Disparity of a Seat Cushion and Its Influence on Postural Control

Properties of supporting surfaces of a seat have an influence on postural control. Centre of pressure (COP) displacement parameters reflect both the balance controlling process and movements of the centre of a mass of entire body. The subjects of the study were 9 healthy men. A seat cushion was examined with a 2-force platform setup. Force exertion at a seat pan and feet and COP displacement at a seat pan were measured to analyse postural control. Analysis of variance determined the differences in postural control depending on a cushion type among the subjects. Significant differences in COP displacement parameters were in COP trajectory length, medio-lateral COP displacement and COP velocity. The results of the study showed that foam cushion ensures better postural control.     

Electrochemical remediation of copper (II) from an industrial effluent Part II: three-dimensional foam electrodes

A batch recycle removal of copper ions from an industrial effluent by means of copper foam cathodes was tested. A constant current of 750 A was applied to the cell in order to perform the reduction. Copper depletion was investigated at different solution flow rates and a removal greater than 98% was obtained with a flow rate of 1000 l/h. The influence of initial metal concentration on copper deposition and current efficiency is also discussed.     

Simultaneous photocatalytic treatment of Cr(VI), Ni(II) and SDBS in aqueous solutions: Evaluation of removal efficiency and energy consumption

Simultaneous photocatalytic reduction of poisonous Cr(VI) and Ni(II) ions, coupled with photocatalytic oxidation of sodium dodecyl benzene sulfonate (SDBS) were studied with a trace amount of commercial titania nanoparticles and by means of a direct-photo-irradiation reactor. The co-presence of metal ions and SDBS causes metal ions reduction as well as SDBS oxidation to enhance and energy efficiency to improve. XRD, XPS and FTIR analysis were used to characterize TiO₂ particles before and after usage with the aim of evaluating the mechanism of reactions. The effect of major operating parameters, pH and temperature, was investigated. Under conditions of [Cr(VI)]₀ = [Ni(II)]₀ = 5 mg/L, [SDBS]₀ = 10 mg/L, [TiO₂] = 40 mg/L, pH 6 and T = 35 °C; the removal efficiencies of 55.4%, 71.2% and 57.2% were obtained, respectively, for Cr(VI) and Ni(II) reduction, as well as for SDBS oxidation, after 110 min operation. The relevant kinetic model jointed with the Arrhenius equation was introduced. Pseudo-first-order reactions are relevant. Energy consumption (electrical and thermal) evaluations revealed that operations at higher temperatures provide significant cost reduction. Meantime, a criterion was proposed for a consistent assessment of this kind of processes.     

压缩空气泡沫在长距离管路输送中压降的数值模拟

基于Fluent对压缩空气泡沫在长距离管道中的流动特性进行了数值模拟研究,将压缩空气泡沫近似为弥散流,采用Saplart-Allmaras模型模拟了不同管径下压缩空气泡沫以及不同泡沫原液浓度的AFFF泡沫在长距离管道内的流动及压降变化。模拟结果表明,随着距离变化,各管径管道内压降均呈现线性变化,且随着压缩空气泡沫的流动,压降线性增大。管道管径对管内压降变化具有显著影响,管道直径越小,管道内压降越大;泡沫原液浓度对压降的影响较小,且压缩空气泡沫在长距离输送中的压力随距离线性衰减。将模拟结果与长距离输送的试验结果进行了对比,误差在10%以内。     

