新疆阜康冶炼厂无污染工艺及环境治理

介绍了阜康冶炼厂无污染新工艺和环境治理的有关情况 ,从理论上阐述了无污染工艺和污水治理的技术原理 ,对有色金属冶炼工业逐步采用湿法精炼清洁工艺有一定的指导作用     

上海浦东国际机场飞机尾气排放对机场附近空气质量的影响

统计2012年10月和11月浦东机场飞机机型和航班架次,根据各类飞机起降的污染物排放设计工作参数,估算出2012年浦东机场飞机起降时排放的NO2、SO2、CO和HC的估算值。利用浦东新区13个空气监测子站二氧化氮和二氧化硫数据绘制等值线图。结果显示,机场所在的江镇点位和祝桥点位二氧化氮浓度变化受飞机影响很大,而飞机排放的二氧化硫对两个点位的影响可以忽略不计。建议采用改进飞机滑行路线、探讨征收飞机碳排放税等措施减少飞机尾气排放对空气质量的影响。     

Enhancement of UV and chromate mutagenesis by nickel ions in the Chinese hamster HGPRT Assay †

1. The HGPRT (Hypoxanthine‐Guanine‐Phospho‐Ribosyl‐Transferase) assay with Chinese Hamster V79 cells was used to measure the mutagenic effects of UV irradiation, potassium dichromate and nickel chloride. The agents were tested separately and in the combinations of UV plus nickel and dichromate plus nickel.

2. UV, Cr(VI) and Ni(II) were confirmed to be mutagenic in the V79 cell assay. The combination of UV(5J/m²) and Ni(II) (0.5 mM) caused a mutation rate 11.2 times above that corresponding to the sum of the individual mutation rates of these agents. The combined action of Cr(VI) (0.1 mM) and Ni(II) (0.5 mM) produced a mutation rate 2.8 fold above that corresponding to the sum of the individual rates of the separate agents.

3. The enhancing effect of nickel chloride on the mutagenicity of UV or Cr(VI) is interpreted by an interference of Ni(II) with the repair of DNA lesions.     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.     

电解法处理含镍废水及纯镍的回收

采用电解回收法处理Ni2+含量为2g/L的废水,在阴极回收纯镍。研究了电解电流、极距、NH4Cl浓度、pH值等因素对Ni2+去除率、槽压、阴极能耗的影响,得出最优工艺参数为:温度20℃,电解时间20min时、电解电流300mA,极距15mm,NH4Cl浓度5g/L,pH值8.0,该条件下Ni2+去除率为96.926%,槽压16.21V,阴极能耗22.418kW.h/kg,在阴极可得到沉积6.45μm厚的镍板。     

Poly(ethylene oxide)-coated granular starch-poly(hydroxybutyrate-co-hydroxyvalerate) composite materials

Granular cornstarch was coated with several biodegradable polymers in an effort to improve the mechanical properties of starch-poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) composites. Only samples containing poly(ethylene oxide) (PEO)-coated granular starch showed a large improvement in tensile properties over uncoated starch. For example, a 50/50 blend of PEO-coated starch and PHBV had a tensile strength of 19 MPa and an ultimate elongation of 23%, compared to 10 MPa and 11% for a similar blend containing uncoated starch. PEO may act as an adhesive between the starch and the PHBV and/or increase the toughness and resistance to crack growth of PHBV around the starch granules.Paper presented at the Bio/Environmentally Degradable Polymer Society—Third National Meeting, June 6–8, 1994, Boston, Massachusetts.Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

含镍废催化剂的回收利用

介绍了从含镍废催化剂中以硝酸镍形式加收镍的方法，镍回收率为70％，硝酸镍纯度为96．6％。该工艺简单，具有较好的经济效益和环境效益。     

尿中氚水和总氚的对比分析测定研究

用蒸馏液闪法测量尿中氚水浓度 ,用氧化蒸馏液闪法测量尿中总氚 (氚水和有机氚 )浓度。同时测量了 1999年核设施退役时接触氚人员的高于本底水平的尿中氚水和总氚浓度 72个样品。比较氚水和有机氚浓度 ,得到有机氚浓度占氚水浓度的平均值为 (5 4± 3 7) % ,其值与理论值和动物实验值基本相符     

Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

Ethoxylated Soybean Polyols for Polyurethanes

Soybean polyols prepared by ring opening reactions of epoxidized soybean oil with hydrogen active compounds (water, alcohols, organic or inorganic acids, thiols, hydrogen etc.) have a low reactivity in the reaction with isocyanates because the hydroxyl groups are secondary. This paper presents a simple and convenient method to increase the reactivity of soybean polyols with secondary hydroxyl groups by ethoxylation reactions with the preservation of triglyceride ester bonds. The method uses mild reaction conditions: low alkoxylation temperature of 35–45 °C, low pressure of 0.1–0.2 MPa (15–30 p.s.i.) and a superacid as catalyst (HBF₄). The new soybean polyols have a higher reactivity toward isocyanates in polyurethane formation due to the high percentage of primary hydroxyl groups. The primary hydroxyl content was determined by the second order kinetics of polyol reaction with phenyl isocyanate.