度,使溶出伏安法在海水分析中得到更好的应用.     

Prediction of future disposal of end-of-life refrigerators containing CFC-11

The objective of this study was to predict the number of refrigerators containing CFC-11 blown isolation foam and the amount of CFC-11 banked in these refrigerators. By using a Weibull-based survival function, the number of CFC-11 containing and still-functioning refrigerators was estimated to be approximately 1.6 million in 2013 in Turkey. In order to determine the amount of CFC-11 in the isolation foam of these refrigerators, polyurethane (PU) foam samples were taken from a refrigerator manufactured in 1993 and the quantity of CFC-11 was analyzed by a GC-MS. It was determined that 113–195 mg CFC-11/g PU remains in the PU foam depending on the location such as door, sides, top and bottom. Knowing that a mid-sized refrigerator contains 4 kg PU on average, the total amount of PU foam to be disposed of is 6344 tons when the CFC-11 containing refrigerators in Turkey become obsolete in the near future. Furthermore, 717–1237 tons of CFC-11 are expected to be banked in the PU foam of these refrigerators which will exert an equivalent amount of ozone depleting potential (ODP). In addition, the global warming potential will vary between 3.4 and 5.9 million tons of CO₂.     

Development of heat transfer and evaporation model of LNG covered by Hi-Ex foam

Natural gas is a kind of clean, efficient green energy source, which is used widely. Liquefied natural gas (LNG) is produced by cooling natural gas to −161 °C, at which it becomes the liquid. Once LNG was released, fire or explosion would happen when ignition source existed nearby. The high expansion foam (Hi-Ex foam) is believed to quickly blanket on the top of LNG spillage pool and warm the LNG vapor to lower the vapor cloud density at the ground level and raising vapor buoyancy. To identify the physical structure after it contacted with LN₂ and to develop heat transfer model, the small-scale field test with liquid nitrogen (LN₂) was designed. In experiment, three layers including frozen ice layer, frozen Hi-Ex layer and soft layer of Hi-Ex foam were observed at the steady state. By characterizing physical structure of the foam, formulas for calculating the surface of single foam bubble and counting foam film thickness were deduced. The micro heat transfer and evaporation model between cryogenic liquid and Hi-Ex foam was established. Indicating the physical structure of the frozen ice layer, there were a certain number of icicles below it. The heat transfer and evaporation mathematical model between the frozen ice layer and LNG was derived. Combining models above with the heat transfer between LNG, ground and cofferdam, the heat transfer and evaporation mathematical model of LNG covered by Hi-Ex foam was developed eventually. Finally, LN₂ evaporation rate calculated by this model was compared with the measured evaporation rate. The calculated results are 1.2–2.1 times of experimental results, which were acceptable in engineering and proved the model was reliable.     

石墨烯凝胶电极的制备及电吸附Pb2+的性能

电吸附去除水中重金属离子具有吸附容量高和电极可再生的优点.本文采用高温水热法还原氧化石墨烯(GO)得到石墨烯水凝胶(GS)并经压片制得GS电极.本文对GS电极的电化学性能进行了测试,考察了GS电极电吸附Pb~(2+)的动力学和热力学特性,以及电极的脱附和循环使用情况.结果表明,GS电极的电化学性能优异,其单位质量比电容高达200.4 F·g~(-1)(1 A·g~(-1));提高电压有利于GS电极电吸附Pb~(2+),电压为-1.2 V时,GS电极对Pb~(2+)的去除率达96.4%;GS电极电吸附Pb~(2+)的饱和吸附量达461.20 mg·g~(-1),是不加电时饱和吸附量的2倍;施加反向电压可以实现Pb~(2+)的脱附和电极再生,电吸附-脱附15次后,电极对Pb~(2+)的去除率保持在95%以上.     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

Pd-MnO2 nanoparticles/TiO2 nanotube arrays (NTAs) photo-electrodes photo-catalytic properties and their ability of degrading Rhodamine B under visible light

Pd-MnO_2/TiO_2 nanotube arrays(NTAs) photo-electrodes were successfully fabricated via anodization and electro deposition subsequently; the obtained Pd-MnO_2/TiO_2 NTAs photo electrodes were analyzed by scanning electron microscopy(SEM), X-ray diffraction(XRD) and characterized accordingly. Moreover, the light harvesting and absorption properties were investigated via ultraviolet–visible diffuse reflectance spectrum(DRS); photo degradation efficiency was investigated via analyzing the photo catalytic degradation of Rhodamine B under visible illumination(xenon light). The performed analyses illustrated that Pd-MnO_2 codoped particles were successfully deposited onto the surface of the TiO_2 nanotube arrays;DRS results showed significant improvement in visible light absorption which was between400 and 700 nm. Finally, the photo catalytic degradation efficiency results of the designated organic pollutant(Rhodamine B) illustrated a superior photocatalytic(PC) efficiency of approximately 95% compared to the bare TiO_2 NTAs, which only exhibited a photo catalytic degradation efficiency of approximately 61%, thus it indicated the significant enhancement of the light absorption properties of fabricated photo electrodes and their yield of UOH radicals.     

添加H2O2加速低合金钢海水腐蚀的主要影响因素研究

采用极化曲线、旋转圆盘电极试验和失重（质量损失）法研究了低合金钢在添加了H。o：的海水中腐蚀加速的主要影响因素。结果发现低合金钢在添加H2O2的海水中腐蚀加速主要受到了H2O2浓度、温度、搅拌速度和H2O2添加周期的影响。研究表明,搅拌速度不变、H2O2添加周期相同的条件下,在H2O2浓度为0．8mol／L的70℃海水中,低合金铜的腐蚀加速最显著;在试验的转速范围内,加速作用随搅拌速度增大变得更为显著;H2O2加入后350min内加速作用较明显。     

镍掺杂二氧化钛光催化剂的制备与光催化性能研究

利用溶胶-凝胶法制备了镍掺杂的二氧化钛,采用紫外可见分光光度计、傅里叶红外分光光度计、X衍射仪(XRD)、扫描电镜(SEM)等测试手段对结果进行了表征。表征结果表明在550℃下煅烧的产物主要是锐钛型二氧化钛,镍的掺杂使得二氧化钛的紫外可见反射光谱明显红移,且镍掺杂二氧化钛的粒度减小,团聚程度下降。以活性艳蓝KN-R为模型降解目标物,通过比较镍掺杂二氧化钛、纯二氧化钛以及标准P25二氧化钛的光催化性能发现镍掺杂二氧化钛的光催化活性最好。当钛酸正丁酯/乙醇比为1:25;钛酸正丁酯/冰乙酸比为1:1;钛酸正丁酯/硝酸镍比为1 000:3;煅烧温度为550℃,煅烧时间为2 h时,镍掺杂二氧化钛的光催化效率最高,达到73.3%。