La-PTFE共掺杂二氧化铅电极的制备及其性能研究

以Ti为基体,掺杂La2O3和聚四氟乙烯(PTFE),通过电沉积法制备了Ti/SnO2+Sb2O3/PTFE+La2O3+β-PbO2电极,并将所制备的电极应用于亚甲基蓝模拟染料废水的降解.结果发现,与常规的Ti/SnO2+Sb2O3/PTFE+β-PbO2电极相比,Ti/SnO2+Sb2O3/PTFE+La2O3+β-PbO2电极对亚甲基蓝及COD有较好的去除效果.含有La2O3活性层的Ti/SnO2+Sb2O3/PTFE+La2O3+β-PbO2电极在电解质浓度为0.15mol.L-1,电极极距为6.0cm的酸性条件下降解亚甲基蓝的效果最佳.降解3.0h后,对100mg.L-1亚甲基蓝的去除率可达到97.92%,对COD去除率为93.39%.SEM结果显示,Ti/SnO2+Sb2O3/PTFE+La2O3+β-PbO2电极表面颗粒鲜明,比表面积增大,改善了电极的微观结构和催化效果.电化学测试表明,La2O3的掺杂显著提高了二氧化铅电极的析氧过电位,显示出较好的应用前景.     

Enzyme-electrolytic degradation of dichloromethane: Efficiency, kinetics and mechanism

Enzymatic electrolysis cell(EEC) has advantages over microbial electrolysis cell(MEC) due to the needless of microbe inoculation and high-efficiency of enzymatic reaction. In this study, an EEC was first applied to achieve the effective degradation of halogenated organic pollutants and dichloromethane(CH_2Cl_2) was utilized as a model pollutant. The results indicate that the degradation efficiency of CH_2Cl_2 after 2 hr reaction in the EEC was almost100%, which was significantly higher than that with enzyme(51.1%) or current(19.0%). The current induced the continuous regeneration of reduced glutathione(GSH), thus CH_2Cl_2 was degraded under the catalysis of GSH-dependent dehalogenase through stepwise dechlorination, and successively formed monochloromethane(CH_3Cl) and methane(CH_4). The kinetic result shows that with a current of 15 mA, the maximum specific degradation rate of CH_2Cl_2(3.77 × 10~(-3) hr~(-1)) was increased by 5.7 times. The optimum condition for CH_2Cl_2 dechlorination was also obtained with pH, current and temperature of 7.0, 15 mA and 35°C,respectively. Importantly, this study helps to understand the behavior of enzymes and the fate of halogenated organic pollutants with EEC, providing a possible treatment technology for halogenated organic pollutants.     

EDTA直接滴定测定镍

参考磷酸在345~356℃时有强腐蚀性的特点,采有硫磷混合酸消解矿样,能使样品消解完全。本方法经加标校核证明,检测结果重现性好,准确度高。     

镍渣制备建筑用微晶玻璃的初步研究

对从镍渣中提取铁同时制备建筑用微晶玻璃的进行了研究.结果表明,熔渣中铁的质量分数可以降到0.5%左右,满足制备微晶玻璃的要求.对微晶玻璃样品进行了显微镜、X射线衍射、扫描电镜分析.其主晶相是透辉石(CaO·MgO·2SiO2),晶体的形貌为短柱状,分布均匀.本文所介绍的制备工艺是可行的.     

外浮顶储罐泡沫灭火设施的选型

分析了外浮顶储罐火灾危险性及火灾类型,对目前泡沫灭火设施在外浮顶储罐中的应用及存在的问题进行阐述,建议外浮顶储罐的泡沫灭火设施采用边缘泡沫消防系统.     

电极构型对空气阴极生物燃料电池发电性能的影响

在空气阴极生物燃料电池(ACMFC)中,从阴极扩散进入阳极的氧气能够被兼性微生物作为电子受体还原,进而导致电子损失严重.本研究利用葡萄糖作底物,对2种不同电极构型的空气阴极生物燃料电池ACMFC1和ACMFC2的功率输出和电子回收进行了比较研究.结果表明,ACMFC1的内阻为302.14Ω,阳极电位为-323mV,最大功率密度为3 070 mW/m³;ACMFC2的内阻为107.79Ω,阳极电位为-442mV,最大功率密度达到9 800 mW/m³.在间歇条件下,ACMFC2可以连续运行220h,电子回收率为30.1%;而ACMFC1只能运行不到50h,电子回收率为9.78%.因此,合理的设计空气阴极生物燃料电池电极构型可以减小内阻,增大电池电动势进而增大功率输出,提高电子回收率.